Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Steering

1994 Chrysler LHS Steering problems

Owners have filed 29 complaints about the 1994 Chrysler LHS's steering with NHTSA - 9% of all its complaints, most recently on January 2, 2006. Loss of power steering, stiff or loose steering, wandering, column and rack problems.

Complaints
29
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Steering complaints

SteeringTransmission & drivetrainElectrical system

In july 2004, I purchased a used '94 chrysler lhs w/95,000 miles in very good condition (exterior/interior) but within the first few weeks I experienced electrical problems (electric current not going to gauges, gauges going haywire), transmission problems (periodic 'limp mode', car erratically surging) and steering problems (rack 7 pinion, inner/outer tie rods). Within a few months I replaced the inner/outer tie rods and front/rear stabilizer links that all improved my front suspension. Just recently about a...

Read the full complaint

month ago, I had my local dodge dealer replace one broken transmission mount ($305) then the following week at 124,500 miles while driving to work on my local highway my transmission failed, which resulted in loss of power steering and loss of drive gears, I was able to exit safely onto my jobs parking lot before it finally gave out. I had it towed to an exclusive auto transmission shop, they had to rebuild/overhaul the transmission and torque converter ($1,800). A whopping $2,100 in repairs in about a month. There went my christmas money. *Jb

Filed Incident Steering · Power train · Electrical systemNHTSA 10146729
Steering

Dt: contact owns a 1994 chrysler lhs. While the contact's daughter was driving vehicle skidded, and when she turned the wheel, it would not turn. A mechanic pulled up behind and told the contact that it could be rack and pinion steering. If any vehicles had been on the road there could have been a collision.*Ak

Filed Incident SteeringNHTSA 10140027
Steering

Consumer experienced steering trouble which caused the vehicle to go straight in one direction. Dealer informed consumer that a bolt broke inside the steering column, and needed to be repaired. *Ak

Filed Incident SteeringNHTSA 10103479
SteeringSuspensionFuel systemVisibility & wipers

Various problems with 1994 chrysler lhs. *Mr the mirror in the windshield was too low and obstructed the vision of the driver when looking to the right side, the front end was bouncing and wobbling in the front end, the fuel problem caused an odor in the interior of the vehicle and the steering column was defective. *Sc *jb

Filed Incident Steering · Suspension · Fuel system, gasoline · VisibilityNHTSA 10083725
Steering

On february 2002, 2 bolts connecting to the rack and pinion and tie rods snapped in half and nearly caused me to crash my vehicle. The snapping of the bolts caused the malfunction of the rack and pinion and I had to replace the rack and pinion plus the bolts (from chrysler). On january 23, 2004 , the exact malfunction occurred again almost causing another accident. I can't understand how a solid steel bolt manufactured by chrysler can snap in half after only 2 years. I have owned other automobiles older than the...

Read the full complaint

chrysler lhs and never had a bolt break in half at any time. I have been lucky on both occasions that I was able to maneuver the vehicle before an accident occurred. Also, these repairs are costly and cause one to be apprehensive about driving the vehicle again. *Ak

Filed Incident SteeringNHTSA 10055122
SteeringEquipment & accessories

Safety alert: while driving, a bolt holding the rack and pinion arm sheared off and the steering failed ! ! ! The steering completely failed. It was inoperable. When I called chrysler customer service they hung up on me... We just bought a toyota.

Filed Incident Steering · Equipment · Unknown or otherNHTSA 10070175
Steering

While driving 5 mph, attempting to make a right turn, the steering wheel failed to respond. The manufacturer was contacted. Please provide further information. *Ph

Filed SteeringNHTSA 10047772
Steering

Consumer stated while traveling and without any indication inner and outer tie rods broke, causing consumer to lose control of vehicle. *Ak

Filed SteeringNHTSA 10042816
Steering

While backing around a corner, the righthand cv shaft popped out of the housing. The cv shaft was replaced only to have it happen again while backing up and turning the wheel. Closer inspection showed that the lower control arm mount had torn away at the weld area. I can email a picture of the area if you would like. Thanks... Dan dt

Filed Incident SteeringNHTSA 768757
Steering

When making a sharp left turn there is a loud clunking noise. Dealer determined that steering gear assembly needed to be replaced.*Ak

Filed Incident SteeringNHTSA 8008673
SteeringSuspensionElectrical system

Frame of vehicle is weak and is moving under steering gear. Cause is unknown. *Ak consumer states that he replaced the rack and pinion and in doing so, found that the wiring harness that goes from the solenoid control module and the solenoid control valve had been put in between the crossmember and the rack and pinion, a bolt had cut and shorted out the harness, this is the bolt that holds the mount of the rack and pinion, while turning the wheel to the left and right, the master cylinder and rack and pinion move, dealer recomended replacement of the rack bushings and right sway bar link, however stated the steering was not a problem. *Slc

Filed Incident Steering · Suspension · Electrical systemNHTSA 8008591
Steering

NO SUMMARY LISTED FOR ABOVE VEHICLE. *AK

Filed Incident SteeringNHTSA 752109
SteeringElectrical system

Right steering tie rod has rubbed through transmission harness, causing a short circuit which resulted in an electrical system malfunction. A recall has been issued on vehicle's make and model. However, this vehicle was not included due to vin. Vehicle was repaired at the owner's expense. *Ak

Filed Steering · Electrical systemNHTSA 890631
Steering

Whenever weather is cold and turning steering wheel, rubber bushing on power steering would make a lot of noise. It also makes it hard to turn. *Ak

Filed SteeringNHTSA 881283
SteeringBrakesEngine & cooling

White smoke comes out of engine. Brakes self applyed while driving. Steering wobbles all across lanes.*Ak

Filed Incident Steering · Service brakes, hydraulic · Engine and engine coolingNHTSA 738454
SteeringSuspension

Vehicle went in the opposite of the direction from where it wassuppose to go. Dealer replaced inner tie rod & wheel alignment. Other tie rod will need to be done. *Ak

Filed Incident Steering · SuspensionNHTSA 869560
Steering

While driving at approximately 40mph tie rod broke, causing a lack of steering & no control of vehicle. This has happened once before. Vehicle towed to dealer. Rack & pinion needed replacing. Contacted manufacturer.*Ak

Filed Incident SteeringNHTSA 865629
SteeringTransmission & drivetrainEquipment & accessories

This car had a bumper to bumper 60,000 mile warranty - transmission and air conditioning should have been covered 100% I did not purchase this vehicle from vandynhoven's only had it serviced through them. They are reimbursing me 50% on the airconditioning because chrysler has agreed to pay 50% but I feel that the evaporator core was warranteed up to 70,000 miles and now I'm at 71,700 and they aren't covering it in full. The car was brought in at least 2 times while under warranty with air problems ? Same with the transmission - it was brought in on several occations where it should have been fully covered and I had to pay $750.00 The intake manifold was leaking on 10/04/99 *ak

Filed Incident Steering · Power train · EquipmentNHTSA 724327
Steering

Rack & pinion steering went out. Also, left inner tie rod broke. *Ak

Filed Incident SteeringNHTSA 863440
Steering

Two and only bolts of rack and pinion completely sheared off exiting from gas station resulting in total loss of steering. Original rack and pinion was replaced at 47k miles with a new one. Dealer being very cooperative in trying to get reimbursement for us ($800+). Our concern is possibly defective bolts and need to issue recall for replacement of bolts. We kept original sheared bolts and rack. Dealer now has bolts and has sent them to detroit for testing. Dealer also has now taken possesion of rack and...

Read the full complaint

pinion showing remnants of sheared bolts inside. We have had many problems with the front end/steering of this vehicle. Each time repair is made, problem gets worse, now culminating in total loss of steering which could have also resulted in the death of my wife, who was driving the car. Fortunately, she had pulled into a gas station after driving several hours on i-74 at 65 mph. Should a 1994 chrysler lhs now be on its third rack and pinion. I think not. I'm not optimistic dealer will come back with a definitive answer although the bolts were sent to chrysler engineering for metalurgy testing. If you need further information, we have documented all repairs/problems with this vehicle and would supply you with same. *Ak

Filed Incident SteeringNHTSA 722325
Steering

Rack and pinion steering welds are breaking away from the k-frame. Dealer has been contacted. *Ak

Filed SteeringNHTSA 861101
Steering

The sterring wheel vibrates/pulsates when the brakes are applied.

Filed SteeringNHTSA 713821
SteeringEquipment & accessories

Dear nhtsa, in january I bought a 94 chrysler lhs in good condition from a friend. It had around 75000 miles on it when I bought it. Before I bought it, she told me that she had repaired the ac numerous times and the warranty had even been extended on it until 70,000 miles. Also, I read in consumer reports that in canada, the chrysler lhs ac warranty was extended to 7 years or 150,000 km to address ac evaporator problems. With that in mind, when I tried to use the ac in the spring/summer, it smelled like the...

Read the full complaint

nastiest, worst smell ever and I couldn't use it. When I took it to the chrysler dealership, they told me that I needed a new air conditioning system for $1500. When I brought up the history of repairs, they offered no payment help whatsoever. I decided to take my car to my regular repair shop, and they told me that it was only the evaporator, and it would cost me around $500 to fix. I paid for that. The reason that I am telling you this is because the part was defective, and the dealership not only wouldn't help me with the repairs (even thought they knew the ac had a history of problems) but they tried to sell me more unnecessary parts (the rest of the ac system). The second problem that I am having, which has not been fixed is the rack and pinion. In mid january I turned on the car one day and the power steering was out. I took it to my good mechanic (not the liar/thief chrysler dealership) and he told me that the rack and pinion needed to be fixed/replaced, another $400-500 job. Instead of fixing it, I decided to do a little bit of research and I noticed your investigation pe99044 which started on june 28,1999 and I wanted you to know that my rack and pinion is also defective, and it needs to be replaced. Thank you for all of your help and please feel free to e-mail me at [email protected] thanks again!!!

Filed Incident Steering · EquipmentNHTSA 712232
Steering

Vehicle had been parked. Started vehicle & attempted to back up & nothing happened. Had no control of vehicle. Was able to turn steering wheel. Had vehicle towed to dealer. Informed by mechanic, bolts on both side of tie rods had broken and steering gear box had also went. Mjs

Filed Incident SteeringNHTSA 848711
SteeringEngine & coolingBody, doors & structure

1) Rack & pinion steering components are becoming worn after only 59000 miles. As the steering wheel is moved, a "clunking" noise is heard coming from the rack & pinion gear box, resulting in vibration through steering wheel at low or high speeds. 2) Trunk is filling with water due to body welding cracks. Welding cracks are located in each rear corner of trunk lid near each turn indicator. 3) Engine ticking is coming from valve train wear. *Ak

Filed Incident Steering · Engine and engine cooling · StructureNHTSA 702516

Chrysler LHS steering complaints by year

LHS steering problems, every year

Had a steering problem with your 1994 LHS? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience