On certain school buses and truck model vehicles manufactured between february 28, 1999, through april 5, 2004, the anti-lock brake system electronic control unit (ecu) may misinterpret a corrupt wheel speed signal.
1991-2001 · 11 model years
International Harvester 4700 Problems by year
Owners have filed 40 complaints about the International Harvester 4700 across 11 model years, and it has 14 recalls. The 1997 has the most complaints once its age is allowed for (13), while 1993 has far fewer than a typical year. The most reported problem area is the brakes, followed by the acceleration & cruise control.
- Complaints
- 40
- Recalls
- 14
- Crashes
- 4
- Fires
- 4
- Injuries
- 11
- Deaths
- 2
4700 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common 4700 problems
International Harvester 4700 recalls 14
On certain heavy duty trucks, a brass fitting connects the double check valve to the brake relay valve. With certain inputs to the vehicle, the weight of the check valve on the fitting can cause the assembly to resonate. The subject vibration can cause...
On certain heavy duty trucks equipped with bostrom driver seat models 910, 910sc, or 914 and international's parking brake code 04036, if someone outside the cab adjusts/slides the driver's seat to its most forward position, with the parking brake set, the...
On certain medium and heavy duty trucks, a brass fitting connects the double check valve to the brake relay valve. With certain inputs to the vehicle, the weight of the check valve on the fitting can cause the assembly to resonate. The subject vibration can...
Vehicle description: heavy duty trucks equipped with bostrom driver seat models (910, 910sc, or 914) and international's parking brake code 04036. If someone outside the cab adjusts/slides the driver's seat to its most forward position, with the parking...
Vehicle description: heavy duty trucks. The vehicles involved in this recall were built for export with manual slack adjusters and were sold in the us. These vehicles need to have automatic slack adjusters in order to comply with the requirements of fmvss...
Vehicle description: trucks equipped with allison 1000 or 2400 series transmissions. These transmissions can experience park pawl to rear cover interference due to an out of flatness condition.
Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is...
The steering column used was incorrectly manufactured. The tube portion of the steering column has a welded end with a specified length of 5.5 Inches. A 3.5 Inch welded end was used by mistake. With the shorter end, it is possible there is insufficient...
At low ambient temperature, with the parking brake applied abd the engine running, pressure can build up sufficiently to partially pressurize the brake chamber which controls the ddm park brake at the rear of the transmission allowing the parking brake to...
The base of the electronic accelerator pedal is made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the...
Latest 4700 complaints
Tl*the contact owns a 1998 international 4700. While driving 25 mph, the contact noticed flames coming from the front passenger side of the vehicle. The dealer stated that the cause of the fire was friction, which resulted from the brakes being jammed by rust. The dealer replaced the front rotor, calipers, and brake shoes. Approximately six months later, the contact noticed flames coming from the rear passenger side of the vehicle. The dealer stated that the vehicle had hydraulic brakes, which caused the fire,...
Read the full complaint
when it should have had air brakes. The dealer replaced the rear brake shoes. The contact was not sure if anything else was replaced. The engine size was unknown. The current mileage is 45,000 and failure mileage was 35,000.
New kelly armorsteel kls tires were put on my work truck which happens to be a propane delivery truck since then rear of truck wanders badly .In the process of getting taken care of with no help from kelly springfield except to lower the air pressure 10 lbs in each of the 4 drive tires which I will not do. *Nm
Dt*: the contact stated the hydraulic brake calipers failed to release. When the failure occurred in the front brake calipers the vehicle pulled in the opposite direction of the working caliper. The failure occurred without warning each time. Although, there was smoke and sparks present there was no fire. The left front caliper has not been replaced, but the other three were replaced on separate occasions. The problem occurred on six occasions. The vehicle is currently at the dealership awaiting further investigation by the brake manufacturer.
The gauges and speedometer quit working on the dash of the 2001 international model 4700. So far there have been no consequences but I have been hearing that it is a hazardous occurence because of the possibility of a fire in the dashboard. Talking to other owners of international trucks they have all experienced the same thing, one with a fire occuring.*Ak
2000 International 4700 medium duty truck used as a tow truck has no cushion on the driver's seat, as a result, I have had a back fusion and still have severe hip pain. *Ak
The brakes have been defective since consumer purchased the vehicle. Consumer's vehicle was included in a recall for the same brake problem, but problem recurred. Abs light was still on after being serviced 8 times.*Ak
Questions about the International Harvester 4700
Which International Harvester 4700 years have the most problems?
Which International Harvester 4700 years have the fewest complaints?
What are the most common International Harvester 4700 problems?
Across every model year, owners report problems with the brakes (17), acceleration & cruise control (5), steering (5) most often.
How many recalls does the International Harvester 4700 have?
NHTSA lists 14 recalls across all International Harvester 4700 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data