Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. One or both front brake rotor/hubs were built with an out-of-specification gray iron that can fail during the life of the vehicle.
Brakes
Chevrolet C30 Brake problems by year
17 complaints filed with NHTSA about the Chevrolet C30's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
The brake pedal push rod retainer is missing, mispositioned or not properly seated.
Loose pivot bolt holding the brake pedal to its support bracket could disengage from the nut.
Fatigue cracks may develop in the brake vacuum booster housing. This may cause a vacuum leak and reduce the effectiveness of the brakes. After prolonged use, the cracks may develop to the extent that the booster may separate from the vehicle.
The front hoses on the involved vehicles may have improperly oriented hose fittings, resulting in a rubbing contact between the right brake hose and the upper control arm of the front suspension or in a twisted left hose resulting in a faulty attachment at...
On the involved vehicles, the nuts which attach the brake master cylinder to the hydro-boost unit may have been over-tightened. This could have caused stripped threads and cracked attaching flanges. Should these nuts fail, the parts may separate and loss of...
Latest C30 brake complaints
While applying brakes vehicle does not respond to a complete stop, vehicle skids forward.*Ak when approaching a traffic stop on a rough road surface brakes will apply for a frction of a second then release, vehicle will then coast woth no brakes and coast through traffic. *Mj
While traveling about 15-20mph and after the brakes are depressed there is an initial response, but vehicle continues to go forward. No accidents or injuries have occurred. *Ak
I have a recall letter from gm canada concerning antilock brakes. When I took the van to be fixed, the dealer would not do it because the van was converted to an rv by roadtrek and it would require 16 hours labor to repair the brakes. Neither gm or roadtrek would cover the cost. How can I get this resolved.
When applying the brakes during normal braking condtions/smooth road surface, and no inclement weather, it seemed as though the left front wheel locked up and the truck did not stop in a safe distance. Problem was worse on wet roads. Dealer stated that nothing was wrong with the brakes. In october of1999, this problem caused a rear end crash. Please provide any further information. The truck is a company owned vehicle. *Ak
No summary listed for above vehicle. *Ak( dot number: )
When applying the brakes the vehicle vibrates and pulls to the left. About every 3 months, the brake assembly has to have something replaced such as pads, rotors, etc. Dlr has seen vehicle over 11 times and problem still exists. *Ak
An inherent invasion of of proper response from braking system. This occurs during fall/winter seasons; also, when moisturization comes in contact with road surfaces. Consumer assistance center affirms system functioning correctly. *Ak
When brakes are applied they resist. When vehicle goes over a bump the brake releases and keeps going. The dealer has not been able to duplicate the problem. *Ak
Vehicle used for police use. Consumer stated when traveling at 30 mph the rear brakes grab and also lock up, causing the vehicle to freeze. Consumer also stated when the problem occurs the occupants inside the vehicle being forced into the windshield. Consumer has contacted the dealer. *Ak
When driving along, came to a stop light, started braking and suddenly there was a complete loss of brakes. Road conditions wet, but not slippery. Took vehicle in for repairs to two different dealers and they could not find anything wrong with the brakes. Brake failure caused vehicle to run into the back of a another vehicle. *Ak
The abs braking system malfunctioned when applying the brakes hard and quickly. Had an accident, applied the brakes quickly and they malfunctioned, causing the vehicle to roll 30 feet and run into another vehicle. Dealer said that was how the brakes worked. *Ak
When making a stop (driving slowly) the brakes work correctly, but when making a sudden stop the vehicle speeds up and not down. Please explain. *Ak
When brake primary pump is out, the brake pedal goes to the floor and there are no brakes . Please describe .*Ak
Abs, brake failure, replacement of differential valve, when brakes are applied locks up in front and extended stopping in rear. *Ak
The brake pedal is hard when applied. A delay is experienced.*Ak
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data