Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

1998 Buick Lesabre Engine problems

Owners have filed 204 complaints about the 1998 Buick Lesabre's engine & cooling with NHTSA - 50% of all its complaints, most recently on June 15, 2023. They describe 1 crash, 29 fires and 2 injuries. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
204
Recalls
0
Crashes
1
Fires
29
Injuries
2
Deaths
0

Engine complaints

Engine & cooling

Defective manifold gasket. Coolant degrades gasket causing coolant to leak into engine, catalytic converter and exhaust system. *Jb

Filed Incident Engine and engine coolingNHTSA 10149308
Engine & cooling

1998 Buick lesabre engine seized causing consumer to come to an abrupt stop. Upper intake manifold had warped causing anti-freeze to go into the motor per mechanic. *Ts ***no answer required****jb

Filed Incident Engine and engine coolingNHTSA 10149750
Engine & cooling

Dt: the contact stated the antifreeze was low . He took the vehicle to shop the to have it checked. They found the intake manifold was leaking antifreeze into the engine. This, in turn could have caused the engine to blow up. The intake manifold was replaced. *Ak updated 02/06/06. *Jb

Filed Incident Engine and engine coolingNHTSA 10145718
Engine & cooling

Dt: consumer states that vehicle has a plastic intake manifold and after about 80,000 miles it failed, causing engine to lock up. He took vehicle to an independent service department and then called general motors to be reimbursed but because it was not taken to an authorized dealer they will not pay for the work done. Consumer noticed the problem when he tried to start the vehicle and it would not star. Smelled antifreeze. Then, consumer's son examined vehicle and found out it was intake manifold. *Ak

Filed Incident Engine and engine coolingNHTSA 10127255
Engine & cooling

Dt: when started vehicle and there was a backfire with a lot o smoke. Care would not start. Took vehicle to buick garage, and they said it was the intake manifold, and they repaired it. *Ak *sb *nm

Filed Incident Engine and engine coolingNHTSA 10122496
Engine & cooling

My wife drives a 1998 buick lesabre. She has a disability and is pacemaker-dependent. On 5-17-2005 she was enroute on the highway toward our town in the buick when it started running hot. Fortunately, she was able to make it back to our town, where she then pulled over in a wal-mart parking lot. However, she became very stressed over the situation because the temperature guage had gone well into the red but she was afraid to pull over for fear of becoming stranded on the highway. As it turns out, the cause...

Read the full complaint

of this problem is a failed plenum, an issue which occurs frequently with the gm 3800 engine. I submit to you that this problem is well-known to the manufacturer, the nhtsa, and many mechanics and repair shops. The safety problem comes from the fact that (as far as I am aware) there have been no warnings issued to consumers who own a vehicle with the gm 3800 series ii engine. The potential for situations to occur much worse than ours is not only likely, but it is a guaranteed event. My only recourse at this point is to file a complaint with the nhtsa, a complaint which I feel should be classified as a safety issue. These engine failures are not just merely a 'consumer misfortune', but will become the underlying cause for inumerable road hazards for the car's owners as well as other drivers. The problem is due to an engineering design flaw (materials used) and future safety problems (including loss of life) can be avoided. This issue should be addressed by the nhtsa.

Filed Incident Engine and engine coolingNHTSA 10121640
Engine & cooling

Vehicle stalled. Driver pulled over. Driver was unable to restart vehicle, and had it towed to dealer, and mechanic determined that engine needed to be replaced. *Ak the chevrolet dealer told the consumer that water got into the engine block and locked it up. They removed and replaced the(manifold) plenum with all new gaskets, new oil, anti freeze and new spark plugs. *Bf *nm

Filed Incident Engine and engine coolingNHTSA 10113490
Engine & cooling

While driving at approximately 50 mph the plastic manifold burst without warning, causing the engine to lock up. Owner contacted the dealer and the manufacturer, and was told that there was nothing else they could do. *Ak

Filed Incident Engine and engine coolingNHTSA 10113225
Engine & coolingFuel system

Loss of coolant. The plastic intake plenum got a hole in it. This filled the engine with coolant thus causing the car to stall on the highway. I had the defective part replaced at a cost of 900 dollars. I still have the defective part. I'm retired, so this put a strain on our budget. Thank you. *Jb

Filed Incident Engine and engine cooling · Fuel system, otherNHTSA 10110707
Engine & cooling

We drove from home to olathe, ks and back to a kohl's at shawnee station on our way home. We parked the buick and when I tried to start the buick it failed to start. I thought it might be the battery. I waited a few minutes and tried to start the buick. The buick started but white smoke come out of the tailpipe and it began to shake tremendously like we were in a big storm. We had the buick towed to firestone and they said the air manifold rings let the anti-freeze up the motor and the shaking caused oil to leak. We were fortunate that this didn't happen somewhere else. *Jb

Filed Incident Engine and engine coolingNHTSA 10110228
Engine & cooling

The 3.8L gm engines used '95 - '98 for the buick: rivera, lesabre, park avenue, regal, chevy: lumina, monte carlo, oldsmobile: 98,88,intrigue, pontiac: bonneville, grand prix have a known defect. Service bulletin 01-06-01-007a coolant leak. In december 2004, my plastic intake manifold melted and allowed the engine coolant to fill the cylinders of the engine with coolant. Gm resolved the defect with a design change in 99. I feel that gm is responsible for the cost of the repair of the defective part. Second the...

Read the full complaint

engine shut down at 55 mph in heavy traffic, which is a serious safety hazard that warrants a recall. I contacted gm; service record number 1-293342957 they never called me back after a number of messages (7) then denied the claim. *Nm

Filed Incident Engine and engine coolingNHTSA 10107692
Engine & cooling

1998 Buick lesabre. Plenum gasket on the intake manifold fails and allows coolant to get into engine. Then engine dies in the road causing people to slam on breaks. No wrecks. This is a well know problem with lesabre's but buick has failed to correct the problem. I had to pay $1200 to fix car and it now probably has engine damage. I would like buick to come forward with this and let people know about it. This has to stop! *Nm

Filed Incident Engine and engine coolingNHTSA 10106385
Engine & cooling

Recall campaign received concerning fuel pressure regulator. *Bf the vehicle experienced a backfire which resulted in the replacement of the manifold. The problem recurred and the fuel pressure regulator was replaced. *Sc

Filed Incident Engine and engine coolingNHTSA 10109588
Engine & cooling

The check engine light came on in my 1998 buick lesabre and I pulled over to discover that there was low levels of coolant. It had just been checked 2 months earlier at an oil change and the week brfore when I got gas. I added coolant and got back on the road. After 5 miles the car quit running in heavy traffic. I had it towed to a buick dealer who diagnosed the problem as a failed plenum that allowed coolant to foul the plugs. The dealer replaced the plenum, fouled plugs, coolant, and oil for $800.00 Dollars. *Ak

Filed Incident Engine and engine coolingNHTSA 10105763
Engine & cooling

While driving engine light illuminated on the dashboard constantly. Then, engine completely failed. The gaskets had been changed several times. Anti-freeze and oil leaked. Consumer found that it was the intake manifold. *Ak

Filed Incident Engine and engine coolingNHTSA 10106638
Engine & cooling

Faulty design of intake manifold on gm 3.8L engine used in 1998 thru 2004 engine. Plastic housing melts enough after 80,000 to allow engine coolant into the combustion chamber causing engine to hydrolock without warning. Car becomes immediately undrivable. *Jb

Filed Incident Engine and engine coolingNHTSA 10104908
Engine & coolingFuel system

Vehicle returned for inspection with regard to 04v090 12/13/04 complaints poor performance, fuel economy, hard starting, and use of dexcool anti-freeze since recall performed. Decool anti-freeze entering the intake manifold of engine, and engine oiling system from failure or rupture of upper intake plenum near egr passage. Anti-freeze has filled engine lifters causing noise/failure, filling combustion chamber causing hydro-locking of engine, could cause catastrophic failure of engine resulting in possible fire or...

Read the full complaint

accident. Dealer refused to repair under 04v090 manifold over pressure condition stated replacement of upper & lower intake, lifter, plugs, oil, anti-freeze at a cost of $1,150 on vehicle that had 77,827 when the recall was done, and now has 80,407 mi. Which is less then 3,000. This could very well have hydro-locked the engine at freeway speed,or caused catastrophic failure resulting in severe damage, injury, and possible fire from engine oil & fuel hitting the hot catalytic converter!*Ak

Filed Incident Engine and engine cooling · Fuel system, gasolineNHTSA 10104268
Engine & cooling

