The anti-lock brake/traction control computer logic program was incomplete, resulting in the trapping of brake fluid pressure in the rear brake lines. Failure to release the rear brake line pressure causes a condition where brake pedal application results in...
Brakes
Lexus SC400 Brake problems by year
8 complaints filed with NHTSA about the Lexus SC400's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
Latest SC400 brake complaints
Tl*the contact owns a 1992 lexus sc400. While driving 35 mph, the hydraulic braking system trapped the brake fluid pressure and the rear brake line. As a result, the rear brakes began to drag and only the front brakes could be used. The dealer stated that the vin was not included in nhtsa campaign id number 92v046000 (service brakes, hydraulic:foundation components). The purchase date was unknown. The current mileage was 191,000 and failure mileage was 185,000.
Tl*the contact owns a 1992 lexus sc400. While driving 40 mph the traction control light remained illuminated. When the brake pedal was depressed there was a popping noise in the rear brakes. The road conditions were not a factor. The current and failure mileage were 230,000. *Ak the rear brakes would lock up when coming to a full. Updated 05/04/07*tr
Tl* the contact owns a 1993 lexus sc400. The traction control logic program failed and caused loss of stopping power. The contact stated the rear brakes were dragging. The current and failure mileage was 112,000. The dealer has advised the contact that the traction control computer needed to be replaced.
While driving,the rear of the vehicle hydroplaned with out warning. The consumer applied the brakes, but the pedal went to the floor. The driver was unable to maintain control of the vehicle and crashed into a ditch. The air bags did not deploy. The consumer and passenger was not injured. Please fill in additional information. *Jb. *Ak
The vehicle has had an on going problem with the traction control lights coming on and off. The problem has worsened over time and now the light remains on. There was a hydraulic brakes recall 92v046000 on this issue but the manufacture is indicating that the vin number isn't included. The consumer had the vin number run by alldata and a mechanic who indicated that the vin number was included. *Nm the all data description of the recall indicated that the rear brake pads would be stressed because of the malfunctioning traction control and abs system. The rear pads were replaced at 15000 miles. *Nm
Traction control failed. Consumer was concerned that abs brakes malfunctioned. A recall was issued. However, this vehicle was not included in the recall due to vin. *Ak
The brake pedal is positioned too close to the accelerator pedal. When applying the brake pedal, the accelerator pedal is also pressed, causing the vehicle not to stop. This has almost caused several collisions. The dealer has been contacted. *Ak
The brake calipers were sticking, causing a loud rubbing noise when the brakes are applied. Also when the brakes are applied the car pulls to the left. Dlr replaced rear pads and rotors. *Ak
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data