Motorcycle started stalling while driving and at lights. Throttle was unresponsive and almost caused an accident. Bike would backfire and not idle. At 6250 miles six wires from the ecm harness rubbed the sharp metal shock fluid line and shorted out the coil, tps, o2 sensor and injectors. The bike was undriveable. Dealer resoldered harness. This is the second rub through harness problem. Engine harness was covered with electrical conduit and sharp fluid line was covered with rubber fuel line. *Tr
Electrical system
2006 Buell XB12S Electrical problems
Owners have filed 2 complaints about the 2006 Buell XB12S's electrical system with NHTSA - 67% of all its complaints, most recently on March 4, 2009. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.
- Complaints
- 2
- Recalls
- 0
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Electrical complaints
Removed seat and noticed harness to ecm chaffing on seat. Problem could cause engine not to run. Wire harness felt was rubbed completely through exposing multiple copper wires in harness. Mileage of motorcycle is 4925. Cause is harness vibrates against the sharp edge of underside of seat. Dealer states this is a common problem. Dealer repaired harness and secured harness to a lower position with tie straps. No known solution from buell has been released. *Tr
Buell XB12S electrical complaints by year
XB12S electrical problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data