Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

2000 Kawasaki KL650A14 Engine problems

Owners have filed 2 complaints about the 2000 Kawasaki KL650A14's engine & cooling with NHTSA - 100% of all its complaints, most recently on August 14, 2017. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
2
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Engine complaints

Engine & cooling

The engine balancer locking mechanism failed early on this engine - and on many of the klr650s from 1987 - 2007 using the model a designation. Mine was an a14 in the '86-'07 klr65's chain-driven balancer subsystem, two related parts are prone to failure: 1) the balancer idler lever (kawasaki part no. 13168-1436); And, 2) the idler shaft spring (kawasaki part no. 92144-1860). The two parts serve to maintain tension on the balancer chain. The oem idler shaft lever is a welded piece. Because it is improperly...

Read the full complaint

supported, the lever can be easily crimped, dented, or warped. Eventually, the damage can become so severe the lever ???Hangs??ť On the crimped part and fails to allow adjustment to the chain tension. In some cases the weld fails or the collar breaks so the lever is no longer attached to the idler shaft and pieces fall into the oil sump below. Tension on the system is now held entirely by the idler shaft spring. Under tremendous stress, the spring can fail either by breakage or being stretched beyond limits. In any of the above scenarios, when tension is lost the chain is capable of jumping a sprocket, jamming and locking the engine. It is also possible for the broken pieces to find their way into the oil pump (assuming the protective screen is missing) and cause engine failure at speed.

Filed Incident EngineNHTSA 11015272
Engine & cooling

My 2000 kawasaki klr650 has an issue with the counter balancer adjustment system that has been documented many times by other owners. In 2002 I opened the side case up and the balancer adjustment spring was broken. The spring was broken. I replaced the spring and also the lever with an aftermarket parts. Once the lever and/or the spring breaks the system will not adjust tension on the balancer chain and as likely will cause the adjustment to loosen rather than tighten. A very loose chain can derail and possibly lock up the engine during operation and at speed. This is a very dangerous situation with possible injury. *Jb

Filed Incident Engine and engine coolingNHTSA 10185131

Had a engine problem with your 2000 KL650A14? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience