Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Electrical system

Can-AM Spyder RT Electrical problems by year

26 complaints filed with NHTSA about the Can-AM Spyder RT's electrical system. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.

Electrical complaints by model year

YearElectrical complaintsCrashesInjuriesRecalls
20260001
20250001
20241001
20231000
20211000
20191000
20162000
20143000
20137000
20127000
20113000

Electrical recalls

Latest Spyder RT electrical complaints

2024 Can-AM Spyder RTElectrical system

The contact owns a 2024 Can-Am Spyder RT. The contact stated that while driving 70 MPH, the transmission unexpectedly downshifted to fourth gear and quickly decelerated to 45 MPH. The contact stated that the vehicle was uncontrollable. Several unknown warning lights were illuminated. The contact regained control of the vehicle and the transmission shifted into sixth gear. The vehicle was driven to a safe location, and the vehicle was parked and was restarted. The contact stated that upon driving at an undisclosed...

Read the full complaint

speed, the failure reoccurred. The contact stated that there was an abnormally loud clunking sound coming from the vehicle. The warning lights then turned off. The contact stated that the failure had occurred immediately after the vehicle was repaired under NHTSA Campaign Number: 26V575000 (Electrical System). The contact stated that the recall repair was completed over the air. The manufacturer was contacted, and a case was filed. The failure mileage was approximately 17,070.

Filed Incident Electrical systemNHTSA 11774282
2023 Can-AM Spyder RTElectrical system

BRP redesigned the alternator drive shaft starting with the 2023 model year. The alternator drive has a friction drive device built into the shaft. The shaft is making a squealing noise under normal operation. This friction unit is designed to only slip when a heavy load is applied to the alternator, ie when turning at idle. The problem is that when it slips the alternator cuts out and steering get difficult with out electric assistance. I also fear that this will prematurely wear the friction material off the...

Read the full complaint

shaft which will result in metal to metal shavings being released into the engine. Initially I was told it was The wrong oil being used, The bike has been serviced exclusively at my canal dealer using only canal parts.

Filed Incident Electrical systemNHTSA 11680284
2016 Can-AM Spyder RTElectrical system

The contact owns a 2016 Can Am Spyder RT. The contact stated while attempting to start the vehicle, the ignition failed to function as intended. The message DESS (Dynamically Enhanced Security System) was displayed. The vehicle was then towed to the dealer, where it was diagnosed and determined that the programmed key chip had failed and needed to be replaced. The repair was pending. The manufacturer was notified of the failure but denied assistance in covering the cost for the repair. The failure mileage was 6,000.

Filed Incident Electrical systemNHTSA 11665734
2021 Can-AM Spyder RTElectrical systemLights

One of the electrical fuse boxes on the vehicle (right side as viewed from front of vehicle) had water infiltration causing fuses to corrode; leading to an electrical failure at dark, where the vehicle had no headlight, tail light, brake light, turn signals or emergency flashers. Due to this failure I was almost rear ended when stopping for a traffic light. Also the cooling fans would not come on and the vehicle will overheat due to this issue. When I opened the fuse box trying to diagnose the problem it had more...

Read the full complaint

than a tablespoon of water which was green in color due to the corrosion created by the water infiltration. I was able to replace one of the fuses long enough to safely get the vehicle to my home and to the dealership for investigation. I had the dealership open a claim with BRP (the manufacturer) who has concluded this is not covered under warranty. This vehicle was purchased 1 year ago and has been garage kept since date of purchase, washed twice and driven in the rain one time. This vehicle has 2,020 miles and remains stock with no modifications. Having no lighting is a safety hazard with potential for great harm, this issue needs to be addressed by the manufacturer. It appears that BRP wants to make me pay for repairs when their manufacturing process is that cause and this is not acceptable.

Filed Incident Electrical system · Exterior lightingNHTSA 11488996
2019 Can-AM Spyder RTElectrical systemBrakes

The electronic parking brake malfunctions and failed to either engage or disengage. Failure to engage prevents the vehicle from rolling after starting and in gear. Failure to engage allows the vehicle to roll after stopping, turning the engine off, and releasing the manual foot brake. In order to stabilize the vehicle from moving if the ebrake will not engage, the rider must release the manual foot brake, while attempting to prevent the vehicle from rolling, and place a chock under tire(s). In order to prevent the...

Read the full complaint

rider from being stranded if the ebrake fails to disengage, the rider must stabilize the vehicle first, manually remove the rear brake spring, and loosen the brake cable nuts to release brake cable tension. This requires a spring tool and two 12mm wrenches. While this will allow the rider to not be stranded, it creates a hazard when the rider arrives at their destination and must park the vehicle.

Filed Incident Electrical system · Service brakesNHTSA 11338776
2014 Can-AM Spyder RTElectrical system

Tl* the contact owns a 2014 can-am spyder rt. While driving approximately 15 mph, the motorcycle shut off. The contact coasted to the side of the road and had the vehicle towed to malcolm smith motorsports (7599 indiana ave, riverside, ca 92504). The dealer determined that the limp home mode failed. The contact also stated that this was the second occurrance. The motorcycle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 21,000.

Filed Incident Electrical systemNHTSA 11278833
2012 Can-AM Spyder RTElectrical systemDriver assistanceBrakes

On 7/11/2019 my 2012 canam rt se5 started throwing out vss fault code, I took it home and contacted my local canam service company. They asked me to bring it in which I did the next day. Enroute to the shop it began showing abs limp home mode but was not in limp home mode. Once connected to the shop computer I was advised the bike was throwing out numerous codes and false codes. Then I wasxadvised this bike has had numerous electrical problems since 2013 ip to and including replacing the entire instrument cluster...

Read the full complaint

at 15000+ miles. Since purchasing thw bike it constantly shorts the horn out and I have to replace the fuse. In addition to the vss/abs codes the shock compressor had started coming on and off.

Filed Incident Electrical system · Electronic stability control (ESC) · Service brakesNHTSA 11232054
2012 Can-AM Spyder RTElectrical systemDriver assistanceFuel systemFire

My wife and I were riding to hawks nest state park in west virginia, my can-am spider caught on fire around the fuel cap area we were coming to a stop going about 10 miles an hour to 0. I felt heat on my left leg looked down and saw flames and told my wife to get off the bike and we got off and the bike, it burned for a few minutes before someone put the fire out with an extinguisher. We had fueled up about 35 miles prior to this stop. There are recalls on this motorcycle but not my specific vin #- why? I see this...

Read the full complaint

is the exact same problem with other 2008 to 2012 can-am spyders with vapor leak or fuel line leak recalls. I have only owned this can-am for three months I am grateful we are not hurt but this could've been really really bad these are known for catching fire as I am learning and reading I am fortunate yes- please stop these bikes from being sold!! The road was hilly 2 lane country road. Sunshine 85 degrees. Ruined our day and bike!

Filed Incident Electrical system · Electronic stability control (ESC) · Fuel / propulsion systemNHTSA 11231750
2013 Can-AM Spyder RTElectrical systemBrakesFuel system

Excess heat has melted the brake line twice, master cyl. Melted, braks get soft and inhibit stopping power, electrical wiringis degrading from excess heat, gas tanl get so hot the gas starts to boil, panels are melting and warping from excess heat. The unit has been declared un safe to ride. Brp refuses to address the safety issues, all recalls and upgrades have been done and the problem is just getting worst, brp, will not fix only offers to hide the cometic damage

Filed Incident Electrical system · Service brakes · Fuel / propulsion systemNHTSA 11114334
2011 Can-AM Spyder RTElectrical systemEngine & coolingFire

Tl* the contact owns a 2011 can-am roadster spyder rt motorcycle. While driving 35 mph, the engine failed and flames appeared under the motorcycle near the engine area. The contact was able to move safely onto the road shoulder. The fire department assisted to contain the fire and a fire report was filed. The motorcycle was taken to a tow yard. The motorcycle was not repaired. The dealer and manufacturer were not notified. The approximate failure mileage was 2,935.

Filed Incident Electrical system · EngineNHTSA 11040912
2016 Can-AM Spyder RTTransmission & drivetrainElectrical system

An electrical failure caused the transmission to lock in gear which in turn caused the engine to stall. The vehicle could not be moved from the road creating a safety issue to both myself and other motorists. The vehicle stalled on a two lane highway with minimal shoulder and in the middle of a blind 45 mph corner. If the vehicle had a neutral release switch, the vehicle could have been moved onto the shoulder removing the obstacle from the path of oncoming motorists. Since the vehicle could not be moved, I...

Read the full complaint

had to stand in the road to warn motorists to stop. The cause of the electrical failure is yet to be determined but is less important than the inability to move the vehicle out of the path of other motorists.

Filed Incident Power train · Electrical systemNHTSA 10986164
2014 Can-AM Spyder RTTransmission & drivetrainElectrical systemBrakes

The bike went into limp mode the first time 8 months after purchase and has been in the shop 5 times in one year. Complaints of not shifting correctly and electrical problems along with air shocks leaking and an oil leak ect. I was riding on back country road when I couldn't down sift the bike before going into a corner. Had to power stir the bike around the corner and almost lost control.

Filed Incident Power train · Electrical system · Service brakesNHTSA 10960205
2014 Can-AM Spyder RTElectrical systemFire

I purchased the bike in april 2015 and I ride on country roads. In october we took the bike up to get a pumpkin and had to sit in traffic. The bike overheated so we pulled off and let it cool down. On the way back home the instrument panel we flashing different thing so I pulled over and called can-am for a tow truck so it could be taken to the dealership. The dealership had the bike for around 2 weeks and finally called me and told me it was fixed. I picked up the bike and it overheated not even a 1/4 mile from...

Read the full complaint

the shop so I took it back. They found out the manufacturer did not install the fuses for the cooling fans.When I got the bike back from the dealer the second time I parked it and when I had a chance to ride it on november 28th 2015, ii was on county roads in north georgia and it over heated again. I called the dealership to let them know I was on my way back to the dealer when the instrument panel started flashing a lot of different things. I pulled off the side of the road and it looked like smoke behind the instrument panel and that is when I saw flames. The fire department put it out and I had it taken to the dealership. The bike is a total loss. Can-am sent an engineer to look at the bike on january 19th 2016. What I was told by my insurance company the engineer said "it looks like the fire started at the radiator but there was too much debris to confirm. My insurance company state farm called me last night and told me can am was not going to do anything.

Filed Incident Electrical systemNHTSA 10824167
2011 Can-AM Spyder RTElectrical systemBrakesFuel systemFire

Tl* the contact owns a 2011 can-am spyder rt. While the vehicle was parked, the contact noticed strong fuel fumes around the vehicle. In addition, the contact stated that the vehicle failed to start. The abs and the ebd default were displayed across the message board. The vehicle was taken to a dealer but was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 3,200. The vin was unavailable.

Filed Incident Electrical system · Service brakes · Fuel / propulsion systemNHTSA 10735184

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience