Certain trucks equipped with dual rear wheels fail to comply with the requirements of federal motor vehicle safety standard no. 108, "Lamps, reflective devices and associated equipment." The trucks may have been inadvertently manufactured without the roof...
Lights
Dodge Ram 3500 Lighting problems by year
66 complaints filed with NHTSA about the Dodge Ram 3500's lights. Headlights, tail lights, brake lights, turn signals and interior lighting failures.
Lighting complaints by model year
Lighting recalls
Latest Ram 3500 lighting complaints
Happened on both sides 2 month apart. Loud bang and rumble. Inside tire, tread came off of tire. Damaged inside of wheel well, running lights, fenders on the dually, metal supports on fender. Never had this happen in 30+ years of towing and driving trucks.
Tl* the contact owns a 2003 dodge ram 3500. The contact stated that the headlights failed intermittently without warning. In addition, the windshield wipers failed intermittently and worked only at the slow setting. The dealer diagnosed that the tipm module failed and needed to be replaced. The vehicle was not repaired because the part was on back order. The vin was not included in nhtsa campaign numbers: 06e023000 (exterior lighting) and 09e009000 (visibility). The manufacturer was made aware of the failure. The failure mileage was approximately 230,000. Updated 08/14/2017*js
It has been several years now but after extensive research I have decided to take action. I was driving my pick-up in town when I lost my gauge lights and I noticed at the same time I lost all my maker lights on the vehicle. I pulled over and found a blown fuse in the fuse box and replaced it with a new one. Right away it blew again only this time it also blew the cercit in the totally integrated power module, wichata left me no choice but to bypass the curcit and get power to my lights form another...
Read the full complaint
source. The next day I went to the dealer and was told it is a common problem and the tipm is $850 that don't include the cost of replacing it and then programing it ti the vehicle. So I decided I wasn't going to pay that much for something that I had already fixed by bypassing the problem. Then a few years later I was driving down the highway around 65 mph at night when I lost my high beam headlights upon further diagnosis I found it to be the tipm at fault again. I spoke with the dealer about it and they told me it too was a common problem. So I filed a complaint with chrysler about both issues and told them they needed to get it fixed and they told me they would look into it. So I let it go without pressing the issue any further. As to my knowledge nothing has been done. But after extensive research I have found more serious problems with the tipm, that dodge needs to acknowledge and bite the bullet and fix the problems. Due to these issues being major safety problems. (I.E. Loss of wipers, loss of low beam headlights, and turn signal flashing the wrong way)
Both mounting tabs on the driver's side tail light fixture broke allowing the entire housing to fall off on the interstate. It was dangling by the electrical pigtail.
Totally integrated power module has a short causing the right side parking lamps, marker lamps, and right side taillight to blow the fuse every time it is changed. As soon as the lights are turned on, the fuse blows within seconds.
Tl* the contact owns a 2006 dodge ram 3500. The contact stated that while driving 40 mph, his visibility decreased then eventually failed without warning. The contact stated that the tipm board failed which affected the visibility of the low beams. The vehicle was not diagnosed however, the low beam lights were repaired but the failure persisted. The manufacturer was notified of the failure. The failure mileage was 180,000.
Steering wheel not center dealer wont fixed ask three times also turn signals the right comes on when you turn on the left one they fixed after fighting with them the wipers stop some times and then go slow then fast then stop the tipm is bad it runs all the electrical on truck had lots of concerns that it will stall because some time the head lights go bright then dim then bright the trailer light some time come on both then one goes out had trailer check out they said was the truck I drive in daylight hours if I can just had tipm replaced at dealer had to fight with them it cost me 1500.00 Dollars they said their no recall it a safety thing I just think they should pay not me. *Tr
Tl* the contact owns a 2007 dodge ram 3500. The contact stated that after shutting off the vehicle, the interior lights failed to power off. The battery was disconnected in order to power off the interior lights to avoid draining the battery. After the battery was reconnected, the windshield wiper fluid dispensed and smoke came from the fuse box under the hood. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 161,000.
Discovered that there was a recall on the malfunction switch. I carried my vehicle to the dodge dealership. I was refused to have the switch replaced because I was told I was 700 miles over the warranty. I tried to explain that this was a recall to no avail. My switch is doing exactly as described, at intermittent times the switch will display the opposite direction chosen. Turn right blinker on and left comes on, etc. Also sometimes the switch will not turn headlights from dim to bright or bright to dim. This is a major safety concern as it gives the wrong intention on turns and also blinding oncoming traffic. These issues could possibly cause a crash. *Tr
Directionals suddenly started blinking fast. Right & left directional don't opperate, right rear taillight doesn't operate, front left headlight does not opporate, both rear brake lights don't opperate, checked all bulbs by certified mechanic. All bulbs are in good condition. Tested all electrical & lighting lines, certified mechanic concluded that the integrated fuse box is defective & needs a brand new replacement. No corrosion present. Ordered fuse block from dealership, parts dept. Confirms these blocks are on...
Read the full complaint
national back order, with 1000's of orders placed. Called chrysler, they said they can't help as there's no vendor making this part yet. If I got a used part for $400, it'd be an old defective fuse box & I'd have exact same safety issues. Apparently many 2003-2005 dodge ram diesels currently have this same electrical problem. *Tr
Safety issue - almost had an accident. Was turning left, blinker turned on to left, but right blinkers flashed! Person behind me thought I was turning left and started passing on my right. The internet has so many complaint of the same issue. No word from dodge!!!! The may be looking into 2006, but not any other year! *Tr
Turning left onto farm to market...Signaled left..Rear vehicle began passing me on left I slammed on brakes as did they...Although my turn signal lever was in left turn position...Vehicle turn lamps were both signaling a right turn as was dash lamp...Very dangerous..Could have killed passing motorist are sent them to the ditch ..Signal now malfunctions on a weekly basis..Switch on backorder...Tells us something... *Tr
Tl* the contact owns a 2006 dodge ram 3500. The contact stated that while traveling various speeds, the driver's side low beam headlight failed. The contact also mentioned that the gauges failed to function. The vehicle was taken to the dealer where it was found that the integrated power module had failed. The vehicle was not repaired. The manufacturer was contacted about the failure. The failure mileage was 71,000.
Tl* the contact owns a 2006 dodge ram 3500. The contact stated that while driving approximately 55 mph, he was alerted that the driver's side brake light was not illuminated even when applying the brakes. In addition, the driver's side turn signal failed to function when activated. The vehicle was not repaired. The manufacturer was notified of the defect. The approximate failure mileage was 77,540.
Trailer turn signals & brake (left) not working on factory 7 prong trailer adapter, truck indicator is ok, no signal to "left" in the wiring loom from the pdc/fmc to the factory 7 prong trailer adapter. (0 Voltage), right turn, right brake, running, trailer brake & battery charge are fine. Dealer wants 1000$+ to fix/replace a defective pdc/fmc. Had not I done a walk around this could/would of caused an accident if I was making a "left" turn, merging or slowing down/stopping.. Bulbs are all good and independently checked with a 12v power source. *Tr
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data