Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Acceleration & cruise control

2014 Kenworth T680 Acceleration problems

Owners have filed 1 complaint about the 2014 Kenworth T680's acceleration & cruise control with NHTSA - 10% of all its complaints, most recently on March 3, 2017. Unintended acceleration, surging, throttle problems and cruise or adaptive cruise faults.

Complaints
1
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Acceleration complaints

Transmission & drivetrainAcceleration & cruise controlBrakes

This truck is a misbuild from the factory on the brake system plumbing. I am concerned other units may also have been built wrong. The traction control locks up the front drive axle brakes when the truck spins a tire and kills the engine causing damage to the differential and loss of control of the vehicle. I have identified that the service brake air lines are hooked up incorrectly from the factory, not going through the abs modulator valve. This allows full brake application to the front drive axle...

Read the full complaint

service brakes when the traction control engages. It also makes the truck so the abs brake function is not able to function. We have blown apart 2 front differential units rendering the truck unable to move. Often when this happens it kills the engine so now you also loose power steering control. This is an extremely unsafe and illegal build on this truck. Abs is required by dot law and this truck does not have full abs function. I have contacted bendix, the maker of the abs and traction control they have confirmed the way this is hooked up will cause the brakes to lock up. I have attached pictures of the valve, you will notice that one air line comes from the module which goes to the rear brake. The other air line comes directly out of the atr6 brake valve, this line goes directly to the front driver service brake. It should also be run through the modulator valve for proper function. This has happened at all speeds in icy situations. It has happened on mountain passes and leaves the driver with no control. Urgent action required please. This has been going on for 3 years, we have spent many hours trying to figure out why this trucks brakes lock up. We have the kenworth dealer also look at it and they did not find the issue either. Currently this truck is at the kenworth dealer with a request for them to repair it and reimburse us our costs.

Filed Incident Power train · Vehicle speed control · Service brakesNHTSA 10958529

Kenworth T680 acceleration complaints by year

T680 acceleration problems, every year

Had a acceleration problem with your 2014 T680? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience