The abs hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.
Brakes
Dodge Dynasty Brake problems by year
99 complaints filed with NHTSA about the Dodge Dynasty's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
Front disc brake caliper guide pin bolts may not have been adequately torqued and could loosen.
Latest Dynasty brake complaints
WAS UNABLE TO STOP VEHICLE AT REDLIGHT
Tl*the contact owns a 1993 dodge dynasty. The contact stated that the pump motor assembly was making a noise while driving. He was advised that the abs, pump motor assembly and the brake actuator piston were the primary cause of the failure. A local mechanic advised him that recall 96v099000, service brakes, hydraulic antilock seemed to be directly related to the failure. An authorized dealer inspected the vehicle and offered no assistance. The manufacturer advised her that the repair was performed previously and...
Read the full complaint
would not repair the vehicle again under the recall. The contact referenced the lifetime coverage of the parts on the recall notice but the manufacturer denied it. The vehicle has not been repaired. The current mileage was 94,782 and the failure mileage was approximately 93,900. Updated 01/15/10. *Lj updated 01/19/10.*Jb
Tl*the contact owns a 1993 dodge dynasty. While driving 40 mph the brakes failed. He had to shift the vehicle into neutral to decelerate. The manufacturer advised the contact that recall# 96v099000, service brakes, hydraulic, anti-lock was repaired with the previous owner which made him ineligible for a free remedy. No repairs were made. The current and failure mileages were 180,000.
Tl*the contact owns a 1992 dodge dynasty. While driving 30 mph and attempting to stop the vehicle, the brakes failed. The contact stated that the antilock brakes locked, which prevented the vehicle from moving. The vehicle was towed to the dealer. The vehicle was repaired in 1999 according to nhtsa campaign id number 96v099000 (service brakes, hydraulic:antilock). The contact stated that there was a lifetime warranty on this recall; however, the dealer does not want to repair the vehicle again for free. The failure mileage was 100,000.
Abs anti-lock system warning light goes on at times, then off other times. Followed by abs anti-lock system functions to fail totally reduced brakes to stop vehicle by 95% used parking brake to achieve stop. *Tr
While applying the brakes pedal went to the floor. Vehicle continued to accelerate. Consumer pulled over into a ditch in order to stop. Consumer had the vehicle towed to the dealer for inspection, and mechanic determined that the abs braking system unit needed replacement. Consumer informed the mechanic that the problem recurred. *Ak
While applying the brakes brake pedal went to the floor. Consumer was able to maintain control of the vehicle, and had the vehicle towed with no brakes to plaza dodge. Mechanic determined that the pump motor needed to be replaced, and replaced it three times. However, the problem recurred. *Ak consumer was driving on city streets going less than 20 mph and was able to ditch in off roadway medians or drainage ditch with no damage to vehicle or property. *Tc
Consumer received recall 96v099000 concerning abs brake failure. Abs brake light came on and stayed on. After driving 45 mph, consumer smelled a burning odor. Consumer left the vehicle, but saw nothing burning. After getting back into the vehicle, and when pressing the brakes, consumer felt a pulsing sensation. Also, vehicle had four transmissions installed. *Ak
Vehicle experienced the same defect with its abs as stated in recall 96 v 099 000, but it was not included in recall due to vin. *Ak
With no warning, abs motor went out, causing vehicle to lose power. Also, it was hard for vehicle to stop. Cause unknown . Dealer notified. *Ak consumer states that the abs pump motor failed and when calling the dealer mentioned recall, the dealer stated recall had been completed in jan of 1997 and was no longer covered, however after contacting nhtsa and dealer seeing bottom of recall notice, dealer made the proper repairs. *Slc
The vehicle has experienced multiple abs brake pump failures which causes the vehicles brakes to fail without warning, consumer states that the vehicle did not experience problems prior to the abs recall repair. Nlm
NHTSA CAMPAIGN ID NUMBER: 96V099000. *AK
BRAKES IS MY PRROBLEM.*AK
The abs system failed and driver went through red light with no brakes. I am a friend of colledge student who is a friend of my sons, so I am kind of in the middle attempting to get this serious problem fixed. I know the car is old and chrysler says no recall is in effect now but this car has abs recalls and we want to know if chrysler should contribute to the resolution of this obvious defect?*Ak
Damage cost is an approximation. Accident was reported to my insurance company. No safety defect stated in summary. *Ak
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data