- The problem
- Corrosion of the grabhandle at its mounting surface may lead to cracking or loss of strength.
- The risk
- Failure of grabhandle during use could result inpersonal injury.
- The fix
- Replace grabhandle and its fastener with improved grabhandle; also, install gasket between the handle and air starter reservoir.
Body, doors & structure
1986 Freightliner Coe Body problems
No owner has filed a complaint about the 1986 Freightliner Coe's body, doors & structure with NHTSA. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
- Complaints
- 0
- Recalls
- 3
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Body recalls for the 1986 Freightliner Coe
- The problem
- Buckling of the tilt cylinders may occur while lowering the vehicles cab due to improper use of the cab tilt system.
- The risk
- CAB MAY DROP TO ITS LOWERED POSITION.
- The fix
- Replace the 1 1/2 in. Diameter tilt cylinders on all 104 in. Cabs with 2 in. Diameter cylinders.
- The problem
- The handhold mounting system, which consists of a tubular handle held in three places by cast aluminum brackets and attached to the engine exhaust muffler heat shield. Vibration from this system causes the handhold parts to wear. Consequence of defect: if the parts wear thin the possibility exists that the handhold might give way under the weight of a driver. This could result in personal injury.
- The fix
- Replace the end brackets with a modified design utilizing a rubber isolater. Also, add a plastic sleeve to the center bracket for isolation.
Body complaints
No complaints about this area yet.
Freightliner Coe body complaints by year
Coe body problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data