The vehicle failed to start after re-fueling. The engine cranked but wouldn't turn over. The dealership without inspecting the vehicle identified the intake plenum ( manifold) as the problem. There was a small hole which caused the oil to mix in with the water/ anti freeze. This part has been upgraded in the 2002 and later models. The plenum part #fh10095 manifold was replaced. *Jb....*Ak

Filed Incident Engine and engine coolingNHTSA 10103446
Engine & cooling

While placing the vehicle in reverse a loud popping noise was heard coming from the rear. Then, vehicle stalled. Consumer was unable to restart vehicle, and had the vehicle towed to the dealer for inspection. Mechanic determined that the intake exhaust manifold system, and a head gasket needed to be replaced. *Ak. Also, exhaust manifold cover blew off.*Ak

Filed Incident Engine and engine coolingNHTSA 10101240
Engine & cooling

While driving 65 mph consumer noticed fluid leaking from underneath the vehicle. It was taken to the dealer for inspection, and mechanic determined that the water pump needed to be replaced, and replaced it. However, the problem recurred, and the vehicle was taken back to the dealer. Mechanic determined that the engine needed to be replaced.*Ak

Filed Incident Engine and engine coolingNHTSA 10099689
Engine & cooling

Complaint against general motors corp concerning an unsatisfactory transaction . *Bf while driving the ses light illuminated. A few days later the vehicle stalled while being driven and had to be towed to the dealer. The dealer determined that the coolant passage in the upper intake manifold was leaking into the lower intake. The dealer replaced the upper and lower intake manifolds. Shortly after the repairs were made the consumer received a recall notice. The consumer submitted all paperwork for reimbursement but hasn't received it yet. *Nm

Filed Incident Engine and engine coolingNHTSA 10099682
BrakesEngine & cooling

Consumer noticed that antifreeze was leaking from underneath the vehicle. The brakes pedal went to the floor when applied. Consumer drove vehicle to the dealer for inspection, and mechanic determined that oil pan gasket and front brake pads needed to be replaced. *Ak

Filed Incident Service brakes, hydraulic · Engine and engine coolingNHTSA 10099447
Engine & coolingVisibility & wipers

While driving,in inclement weather windshield wipers come on and off intermittently. The consumer was able to drive the vehicle to the dealer for inspection, and the mechanic determined that the windshield wiper motor needed replacement. This vehicle was not on a recall and the warranty expired. *Ak the plastic intake manifold leaked water without unknowingly and would blow out and ingest all of the water from the radiator and also the overflow into the motor. *Sc

Filed Incident Engine and engine cooling · VisibilityNHTSA 10095463
Engine & cooling

On january 2004 an independent repair shop replaced the intake manifold at consumer's expense of $1, 1000, five months later, the consumer received nhtsa recall #04v090000 which stated that vehicles equipped with 3800 v6 (l36) engines and certain delphi fuel pressure regulators, the regulators have a much higher than usual rate of fuel leaks. A leak can allow fuel to enter the intake manifold through a vacuum line. The manufacturer indicated to the consumer the recall was the fuel pressure no the intake...

Read the full complaint

manifold. However, the mechanic determined that a defective fuel pressure broke the intake manifold. *Ak the was attempting to stall while in motion, when the vehicle reached home the vehicle died. The engine turned but did not start. The intake was leaking coolant into cylinders. *Sc

Filed Incident Engine and engine coolingNHTSA 10091657
Engine & cooling

July 11, 2002: we had to have 5 injectors replaced by jordan oldsmobile-buick, hot springs, arkansas. Cost: $709.42. Mileage was 82,260. October 31, 2002: we had to take our car to orr pontiac, cadillac, toyota, hot springs, arkansas, because the car misfired (or backfired) on us. The work order states: customer states that oil light and temp light came on; car was low on coolant and had to add water, said a lot of white smoke came out of tail pipes and had very bad sulfur smell. Intake leaking,...

Read the full complaint

flooding cyl with coolant. Replaced : two manifolds, coolant, oil, etc. Cost: $1398.66. Mileage: 88,103. November 15, 2002: oil gauge goes to red and engine has knock. Diagnosis was internal engine damagei was told that parts of the engine had been made of plastic and this plastic had melted. Complete new engine. Cost: $4174.94. Mileage: 88,821.

Filed Incident Engine and engine coolingNHTSA 10096150

Buick Lesabre engine complaints by year

Lesabre engine problems, every year

Had a engine problem with your 1998 Lesabre? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience