Tl* the contact owns a 2010 harley-davidson flhtcu. While driving 20 mph, the check engine warning indicator illuminated and the acceleration failed. The contact stated that the failure occurred four other times. The vehicle was taken to the dealer where it was diagnosed that the throttle actuator failed. The vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was 26,000. ...Updated 07/13/16 *bf
Engine & cooling
2010 Harley-Davidson Flhtcu Engine problems
Owners have filed 5 complaints about the 2010 Harley-Davidson Flhtcu's engine & cooling with NHTSA - 16% of all its complaints, most recently on June 9, 2016. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
- Complaints
- 5
- Recalls
- 0
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Engine complaints
Multiple times while ridding my flhtcu the bike goes to "limp mode" no throttle,at multiple speeds, with little to no warning. After tones of researching, hour of labor, and a tone of money, the issue still exist and I am at but a lose. During research I fond this issue to be a very common one with multiple hd models. Due to the poor quality of the materials, parts, and engineering designed used to cause such a extremely dangerous safety hazard, any where on the road. I am requesting hd to be held responsible...
Read the full complaint
and to generate a recall to fix this safety issue for their costumers. You can not have a motorcycle quit on you in front of a tractor trailer on the interstate or any where on the road all by its self. Extreamly dangerious.
On 06/24/2014 at 16,948 miles while accelerating from a red light stop on my 2010 flhtcu, I got to 30 mph and the throttle cut out, the check engine light came on, and the engine went into limp mode. I limped the bike 4 miles home and shut it down. The engine light reset on the second restart and throttle resumed. I took it to the dealer who said it was a faulty twist grip sensor. They replaced the sensor and they said it was all set. On 08/15/2014 at 18,600 miles while merging onto route 6 east in brewster, ma the...
Read the full complaint
engine light came on again, the throttle cut out and the engine went into limp mode. Traffic had to brake suddenly to avoid hitting me as I pulled off into a two foot wide shoulder. I had to ride in this narrow shoulder area for five miles to the next exit at 10 mph with a passenger while traffic rushed by at 65 mph just inches away. I got off the next exit and shut the bike down. The engine light and throttle reset on the next restart. I returned to the dealer and they said it was an open circuit code and as directed by a factory tech tip replaced a pin in the throttle position sensor harness and packed it with dielectric grease. They cleared the code and said it was all set. I'm currently riding the bike again. This is a serious problem that will eventually lead to serious injury or death and needs to be addressed by the manufacturer either by recall or product program. This seems to be an issue as seen here on the nhtsa site and other forums. Please have this addressed by harley davidson. *Tr
As per service bulletin ; tt418-a ,electrical connector corrosion and fretting causing the engine to shut down due to vibration . This situation is hazardous as the bike can fail in heavy traffic and intersections . Harley davidson is aware of this situation sense 2008 . As to date there is no recall planned. *Tr
Riding along at 60 mph when the bike went into "limp mode". I immediately lost all throttle response and my speed instantly dropped to 10 mph. Once the bike goes into this "limp mode", the speed is automatically limited to 10 mph. The engine light came on and I had to ride at 10 mph down a busy street with my flashers on to prevent getting rear ended by all the cars. This "limp mode" is a known issue with harley davidson (check it out on google or at hdforums.Com. Harley is apparently refusing to acknowledge...
Read the full complaint
the issue with the bikes. Throttle by wire (tbw) is causing electrical diagnostic issues that "throw codes" (dtc) diagnostic technical codes and cause the bike to immediately go into this dangerous limp mode. The sudden deceleration can cause loss of control and create the possibility of getting hit in the rear end by traffic that is behind you. Imagine traveling on the interstate at 70 mph and having your motorcycle immediately drop to 10 mph. There are many instances on hdforums.Com and on the internet related to this issue. *Js *tr
Harley-Davidson Flhtcu engine complaints by year
Flhtcu engine problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data