1998 Buick lesabre- check engine light went on, stopped at gas station,car would not start after stopping, intake manifold had failed, causing engine coolant to get iinto the engine, because the engine was locked up the starter also broke when trying to restart the car, was stranded 60 miles from home, to get towed and get car fixed cost over 2000.00 Dollars. It seems the intake manifold has a defect. *Ak
Engine & cooling
1998 Buick Lesabre Engine problems
Owners have filed 204 complaints about the 1998 Buick Lesabre's engine & cooling with NHTSA - 50% of all its complaints, most recently on June 15, 2023. They describe 1 crash, 29 fires and 2 injuries. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
- Complaints
- 204
- Recalls
- 0
- Crashes
- 1
- Fires
- 29
- Injuries
- 2
- Deaths
- 0
Engine complaints
The vehicle upper intake manifold failed prior to recall notification. The consumer request reimbursement. *Nm the vehicle died while the consumer backed out of the driveway, restarted and backfired along with engine light illumination, and later the vehicle was started, but had ran rough. Since 10/08/02, the vehicle had run fine. *Sc
The vehicle's plastic intake manifold cracked which resulted in water getting inside the crankcase. *Nm the consumer requested reimbursement because she found out that the part had been recall two years ago. *Nm
While attempting to start the vehicle the consumer heard a load pop then smoke began to fill the cabin of the vehicle. Shortly after the vehicle caught on fire. *Nm the consumer requested reimbursement. The problem was due to a leaking manifold. *Sc
A recall letter was received. Vehicle was taken to the dealer. Problem was the check engine light. After picking the vehicle up mechanic stated that there would be a $79.00 Charge , and the check engine light remained on. *Ak *nm
The engine light was on, the vehicle was repaired. A recall letter was received. After sending the receipts to the manufacture, they are not refunding the entire amount. The intake manifold.
Vehicle's engine misfires and loses power. *Mr the service engine light had come on along with the misfires and power loss. The consumer was told that the problem could be due to the engine hydraulic lock. The consumer stated that gm was aware of the plastic intake manifold problem. *Sc
Engine backfiring on 1998 buick lesabre. *Mr recall# 04v090000. The heater failed and the consumer was informed that a water pump was needed. The engine also died with less than 100k miles. The consumer requested reimbursement. *Sc *jb
Consumer was concerned about reimbursement from the manufacturer. Consumer received recall notice 96v116000 concerning intake manifold failure. Consumer had recall repairs done. However, recall repairs failed. Consumer informed the mechanic that this problem occurred more than once, and had not been resolved. *Ak
While driving vehicle stalled. Consumer pulled over, and had the vehicle towed. Dealership was notified, but did not resolve the problem. *Ak
Problems with fuel pressure regulator on 1998 buick lesabre.*Mr the fuel pressure regulator was replaced in accordance with recall v1082. While driving the vehicle stalled and would not restart. The vehicle was towed to the service dealer where it was deterrmined that the upper intake manifold had failed and coolant was flowing into the cylinders. The consumer feels the manifold should have been recalled and request reimbursement. *Nm
The intake manifold and the exhaust system were a manufacturer's design flaw. When the consumer contacted the manufacturer, the consumer was told that the tubing was too small, causing the tubing to rupture. *Ak the intake manifold was worn through. *Sc *jb
While driving service engine light came on. Then, vehicle decelerated followed by heat and ventilation failures. This was due to engine intake manifold malfunctioning. The manifold wasn't designed correctly by the factory engineer, which caused the engine to misfire. Dealership diagnostic test showed coolant leaking. Cylinder replaced, and lower intake manifold improved design, per bulletin 010601007a. Also, coolant and fluid plugs were replaced.*Ak *nm
While driving engine light illuminated. Vehicle began running very hard and rough. Finally, engine shut down and would not start again. Consumer states due recall 04v090000 vehicle acts in this manner. *Ak
While driving vehicle started to lose power. *Mr the vehicle gradually lost more power and quit. The consumer was informed that the upper intake manifold was cracked in one of the passages, which required a total replacement of the engine. *Sc
Problems with antifreeze leaking into the vehicle's engine.*Mr the consumer was told that he would be responsible for purchase the small copper piece that would not allow the plastic to become overheated. The consumer would like to know if a recall has been issued for this problem. (1998 Buick). *Nm
It would be hard to start the vehicle. Once the vehicle was started the engine warning light illuminated. The dealership was notified, but did not resolve the problem. *Ak
My 1998 buick lesabre had a ruptured manifold in june 2003, causing engine to cease and smoke and minor fire. The smoke made myself and my infant son very ill. This was reported to buick but they refused to reimburse for repair since vehicle was just out of warranty. They told me that the following recall was not in effect: nhtsa recall no. 03V473/gm recall no. 03054 And that my vehicle had no recall. A few months later the engine ceased to start again and it was determined at the buick dealership that it was...
Read the full complaint
a faulty fuel pressue regulator which was replaced. Buick again refused reimbursement although I brought their attention to the current recall on my vehicle. I called again today as the recall for 98 buick lesabres with v6 engines was again posted but buick told me that their system has no such recall and they refused to reimburse me for over $1000 of repairs for the faulty fuel pressue regulator and manifold. Nhtsa recall no. 04V090/gm recall no. 03054B.*Ak *la
While driving on my way to work the vehicle started to slow and the engine light came on. I pulled over and attempted to start the car and the engine would not turn over. I called my auto club for a tow and the car was towed to a connoco station in park rapids. They immediatly knew what the problem was, stating they see a lot of the 3800 engines do this. The intake plenum rotted away allowing coolant to fill a cylinder and stall the engine. Gm has issued a service bullitin for the problem, but no recall. This could be a major safety concern with loss of power to the engine the steering and brakes will not function as they should. *Ak
Our 1998 buick lesabre limited, april 2004 our upper & lower intake manifold's & gasket were replaced due to a leak and the car only had 62,000 miles on it. This cost us over 2000.00 The web has hundreds of similar complaints from other gm owners. *Ak upper intake manifold leaked, causing loss of coolant. Vehicle taken to independent repair shop. Oil and oil filter had to be changed, spark plugs were replaced and cylinder's [engine flushed] had to be cleaned out. Also broken starter replaced. My car had to be...
Read the full complaint
towed over 110 miles back home at a cost of $ 236.50 [My wife was visiting her mom and had 2 grandchildren with her when car broke down in a remote area ,lucky for us she had her cell phone with her and some nice folks at a near by ranch took care of them] my mechanic advised intake manifold leaked, and starter was bad [housing broke] starter housing broke due to trying to start hydro-locked engine. Question: why is buick allowed to use a plastic intake manifold? As this is an area that gets very hot. It's obvious, buick made a big mistake by producing engines with plastic man- ifolds. The intake manifold on the engine is made out of plastic and has the egr tube running through it, causing the plastic to heat up and allow antifreeze to run into the engine. When my mechanic called the local dealership to order parts, the sales clerk told him, "yes we have those parts on hand it happens a lot" also that the upper & lower intakes had been re-designed and that both manifolds need to be replaced as a unit. .(Contributed by mike & della rico) ps. Also, transmission is now acting up [shudders on take-off at times] I understand that these problems [manifold & transmission] are mainly going on with cars having k in the vin. Do you have any information on this? Thank you
Vehicle failed to start when the key was turned in the ignition. Vehicle was towed to a mechanic. Mechanic indicated that the intake manifold degraded around the erg distribution nipple and the fuel pressure regulator diaphram ruptured leaking fuel into the engine through the vacuum hose. This was the same defect as described in the fuel pressure regulator recall 03v473000, but this vehicle's model was not included in the recall although it had the same type of engine. *Ak *nm
While pulling out from a stop light the vehicle began to accelerate and suddenly the engine locked and stalled. The vehicle was towed to the consumer's house and it was found that the upper intake manifold was corroded. This problem caused water and anti-freeze to enter the engine, which caused the vehicle to over heat. Please provide any additional information. *Nm
The plastic intake manifold melted inside the engine. *Jb the vehicle was missing and was smoking. New manifold and plug wires were added. *Sc
This is a engine problem with what I believe was a bad part design. The part is failure of intake plenum. The egr pipe from the engine comes through the plastic intake. There is a lot of heat generated at this point. Over a period of time a hole is burned through the intake. This floods the engine with coolant. I bought the vehicle new. The first time the problem occured at 59,000 miles. I had the vehicle repaired at a cost of $1100.00. I asked the dealer about this. The reponse was . Yes we know there is...
Read the full complaint
a problem with the k engine but the factory has not called for a recall. At 113,577 miles the problem occured again. I again had the engine repaired at a cost of $1140.93. Again I asked the dealer about this. I was told that a service bulletin was sent out in 1996. This stated that if a owner complained of a coolent leak around the intake. Not only should the plastic intake plenum be replace but also the aluminum intake should be repalced becaused the factory had replaced the egr pipe with a smaller pipe. This would keep the heat from burning a hole in the plastic plenum. The cost of this repair is to be paid by the owner. I checked out the service bulletin and found the problem covered all gm 3800 series engines form 1995 - 1998 my engine vin # is 1g4hr52k3wh51080. I was told by the gm service tech. That this problem occured so often that any owner of a 3800 series engine and the new design intake has not been installed you are guaranteed the engine will fail. Again I feel this was a design problem.
When attempting to start the vehicle engine produced a loud bang, then caught on fire. No injuries were reported. *Ak
Buick Lesabre engine complaints by year
Lesabre engine problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data