Ducati North America (Ducati) is recalling certain 2019-2020 Hypermotard 950 and Hypermotard 950 SP motorcycles. The negative terminal on the battery may break, potentially causing a sudden loss of power and an engine stall.
Electrical system
Ducati Hypermotard Electrical problems by year
2 complaints filed with NHTSA about the Ducati Hypermotard's electrical system. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.
Electrical complaints by model year
Electrical recalls
On certain motorcycles, the battery can move side to side inside the fuel tank mounting compartment. This movement could result in main wiring harness damage at the battery terminal. This condition could cause an electrical short consequently stopping the...
Latest Hypermotard electrical complaints
June 15, 2017 about 1400est @ spartanburg, sc-parking lot of cummins atlantic electronic dash went into "christmas tree" mode of random flashing lights, fans on, emergency flashers on, engine shut down and no re-start. Turns out to be a dealer and manufacturer acknowledged problem with ducati canbus system acknowledged by ducati to dealers in a bulletin dated 3november 2016 with orders to install a preventive device in all stock of years 2013-2015 but with instructions to take no active outreach to existing owners...
Read the full complaint
in order to install the same preventive device but to wait until the owner contacts the dealer for service or canbus failure. The 3nov17 dealer bulletin claims engine performance is not affected by the christmas tree phenomenon which apparently signifies that the canbus has been destroyed. This instance occurred at about 10mph in the parking lot of the business noted. Internet research immediately revealed extensive discussion by ducati owners of this issue, with multiple failures related. Ducati refuses to acknowledge that engine shut down, impairment of lighting, compromise of traction control including abs and other electronic functions controlled and monitored by the canbus system represents any safety issues for operators or passengers of these vehicles. Ducati quietly replaces destroyed dashboards containing the central canbus electronics. However, at least one dealer acknowledges that this is a common failure issue for all ducatis using canbus, which apparently started in 2002. Written documentation is in my possession and other affected owners are available to nhtsa for its review. While replacing failed units, ducati remains mute and unresponsive to vehicle owners and operators on the safety subject. Evidence in the form of failed canbus units are apparently returned to ducati and even possibly re-used as new after repair.
Sat. 5 Aug 2015 after a 15,000 mile service, riding about 240 miles the bike suddenly started acting strange. The dct light flashed for no apparent reason and the bike bucked erratically. I stopped, and switched ignition off, then started up again. It started normally. After a few (50?) Yards the dct again flashed multiple times, and the abs and dct both turned themselves off. Restarting again, the bike seemed normal for a half mile or so, then the bike went into a slow driving mode and would not get any...
Read the full complaint
speed. Calling the shop -the tech manager advised me they had no way to pick up the bike, and I should ride it in (about 200 miles). I was taking off from a stop in slow-mode when the dct flashed, and the slow mode disengaged suddenly causing the bike to lunge suddenly (a lot like a two stroke might do full throttle) - I pulled a knuckle joint but managed to hold on and control what would have been a fall into accelerating traffic from the light. Then the 'check engine lamp was on until I made it another 10-20 miles or so to the shop. The shop said that the retaining clip on the speed sensor wire had come loose (it's a 'c' clamp made of nylon) and the wire was rubbing the rotor, until it shorted and confused the computer. Because the is a throttle-by-wire controlled engine, that wire and clip should be better safeguarded. I have added a zip-tie to keep it in place more securely. This should be retrofitted to all these machines before someone gets killed. Also, any problem placing a bike into slow-mode should only be re-set by the tech at the shop. It should not be able to self-cancel - that's potential death.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data