Navistar is recalling certain model year 2011 international 7300, 7400, and 7500 vehicles manufactured from june 30, 2010, through october 13, 2010. These vehicles were built with an incorrect steering system draglink.
2001-2011 · 11 model years
International 7500 Problems by year
Owners have filed 0 complaints about the International 7500 across 11 model years, and it has 17 recalls.
- Complaints
- 0
- Recalls
- 17
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
7500 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
International 7500 recalls 17
Navistar is recalling certain model year 2011 international 7300, 7400, 7500, vehicles for failing to comply with the requirements of federal motor vehicle safety standard no. 108,Ds"'lamps, reflective devices, and associated equipment." These vehicles are...
Navistar has notified nhtsa of a defect on certain model year 2008-2011 international trucks equipped with an optional jump start stud. Corrosion at the base of the stud may cause an electrical short between the stud and battery box.
Navistar is recall 7,521 my 2009 international model trucks and my 2009 and 2010 ic school and transit buses manufactured from april 1, 2008 to december 12, 2008, equipped with a horton 2-speed fan drive, identified by feature code 12tht. The fasteners that...
International is recalling 34,993 my 2006-2008 school and transit buses and heavy duty trucks/tractors manufactured between june 1, 2006 and june 28, 2007, equipped with international dt466 or dt570 engines. The base plate of the engine oil cooler may crack...
On certain 6x4 or 6x6 trucks with air brakes or tractors with air brakes and equipped with bendix sr-7 spring brake modulating valves, the internal rubber check valve may leak causing a delay in the application of the spring brakes to park the vehicle after...
On certain trucks, the rear-rear axle brake slack adjusters may contact the rear axle housing preventing the brakes from being fully applied possibly causing extended stopping distances.
On certain trucks, one or both rear axle housings may contain thinner material than what is necessary for normal vehicle operation. Over time, this thinner material may result in a fatigue failure of the rear axle housing, possibly in the location of the...
On certain trucks equipped with chalmers rear suspensions, the adjustable torque rod end castings may be brittle. A brittle rod end casting may fracture without warning, causing the vehicles' rear axles to become misaligned.
On certain trucks equipped with sr-7 bendix brake valves, the check valve inside the valve cavity may not properly set, causing internal air leakage. If the check valve does not properly seat, the resulting leakage can cause a delay in the application of the...
On certain vehicles equipped with air operated fifth wheel slides and an msva 7-pack accessory controller, the 7-pack can allow water to contaminate its circuit board. This could result in inadvertent operation of the fifth wheel slide control.
On certain trucks, the bolts that mount the front of the cab to the mounting brackets were not properly torqued at the manufacturing plant.
Questions about the International 7500
Which International 7500 years have the fewest complaints?
How many recalls does the International 7500 have?
NHTSA lists 17 recalls across all International 7500 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data