On certain trucks built with front axles assembled by arvinmeritor, the front spindle nut may be over-tightened causing preload on the front wheel bearings which could lead to premature bearing wear.
Suspension
Freightliner Century Suspension problems by year
13 complaints filed with NHTSA about the Freightliner Century's suspension. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
Suspension complaints by model year
Suspension recalls
On certain trucks equipped with truck hub units manufactured by skf exclusively for use on arvinmeritor's ff98x series non-drive steer axles, the hub unit bearings can wear prematurely.
Vehicle description: heavy duty trucks built with dual leaf spring type air ride suspensions and vehicles built with single leaf spring type air ride suspensions. Rear suspension springs can fracture through the center bolt hole after vehicle assembly.
Vehicle description: heavy duty trucks. The outboard bearing on the steering axle hubs can fail due to water intrusion through a hubcap vent.
Vehicle description: heavy duty trucks equipped with meritor interaxle driveline u-joints. Deflector rings, a part of the system to seal the u-joints from contaminates, are loose. This allows water to enter the u-joint bearing area result in dilution of...
Vehicle description: all vehicles equipped with eaton drive axles and axilok spindle nuts. The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle...
Latest Century suspension complaints
I purchased truck 11/2010 truck drove fine for the first yr. Pulling very light freight always the truck became very hard to control. Truck dances, hops, bounce etc. I have had suspension work done and the prob has not improved. I don't get irregular tire wear no physical signs that can be seen, just poor performance. I would not buy another one. The engine/ trans, no complaints, only the drivability. *Tr
Tl*the contact owns a 2000 freightliner century truck. While driving approximately 55 mph, the driver felt a rumble and thump coming from the vehicle. He attempted to pull the vehicle over, but the wheel bearings became loose. As a result, the wheel was hanging on the steering spindle, the brakes were hanging in pieces, and the air line failed. In addition, the plastic access panel failed. There were no injuries. Roadside assistance was called and it was discovered that the entire wheel assembly was...
Read the full complaint
defective. The vehicle was then towed to a dealer and repaired at the contact's expense. The manufacturer stated that the vehicle was not included in nhtsa campaign id number 03v112000. The current mileage was approximately 910,000 and failure mileage was approximately 900,000. Updated 07/14/09.*Lj the consumer was informed he missed the recall by 4 weeks and a couple of days. The consumer stated he has the same hub unit that was recalled and is requesting reimbursement. Updated 07/16/09.*Jb
Tractor failure, tie rod and king pins and bearings were all in poor condition. *Bf *jb
1998 Century class model trailer experiencing multiple problems.*Mr the manufacturer informed the consumer that one of the u-joints had gone bad, the flex line had rotted away which connected to the exhaust manifold which caused a leak. The vehicle experienced a power steering leak, also the air filter was replaced. The consumer was assigned another tractor, however it was a 2001 model and he soon discovered the fan blades were completely black and he had to tape a filter over the air intake. *Jb *nlm
While driving 50 mph and without warning rear left leaf separated from wheel frame, resulting in major damage to truck. Dealer has been notified; however unable to remedy the problem.*Ak
The left front spring hanger is loose, causing the axle to shift. *Slc
Front spring hanger is loose on the frame, this is causing the axle to shift. *Slc
Front spring hanger is loose, this is causing the axle to shift. *Slc
Left front spring hanger is loose, bottom bolts turn by hand. Nlm
LEFT FRONT SPRING HANGER IS LOOSE. NLM
Left front spring hanger is loose, bottom bolts turn by hand. Nlm
Left front spring hanger is loose, bottom bolts turned by hand. Nlm
Axle #1, left side front spring hanger is loose on frame causing axle to shift back and forth. Nlm
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data