- The problem
- On certain sport utility vehicles equipped with antilock brakes (abs), the abs module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.
- The risk
- An electrical short might cause an abs malfunction that would illuminate the abs warning light, and in some cases, the module may overheat resulting in burning odor, smoke, and/or fire. This condition could occur either when the vehicle ignition switch is in the off position or while the vehicle is being operated.
- The fix
- Dealers will inspect the wire harness connector to the abs module for missing or dislodged wire seals, and repair or replace the harness connector as appropriate. The dealer will also inspect the connector on the abs module and replace it if it is found to be corroded or damaged. The recall began on april 23, 2007. Owners may contact ford at 1-800-392-3673.
Brakes
2004 Ford Escape Brake problems
Owners have filed 32 complaints about the 2004 Ford Escape's brakes with NHTSA - 6% of all its complaints, most recently on January 22, 2024. They describe 5 crashes, 2 fires and 3 injuries. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
- Complaints
- 32
- Recalls
- 2
- Crashes
- 5
- Fires
- 2
- Injuries
- 3
- Deaths
- 0
Brake recalls for the 2004 Ford Escape
- The problem
- Certain cardone master cylinders with part numbers 10-2925, 10-2987, 10-2987mza, 10-3083, 11-3015, 11-3042, 11-3044, 11-3045, 11-3047, 11-3064, and 11-3156, and with date codes lower than dca7078 sold as replacement equipment for use on the vehicles listed above. The seal on master cylinder can fail and leak brake fluid.
- The risk
- Loss of brake fluid can result in poor braking performance, possibly resulting in a vehicle crash.
- The fix
- Cardone will notify owners and offer to repurchase any defective master cylinders. The recall began during april 2007. Owners can contact cardone at 1-800-777-4780.
Brake complaints
A few times I have pressed the brakes when coming to a red light and stop signs But instead of my vehicle stopping it propelled me forward as it excellerated out of no where and pushed me into oncoming traffic, I almost was hit by other cars and I almost hit other cars and even have had to swerve onto the side walk to prevent myself from getting g hit by another car. If there were people walking, I would have definitely hit them! When I press the brake, I'm not expecting to accelerate instead Also apparently this...
Read the full complaint
recall of this issue was already done back in 2005 but i just purchased this vehicle in the fall of 2023 And the dealer says there is no recall since it's already been fixed by the previous owner years ago But it needs to be fixed as it's still doing it to me
Brake master cylinder is leaking brake fluid I read about a previous recall not sure if it pertains to my model but it leaks everytime I push my brake pedal
UNKNOWN
Vehicle was u able to control,constant issues with transmission and idle kept getting stuck,speed up on its own and was unable stop without throwing car in park while driving
On 916/17, we were just getting off the entrance onto route 276, east bound, north of philly. I was starting to accelerate and merge with traffic when the accelerator pedal suddenly went to the floor on its own. I then turned off the engine with the key and was able to pull off the right hand side of the road. After we were towed a mechanic was able to lift the pedal after detangling it from the cruise control cable. There was a recall for faulty cruise control (sticking accelerator pedal) in 2015. I took...
Read the full complaint
my vehicle in for the recall and it was repaired by a ford dealer on 6/1/15. The recall notice # is 12s37/nhtsa recall 12v-353 I do not have the ability to scan a repair bill, which amounted to a mechanic tying the cable up out of the way of the pedal
Tl* the contact owns a 2004 ford escape. While driving approximately 35 mph and depressing the brake pedal, the brakes malfunctioned and the vehicle would not stop. The contact also indicated that the check engine light illuminated during the incident. The cause of the failure was not diagnosed. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 160,000.
TAKATA RECALL
TAKATA RECALL
We own a 2004 escape. That two weeks ago caught fire due to the abs control module. We also have had brake lines go bad due to part failure twice. And the total of three alternators. Now we have spoken to ford regarding the 01-03 fire issue. But they will not do anyrhing to consider the 04 even though in researching the actual recall it was the same issue. I woulf like to see this happen. We are selling our vehicle to the sealer sue to lack of reliability. But wanted to vet the word out on this issue. Our engine also idle and tries to pull the vehicle forward even with the brakes applied. This is due to a faulty idle air controll valve.
Tl* the contact owns a 2004 ford escape. While driving at an unknown speed over a bump in the road, the vehicle emitted a clucking noise. The vehicle was taken to the dealer for diagnostic testing, which indicated that the front suspension bar was fractured. The front suspension bar was replaced. The contact also stated that the brake lines also failed due to corrosion. The brake lines were replaced. The vehicle was repaired. The manufacturer was notified. The approximate failure mileage was 125,715. ..Updated 02/01/16 *bf *js
Tl* the contact owned a 2004 ford escape. The contact stated that while driving at approximately 20 mph, the speed accelerated independently, the brake pedal was depressed but failed to respond causing the vehicle to crash into a guard rail. The air bags did not deploy. A police report was filed. The vehicle was towed to an independent mechanic. The vehicle was destroyed. The vin was not included in nhtsa campaign number: 12v353000 (engine and engine cooling, vehicle speed control). The manufacturer was made aware of the failure. The failure mileage was unknown.
I was leaving my parking spot where the vehicle had been parked for approximately 45 minutes when the brake pedal went to the floor and my brakes were not working properly. I discovered that brake fluid was leaking out of the brake line in the front drivers side wheel well. The rubber hose had deteriorated and had to be replaced. Yesterday I was driving when my brake pedal went to the floor again. When I parked the car I found that brake fluid is leaking from the brake line in the front passengers side wheel well....
Read the full complaint
The vehicle now had approximately 137000 miles. It appears that the rubber brake line hose had deteriorated on that side as well. This is a major safety issue as both times I was driving my kids and had to worry about injuring them and potentially anyone else on the road at the times this occurred.
THE CAR STALLS AFTER PUTTING IT IN GEAR / *TR
I first noticed a surging and squeal type noise while coming to a stop. Spouse had repaired 3 times yet it continues. During this time I also heard a clanking noise from rear end as if hatch (window/door) was not securely closed but then assumed it may be related to the aforementioned issue. I mentioned noise increased, loud, frightening (steering difficulties). He contacted ford by phone (x3) and emailed however their reply was no fatalities or incidents had been reported therefore we have 2 options. 1) Take it to...
Read the full complaint
a ford dealer for repair at our expense, 2) trade in for a new ford vehicle. Both school/city/govt employed and cannot afford 2000.00 To repair. Yesterday my husband removed the entire right shock when I returned home from work after a 12 hr day & told him I felt as if the back end was going to fall off & clanking sound intensified. At 8pm he was laying under car on garage floor and found the shock hanging! He was forced to remove as I had to work the next day at 6am. I am driving without one shock, new tires, rusted rear frame and surge continues. I would appreciate any suggestions as to other avenues for reporting. I have 2 coworkers with similar issues, both escapes. The removed shock is rusted, near crumbling of sort but saved along with several photos. Thank you in advance for reviewing my lengthy email and look forward to any input and recommendations. [[redacted]] information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6). *Tr updated 1/21/15 *js
Rubber brake hose on passenger side front ruptured causing all brake fluid to drain from system. Upon inspection it was found the driver side rear rubber brake hose was near failure. Ford service technician indicated that he had seen several failures on ford escapes. This failure causes the brakes to fail completely with no brake pedal response. *Tr
Tl* the contact owns a 2004 ford escape. The contact stated that while driving 25 mph, the steering wheel seized and the brake and accelerator pedals would not respond to pressure. The contact was able to move the steering wheel after much effort but shortly after, crashed into a utility box. The contact was not injured. A police report was not filed. The vehicle was destroyed. The failure and current mileage was 90,000. Updated 04/22/14 ma when the consumers daughter crashed into the electrical box, it caught on fire, and spread to the vehicle. Updated 04/24/14
Tl* the contact owns a 2004 ford escape. While parked, the contact noticed that the abs warning light was illuminated on the instrument panel. The vehicle was taken to an independent mechanic for diagnostic testing. The mechanic stated that the abs module would have to be replaced. The contact referenced nhtsa campaign id number: 07v156000 (service brakes, hydraulic:antilock:control unit/module) but was advised by the manufacturer that the vin was not included in the recall. After a period of time elapsed, the...
Read the full complaint
contact began to notice a loud squeaking noise coming from the rear of the vehicle and a grinding sound when depressing the brake pedal. The contact had the brakes replaced but the failure persisted. The vehicle was not further repaired. The approximate failure mileage was 203,258.
I own three of these vehicles and again right front abs ring snapped while driving. Ford will not do anything even though I've had the same problem on all three cars. *Tr
Driving on a state highway approaching a red light, I applied brakes and felt a pulsing sensation in the brake pedal, it became very hard to stop and I had to pull to the shoulder of the road. This has happened several more times since, at various speeds and with no warning. The abs light on the dash does not come on and there are no obd codes. The vehicle becomes very hard to stop. I had the vehicle checked by my mechanic this week. He felt the problem once, but could not find any problems or obd codes, even...
Read the full complaint
after running diagnostic tests. At this point I am in a quandry; I need to use the vehicle, but feel it is unsafe to do so and will probably park it until someone can tell me what is happening and find a resolution. I have read of similar problems due to a defective 'tone ring' in the abs system, but mine is not defective. *Tr
Tl* the contact owns a 2004 ford escape. The contact stated that while having routine maintenance performed on the vehicle, she was advised that the brake lines were corroded and brake fluid was leaking. The mechanic stated that all of the lines needed to be replaced in order to repair the problem. The manufacturer was not made aware of the failure and the vehicle was not repaired. The failure and the current mileage was 116,000.
Tl*the driver owns a 2004 ford escape. The contact stated when the driver applied pressure to the brake pedal at an unknown speed the vehicle would not stop until excessive pressure was applied to the pedal. The vehicle was driven home where the contact noticed the front passenger side brake line had fractured and the front driver side brake line was severely corroded. The vehicle was not repaired. The failure and current mileages were 140,000.
2004 Ford escape - a b s rings on axel cracked and allowed them to move .Result in brake failing -have to let off the brake so it can grab again and a sensor make it pulse the brakes. Using gasket repair to hold the rings in place...Both sides have this problem. We know of three escapes different years that have now the same problem. *Tr
Tl* the contact owns a 2004 ford escape. The contact stated that she took her vehicle to the dealer for recall nhtsa campaign id number: 07v156000 component: service brakes, hydraulic:antilock:control unit/module. The repair was done and now the failure has recurred. The dealer stated that to repair it again the cost would be approximately 200.00, And they are only responsible for repairing it one time. The manufacturer had not been contacted. The failure mileage was approximately 56,000. The current mileage is approximately 82,000.
Tone rings on ford escapes breaking. These rings are for the abs system. Truck doesn't stop properly. I read alot of complaints online about these tone rings. Ford charges $250 per side. In my case both sides are broke . Sounds like a factory faulty part. *Tr
The brakes on my 2004 ford escape, which only has 23,000 miles on it, started squealing, and I was having to push a little harder than usual. On december 26, 2008 my husband took the vehicle to the shop to have the brakes checked, instead of new brake pads, which were curiously in good condition, we are going to need new front discs, front and back calipers, as well as brake pads. We were able to afford the brake pads as well as the right front disc at cost of 400 dollars but we are going to need to shell out another 400.00 Plus to repair the rest. The wait wouldn't be so bad if I didn't need the escape to transport my daughter back and forth to school every day. *Tr
Ford Escape brake complaints by year
Escape brake problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data