On certain conventional trucks equipped with pro-sleeper berths, water intrusion can be found in the bunk control panel area and pool in the tops of the dome light, tv/vcr, and or refrigerator power switches.
1994-2001 · 8 model years
International Harvester 9400 Problems by year
Owners have filed 0 complaints about the International Harvester 9400 across 8 model years, and it has 11 recalls.
- Complaints
- 0
- Recalls
- 11
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
9400 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
International Harvester 9400 recalls 11
Vehicle description: heavy duty trucks equipped with air brake haldex automatic slack adjusters, long stroke brake chambers, and dana brakes. The automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the...
Vehicle description: heavy duty trucks built with international code 16sch (lower bunk webbing restraint). Incorrect bolts were used to hold the bunk webbing restraint latch brackets to the bunk base.
These vehicles are equipped with a detroit diesel optimized idle system. If the ignition is turned on and the fuse for the electronic control module (ecm) power feed line is removed or burned out, unintentional cranking of the engine will occur..
Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is...
The equalizing beam shaft of the tandem axle suspension were manufactured from as-rolled sae4140 steel rather than the specified annealed sae4140. These shafts can fracture inside the beam at the toe of the weld.
Straps holding the sleeper upper bunk in the raised position can release without warning.
The driveline could have little torque or no torque on the driveline nut that retains the yoke at the center bearing or bearings if the vehicle is equipped with multiple center bearings.
The swivel seat assembly attachments between the upper and lower portions are inadequate to insure that the assembly will stay together during normal use. Vibration can cause the attaching bolts to work loose and fall out.
During assembly, the tie rod end nuts were not properly torqued. Extremely low torque can allow movement beween the ball stud and the tie rod arm causing damage.
Questions about the International Harvester 9400
Which International Harvester 9400 years have the fewest complaints?
How many recalls does the International Harvester 9400 have?
NHTSA lists 11 recalls across all International Harvester 9400 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data