Tl* the contact owns a 2002 bmw k1200rs. While driving approximately 5 mph, fuel leaked from the engine compartment without warning. The failure recurred daily. The vin was not included in nhtsa campaign number: 04v028000 (fuel system, gasoline). The manufacturer was not notified of the failure. The approximate failure mileage was 28,000.
Fuel system
BMW K1200RS Fuel System problems by year
9 complaints filed with NHTSA about the BMW K1200RS's fuel system. Fuel pumps, leaks, injectors, fuel smells, gauges and stalling caused by fuel delivery.
Fuel System complaints by model year
| Year | Fuel System complaints | Crashes | Injuries | Recalls |
|---|---|---|---|---|
| 2002 | 9 | 0 | 0 | 0 |
Latest K1200RS fuel system complaints
This is a follow-up to my first report of this date. Bmw apparently conducted a recall (04v-028) for leaks with this coupling, however the recall addressed leaks from the quick disconnect o-ring and the hose clamps. In this case the body of the plastic male end of the coupling initially cracks and then separates allowing fuel under 100 psi to flow down the engine and then towards the rear of the bike. There was one report of a fire and an injury from the previous recall. Here we have a leak occurring from the same...
Read the full complaint
fitting with the same potential. Initially bmw replaced this fitting with the same original part only to find that the fitting failed again. This problem continues to plague bmw riders and needs to be addressed. It appears that the ntsb's initial investigation was suspended when the manufacturer agreed to a recall back in the 2004/5 time frame, thus the particulars of this problem where not forthcoming, and the full nature of the defect not adequately addressed. *Tr
Started my bmw k1200rs and backed it out of the garage. Noticed a spray emanating from the right side of the engine above the valve cove. Shut the bike down and checked for the leak. Found that the plastic fuel line quick disconnect coupling was cracked allowing fuel to spray out in a fine mist. This could have easily caught fire if the bike had been hot. Checked the internet and found that this failure is a common problem on bmw motorcycles and is not limited to my model or year. Bmw has not seen fit to recall the...
Read the full complaint
affected motorcycles even though they are aware of this problem and have redesigned the coupling. The fuel line is pressurized at 100psi so the likelihood of a catastrophic event is high. *Tr
There were no events leading up to the failure. The failure is within a fuel line coupling system. The o-rings within the coupling system, which help to seal the coupling, were eaten away and gasoline sprays out of the coupling. This leaking spray occurs whenever the machine is turned on, or running, as the fuel pump just keeps pumping fuel out of the leak. Consequences could be a fire if the leak happens at speed out on the road, and the operator is unaware that the gasoline is being sprayed all over the right side of the engine. Nothing has been done to correct the failure as of yet-i am researching the problem for a competent fix. *Tr
Male end of fuel quick disconnect broke, spraying fuel. When I called the dealer, they said that this was common, and that mine had a plastic male end, and that a replacement male end was available for twenty something dollars and was being used as original equipment on later model bikes.. For me this ended well. I noticed it as I was about to enter the garage. There are two quick disconnects and I plan on replacing both male ends with the new improved models. Mine also did not break off entirely, but...
Read the full complaint
cracked and sprayed a thin stream of fuel through hole in the body work. There is a potential for disaster however, since both connectors are behind body work. And are likely to fill the belly pan with fuel with an ensuing fire, particularly if the end breaks off entirely. My bike has always been ridden conservatively on paved roads: I don't think that the disconnects were submitted to any unusual stress. I suspect fatigue and aging of the plastic contributed to its failure. I think that from reading the shop manual, that the quick disconnects are a feature added in around the year 2000. Older models did not have them. There is a recall on these bikes for bad o rings in the quick disconnects. I suspect that the plastic disconnects are a bad bit of work, and fairly dangerous, underengineered.. *Tr
2002 Bmw k1200rs motorcycle fuel line quick disconnect coupling failed while in use causing fuel under high pressure to leak out onto hot engine & rider's right leg, risking fire, crash and serious injury or possible death. Owner at own expense and time replaced all four couplings and clamps, two male and two female. Old parts are available. *Tr
Failure of fuel line quick disconnect. This was a recall and the dealer replaced the original that failed with the same kind that failed again. This represents a fire hazard for all owners and corrective action should be taken. *Tr
1;Excessive fuel consumption - gage reading vs. Mileage driven. Heavy gasoline odor when stopped, severe gasoline leak. 2; Mechanical failure of fuel line quick disconnect fitting on fuel return line - - cracked fitting. 3; Carried out roadside repair. Removed faulty fitting and replaced with straight connector and clamps.
When accelerating from a stop into traffic, the vehicle hesitates severely just above an idle. Extremely dangerous when pulling out into traffic. This happens only during hot weather and is obviously a fuel scheduling problem engineered into the vehicle. Many others complain of the same problem with this vehicle. *Ts *nlm *dimsii ivoq entry posted after 12-12-02 cut over to artemis***763168
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data