Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Suspension

2005 Kenworth T2000 Suspension problems

No owner has filed a complaint about the 2005 Kenworth T2000's suspension with NHTSA. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.

Complaints
0
Recalls
3
Crashes
0
Fires
0
Injuries
0
Deaths
0

Suspension recalls for the 2005 Kenworth T2000

Suspension

08V485000130 vehicles affected

The problem
Paccar is recalling 130 my 2004-2009 t2000, t800, t600, w900 and t660 kenworth trucks built with an ag400 rear suspension, long stroke brake chambers, and wide base tires (super singles). These vehicles may develop an increase in lateral and vertical axle movement. This movement may cause part or parts of the brake assembly (brake cam tube support, brake chamber bracket, brake chamber, brake spider) to develop fatigue cracks, possibly resulting in the failure of the part or parts within the brake assembly.
The risk
A failure may reduce vehicle brake performance, increasing the risk of a crash.
The fix
Dealers will install the cam tube support brackets on all of the rear axle wheel ends. Inspect the rear axle brake assembly and replace it if cracked. The recall is expected to begin during november 2008. Owners may contact kenworth at 1-425-828-5440.

Suspension: rear

05V237000850 vehicles affected

The problem
On certain trucks and tractors equipped with airglide high-articulation rear suspensions, the c65-1006 sway bar used in this rear suspension may experience a reduction in fatigue life due to either a manufacturing process or a high induced stress during an extreme suspension articulation event.
The risk
Both of these conditions can lead to a failure of the sway bar which could cause the rear axle to come loose, increasing the risk of a crash.
The fix
The inspection and repair of these vehicles will depend on the type of vehicle (tractor or truck) and the intended service application. This inspection and repair criteria will be forthcoming. The recall began on june 30, 2005. Owners may contact kenworth at 1-425-828-5440.

Suspension

05V1890001,026 vehicles affected

The problem
On certain heavy duty class 8 trucks, the suspension has transverse beam castings that may fracture under normal loads. If a casting breaks when the vehicle is traveling on a roadway there is the potential for pieces of the casting to become projectiles and the suspension's transverse beam may drop down low enough to contact the road surface.
The risk
This could cause sparks that could potentially ignite and cause a fire.
The fix
Dealers will inspect and replace the defective transverse beam assemblies free of charge. The recall began on june 10, 2005, with letters being mailed to peterbilt owners; and on june 17, 2005, for kenworth owners. Owners may contact peterbilt at 940-591-4201 or kenworth at 425-828-5440.

Suspension complaints

No complaints about this area yet.

Kenworth T2000 suspension complaints by year

T2000 suspension problems, every year

Had a suspension problem with your 2005 T2000? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience