Ford F700 Problems by year

Certain federal-mogul aftermarket fuel pumps sold under the brand names of carter, accuflow, napa, truflow, parts depo, and parts master, shipped between august 2006 and july 2007 for use on the vehicles listed above. The fuel pump diaphragm in certain...

Vehicle description: medium duty trucks and chassis-cabs. An automatic locking front wheel bearing adjusting nut was damaged during installation or removal by incorrect tools or an incorrect torque specification was used.

Vehicle description: medium duty trucks equipped with 7.0L liquefied petroleum gas (lpg) engine or 7.0L efi (gasoline) engine with the optional cab floor pan reinforcement. The engine wiring harness or battery cable can be pinched between the optional cab...

Vehicle description: medium duty trucks and school bus chassis-cowls equipped with automatic transmissions. The welds that attach the key to the top of the steering column mounted automatic transmission shift linkage may not adequately retain the key...

The hand throttle cable can wear the brass swivel block on the governor lever through which it passes.

Air system blockage in the air dryer occurs degrading the moisture removing capabilities of the dryer when the vehicle is operated in a cold environment and moisture accumulates and freezes in the air dryer or in the line between the dryer and the air system...

A connector in the wiring where the tilt hood mounted lamps attach to the vehicle wiring harness was built without sealing plugs. Moisture, road salt or other contaminants can enter the connection resulting in crossed circuits, shorts or corrosion of the...

The drag link installed can contact the front axle i-beam under certain extreme conditions. This drag link was not intended to be installed on "low profile" vehicles.

As a result of inherent vibration in these engines, the throttle return springs can fracture.

Water can enter the door latch release cable. If the vehicle is operated in below freezing temperatures, the water in the door latch release cable can freeze and cause the latch mechanism to malfunction.

The involved vehicles were produced with hydraulic brake booster supply hoses that are located too close to the engine exhaust manifold and may chafe and develop heat damage during vehicle operation. Chafing and heat induced deterioration of a hose due to...