Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Acceleration & cruise control

2004 Chrysler Crossfire Acceleration problems

Owners have filed 2 complaints about the 2004 Chrysler Crossfire's acceleration & cruise control with NHTSA - 2% of all its complaints, most recently on May 19, 2014. Unintended acceleration, surging, throttle problems and cruise or adaptive cruise faults.

Complaints
2
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Acceleration complaints

Electrical systemAcceleration & cruise controlBrakes

This is a common problem on 1000's of crossfire's and mercedes (all models from 1998 forward). This issue is the bas system and brakes. Intermittingly, and usually during warmer weather when applying the brakes the bas light comes on, as does the light indicator. The issue is that the brake lights do not come on. There is a fault where if the bas is not working, the brake lights do not come on. They are tied together in the electronics. The bas is not required to stop the vehicle, however no brake lights...

Read the full complaint

because of the fault is extremely unsafe. The vehicle cannot be driven. Research online has found 1000's of complaints, no resolution and typically hundreds or thousands in repair costs that do not fix the issue. The brake lights should run independently of the bas system. A common fix is connecting an inline fuse from the brake switch to the brake light, if one is mechanically inclined to do so. Contacting mb states they know the issue but cannot determine the cause they also stated too costly to change the system for a % of owners. Other car manufacturers have brake lights wired separately from bas systems. *Js

Filed Incident Electrical system · Vehicle speed control · Service brakesNHTSA 10592419
Acceleration & cruise control

Tl*the contact owns a 2004 chrysler crossfire. While driving between 5-60 mph, the vehicle would not accelerate when the accelerator pedal was depressed. The vehicle would not accelerate without warning. The contact pulled over and was restarted. The failure stopped after the vehicle was restarted. The failure occurred intermittently. The dealer was unable to duplicate or repair the failure. The failure mileage was 32,000 and current mileage was 34,150. Updated 03-04-08 *bf the consumer was told the problem was the accelerator pedal sensor. Once it was replaced, the problem stopped.

Filed Incident Vehicle speed controlNHTSA 10215874

Chrysler Crossfire acceleration complaints by year

Crossfire acceleration problems, every year

Had a acceleration problem with your 2004 Crossfire? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience