Vehicle description: motor home chassis. Hot exhaust gasses can leak from the exhaust gas return (egr) tube on the engine. A hole can develop in the flexible section of the tube. Heat damage to the passenger compartment floor and floor covering can occur.
Engine & cooling
Ford F Super Duty Engine problems by year
31 complaints filed with NHTSA about the Ford F Super Duty's engine & cooling. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
Engine complaints by model year
Engine recalls
Latest F Super Duty engine complaints
My truck has 101k miles on it and it just started stalling out while driving( on streets and highways), also while just idling it stalls(stationary). I took it to my local ford for them to hook it up on their computer to see what the problem is. After hours there and it stalling out and not restarting they couldn't tell what was wrong with it and charged me $125. As I was leaving they said change your maf sensor and #8 coil and it'll be fine. So, I did just that in the parking lot and it still does the same thing....
Read the full complaint
It stalled out many times on my way home. I thought by taking it to the ford dealership (the people that have all the answers for their products) I would get it fixed. And make my truck safe again. I was wrong. Is there something you can do to help me with this. Thanks
My truck has spit out two spark plugs on the passenger side of the engine. These plugs had to be repaired with a hell-coil and this is a temporary fix. It cost me $400 to repair both. My truck has over 100,000 miles and spit out the first at 120,000.
Spark plug shoot out of engine. This is the 3rd time it is because there is only 4 threads to screw into this has happened to this truck two times when it was your with the factory plugs. And now with others that were that were do to specs by ford. This is an expensive fix and it is dangerous to people that stick their hand it there when they see a floppy coil and don't know they can be shocked. Please do something people are getting hurt. It always happens to me when driving, there is a loud noise and then it...
Read the full complaint
starts running different answers sounds like a lawnmower without a muffler. It is scary and caused me a panic attack as I had to find my way off the highway wondering if it is going to explode. It nor fixed because it cost to much and my hand it twitchy from the shock it gave me.
Engine 6.0L, check engine light on, code p0299, 'underboost", car owned since new, odometer now has 12,100 mlesi ford dealership reporting that engine turbo-compressor may need replacement
I have a 2003 f350 superduty truck. It has a triton v10 engine. The spark plug blew out of the engine. This happend 2 years ago also. Forunately I was on surface streets and was not on the freeway which may have been fatal.
Had 8 broken exhaust bolts on this 6.8 V10 only 54687 miles on the truck.
Traveling on a busy highway at 65 mph; the spark plug on my 5.4L v8 triton blew out of its socket. (Any mechanic will tell you everything you want to know about this) this caused an immediate bang and very rough running condition. As soon as it happened; there was an immediate loss of power which in turn; caused a rapid reduction in vehicle speed. Not to mention, the distraction that occurred that caused the lack of focus on surrounding vehicles and other possible hazards. This is the second occurrence of a...
Read the full complaint
separate spark plug blowing out of its socket on the same motor. This will cost several thousand in repairs after all is said and done. On top of the money spent repairing the last incident. There is a documented history of this situation with the more extreme having fire issues. The fire is because atomized fuel is sprayed into the engine compartment due to there being a hole where the spark plug is supposed to be. There was no crash, fire or injury in this case. However, it was close to having all three. *Tr
Engine,6.0 Diesel was loosing water. Took the vehicle to the dealer and was told that the head gaskets were blown and that the head bolts were soft and had stretched. This is a known fault with this engine according to the dealer. If it is a known fault, why hasn't there been a recall to fix this. I have never known an engine to have blown head gaskets at 104,551 miles. There are numerous service bulletins on this problem. *Tr
Spark plug blew out of aluminum head causing unburned fuel to ignite from coil ignition. *Tr
Spark plug blew out while traveling on narrow mountain road causing engine to stall losing power steering. Steered into the mountain side to prevent head on collision. There have been several engine fires due to plug blowing out of cylinder head and fuel not properly burning. *Tr
The problem: 6.0L head bolts. Probably the most well-known and problematic is the issue with the factory head bolts. Essentially, the bolts stretch, which results in a blown head gasket. Ford is aware of this problem is why there is a lawsuite pending due to this issue and others with this 6.0L engine. The problem: egr cooler the 6.0L diesel has a bad reputation for blown head gaskets and sticking egr (exhaust gas recirculation) valve. While stretching head bolts are partly to blame for the head gasket issue,...
Read the full complaint
programmers that turn up the power in your 6.0L truck are guilty culprits as well. Simply put, the stock egr cooler cannot keep up with filtering a modified 6.0L. A failing egr cooler can cause your truck to overheat, run poorly, and add to the potential for head gasket failure. The problem: vacuum leak although the super duty uses unit bearings up front from the factory, the trucks are still equipped with selectable hubs. Many of the early trucks were equipped with ford-specific hubs which had an auto and on setting only. These hubs were vacuum-assisted and known to be problematic. A leaking or dry-rotted vacuum line is not uncommon to find, nor is a damaged hub actuator. Pictured here is a quick trail fix that uses a stick to plug a vacuum line that was leaking and no longer needed because the truck was outfitted with aftermarket hubs. The problem: front unit bearings big tires and unit bearings don't always mix well. Even in the factory configuration, the non-serviceable unit bearings have a limited life cycle. The easy way to check for a bad unit bearing is by jacking up the front axle, one side at a time. You'll want to raise the tire off of the ground enough so that a prybar can be placed under the bottom of the tire. You can also use your hands to test this, but the prybar will give you extra leverage. Issue recall. *Tr
Was driving down highway at 50mph with no load and heard load pop under head and then a constant blowing noise. Pulled over and found that the third spark plug on passengers side had blown out and was laying on top of motor along with coil pack had broke off. Had to use a kit to tap out hole and install insert. Probably will be more problems in future but we will see. Just don't seem safe for that to happen with the fire threat that could cause. As a local fire chief I have scene how fast a vehicle fire can spread. *Tr
Lack of power or runs rough condition, and/or the malfunction indicator light on with egr related diagnostic trouble codes (p0401, p0402, p0403, p0404, p0405, or p0406). Engine and engine cooling:exhaust system:emission control:gas recirculation valve (egr valve). *Tr
Oil from leaking head gasket ,passenger side,dripping on to hot exhaust system .Oil collects in brush shield on exhaust y-connection. *Tr
Spark plug ejected from head, came out with such force as to break the coil on the fuel rail, shatter the spark plug and disintegrated the spark plug boot. Had to tap larger hole and install threaded insert so a new spark plug could be threaded into head and torqued to specs. Replaced the coil and boot and reinstall the fuel rail and injectors to make the truck serviceable again. *Tr
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data