Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

2022 Kenworth T680 Engine problems

Owners have filed 1 complaint about the 2022 Kenworth T680's engine & cooling with NHTSA - 50% of all its complaints, most recently on January 5, 2026. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
1
Recalls
1
Crashes
0
Fires
0
Injuries
0
Deaths
0

Engine recalls for the 2022 Kenworth T680

Engine

21V080000132 vehicles affected

The problem
PACCAR Incorporated (PACCAR) is recalling certain 2021-2022 Kenworth T680, T880, W990, T800, W900 and Peterbilt 579, 567, 389, 367 vehicles equipped with a Cummins X15 engine. The capscrews that attach the flywheel to the crankshaft may have been improperly torqued, allowing the flywheel to detach.
The risk
A detached flywheel can cause loss of drive power, increasing the risk of a crash. Additionally, driveline pieces may be ejected from the engine compartment, increasing the risk of injury.
The fix
PACCAR will notify owners, and dealers will properly torque the capscrews and the engine will also be inspected for damage and, if necessary, repaired, free of charge. The recall began on March 29, 2021. Owners may contact PACCAR customer service at 1-425-828-5888 (Kenworth) or 1-940-591-4220 (Peterbilt). PACCAR's numbers for this recall are 21KWA and 21PBB.

Engine complaints

Engine & cooling

The contact owns a 2022 Kenworth T680. The contact stated that while driving approximately 70 MPH, the Engine Control Module (ECM) or the Engine Control Unit (ECU), started to lose power, eventually displaying a black screen. When attempting to drive and accelerate up to 50 MPH, the vehicle suddenly lost power. The contact stated that a timer displayed a countdown from one hour, and once the timer reached 0 minutes, the vehicle automatically shut off. The contact would coast to the side of the road and wait before...

Read the full complaint

restarting the vehicle to continue driving. The vehicle was taken to the dealer, who diagnosed that the ECM/ECU and oxygen sensors both failed and needed to be replaced. The ECM/ECU was repaired. The manufacturer was not informed of the failure. The failure mileage was 450.

Filed Incident Engine and engine coolingNHTSA 11708828

Kenworth T680 engine complaints by year

T680 engine problems, every year

Had a engine problem with your 2022 T680? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience