General Motors LLC (GM) is recalling certain 2020 Chevrolet Corvette and Cadillac CT4, CT5 and XT4, 2021 Chevrolet Trailblazer, and 2020-2021 Buick Encore GX vehicles. Sensor connection contamination in the electronic brake boost system may cause an...
Brakes
Chevrolet Corvette Brake problems by year
15 complaints filed with NHTSA about the Chevrolet Corvette's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
General Motors LLC (GM) is recalling certain model year 2015 Chevrolet Corvette vehicles manufactured August 20, 2014, to September 4, 2014. In the affected vehicles, only one of the rear parking brake cables may be fully seated and engaged, resulting in the...
Certain passenger vehicles were produced with one or both rear brake hydraulic lines that can come in contact with or be affected by heat from the left engine exhaust manifold and the left exhaust pipe. The brake fluid could reach elevated temperatures and...
Remanufacturerd rear brake calipers, part nos. 18-7019, 18-7020, 16-7019, And 16-7020, manufactured from february 1, 2002, to april, 25, 2003., And for use on 1965 thru 1982 chevrolet corvettes. The subject brake calipers were manufactured using improperly...
Severe and unusual braking conditions may cause damage to the brake master cylinder center valve. Consequence of defect: if sufficient...
Attaching bolts were mistakenly coated with a slippery material during production. This material will act as a lubricant and bolts may loosen and eventually fall off.
Latest Corvette brake complaints
I am reporting a safety issue involving the Active Handling/Stability Control system on my 2012 Chevrolet Corvette. After a routine oil change at Grossman Chevrolet in [[redacted]] on [redacted], the "Service Active Handling System" warning appeared. I called the dealership and was told to cycle the ignition several times to reset it, but the warning stayed on. In early [redacted], I returned for diagnosis. The dealership determined the steering angle sensor (GM Part 25858802) had failed and needed replacement. I...
Read the full complaint
was told the part would be ordered and should arrive in about a week. After weeks with no update, I contacted the dealership. On [redacted] the customer service representative informed me the part was no longer available from GM. He stated the only option was to disconnect the sensor, which would leave the Active Handling/Stability Control system nonfunctional. I requested the part number and began searching for availability myself. Over the next two weeks, I conducted daily searches across GM parts suppliers, aggregators, and Corvette specialty sources. No new or NOS units were available anywhere. GM has discontinued the part without providing a replacement or superseding part number. This means the federally required stability control system cannot be repaired and the vehicle cannot be returned to safe operating condition. GM has provided no remedy or guidance, leaving owners unable to fix a critical safety component. I request NHTSA investigate GM's discontinuation of this essential part and determine whether a recall or mandated remedy is necessary. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Fuel line connection on top of fuel pump cracked. Very common issue with this car as many other experiemcing the same issue.
Driving and service active control system can on feel like brakes locked up, very scary.
service active handling/service traction control
car only has 31,000 miles on it and it's leaking gas from the top of the gas tank. will need fuel pump replaced. not a safe thing to have cheap parks, spilling gas over the exhaust pipes. MAJOR SAFETY ISSUE TO ME! anti lock brake system is also giving issues for a couple years now, noted by previous owner. This car only has 31,000 miles!
Tl* the contact owns a 2011 chevrolet corvette. The contact stated that while driving approximately 10 mph and making a slight left turn, the brakes erroneously applied causing the vehicle to abruptly stop. During the failure, the message service active handling system was displayed. The vehicle was taken to the local dealer jim trenary chevrolet (501 auto mall dr, o'fallon, mo 63368) and diagnosed that the steering column was faulty and needed to be replaced. The steering column was replaced however, the failure persisted. The manufacturer was not notified of the failure. The failure mileage was 15,000.
The front right brake hose that connects the brake 'hard lines' to the caliper failed. The rubber portion separated from the fitting on the caliper causing complete brake failure. Brake pedal went to the floor and all brake fluid dumped out onto the ground and inside of the wheel. The vehicle was traveling at high speed under hard brake pressure. Miraculously, I was able to swerve around obstacles and avoid serious collision. I'm lucky to be alive to write this complaint. Upon removing the wheel, the brake hose was hanging free of the caliper draining what was left of the contents of the brake system on the ground.
While driving over 30 mph the car will brake and the digital information center will show "active handling system" and vehicle is not driveable and is a safety risk
Tl* the contact owns a 2016 chevrolet corvette. While driving 50 mph, the clutch failed without warning and traveled to the floorboard. The pedal failed to rise back in position. The vehicle was taken to norfolk gm auto center (1123 s 20th st, norfolk, ne 68701) where it was diagnosed that the master cylinder needed to be replaced. The vehicle was repaired. The manufacturer was notified of the issue and opened case number: 8-3631978340. No further assistance was provided. The failure mileage was 9,000.
The car only has 2388 miles. Backing straight out the drive way the dash starting displaying service antilock breaks, service traction system, service active handling system. The dash lights from abs and traction stay on and the traction control control button is disabled.
Investigation number ea09-002 going into a slow left sharp turn the vehicle cut off fuel, triggered service abs, service active handling, service traction control. During this time I could not accelerate. Abs braking is now disabled and will not reset with ignition cycles.
Upon braking to enter a tight left hand turn in the country the dic displayed several warning indicators, abs and traction control. The right front brake locked up (confirmed by the flat spot on the tire). I began modulating the brakes thinking that I had lost anti-lock brakes, but the right front brake had locked up. This reduced the braking ability of the car causing me to go off the outside of a left hand turn and into a ditch damaging some components of the front end. I was able to return home safely. The car...
Read the full complaint
was parked until a mechanic looked at it. A dialectic grease was applied to the connectors between the system and the wheels at all 4 corners. This seemed to resolve the issue as experienced on that day. Now, 5 months later all the dash lights involved in the active handling system have come on again. Service abs, service traction control and service active handling all came on at the same time. The car will now need to return to the shop for some more diagnosing and repairs. This is a major safety issue. Having no active handling, traction control or anti-lock brakes does not make a daily drive unsafe. Not until applying brakes and you find the system locking up one wheel causing a loss of control. In an emergency situation it would be unsafe as well of course. We've come so far in improving the safety of our cars it's a shame that the same technology that improves the safety of our cars can also cause a vehicle to become unsafe.
While participating at track day, sponsored by porsche club of america at thunder hill in northern california, my instructor, while driving, experienced brake fading. When we returned to paddock, we checked the brake fluid. It had boiled out through the cap. We also experienced an automatic transmission over heating warning light. When I returned to idaho, I took the car to chevrolet of twin falls. Invoice # 532956. They checked the transmission; brakes and replaced the brake fluid. Then sent me on my way. This car is sold as an performance car. Fading brakes, could easily cause sever injury or death. *Tr
As I left the grocery store I started to head home when the 11 corvette gs sent a message to the dic on the instrument cluster, it said to service active handling, the problem is it locks up the front brakes, while this may not sound too serious at low speeds, imagine pulling out into traffic and the brakes lock up on your car. It occurs pulling onto grass or loose gravel also, especially in turns. I have to turn the car off and restart it for it to move again. My wife started reading the hundreds of complaints on...
Read the full complaint
service the active handling on the corvette forums and what it has done to the vehicles from people that had issues with there vehicles when the service active handling message appeared on there (dic) digital information center that she no longer rides in the car with me. This vehicle has seen more dealer service than any other vehicle that I have owned. *Tr
On my 1975 chevrolet corvette while driving on the jackie robinson parkway in new york city while attempting to stop the brake pedal dropped to the floor. The clevis pin and clip retainer fell off the brake pedal without prior warning almost causing a vehicle crash. Purchased new parts for installation with fear that it might happen again. *Tr
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data