Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Lights

2009 Mazda CX-7 Lighting problems

Owners have filed 4 complaints about the 2009 Mazda CX-7's lights with NHTSA - 6% of all its complaints, most recently on December 22, 2015. Headlights, tail lights, brake lights, turn signals and interior lighting failures.

Complaints
4
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Lighting complaints

Lights

Both rear tail lights looked cloudy and the red color of the rear lights appeared white. I removed the light bulbs, thinking that maybe they had burned out. I noticed the light bulbs had melted through the internal red plastic lens of the tail light assembly and left a hole about the size of a quarter that allows the white light from the bulb to shine through. The melted plastic was all over the bulbs and there was a burnt plastic odor. The 7743 bulbs were both original to the car from mazda when I purchased the...

Read the full complaint

car new in july 2009. I notified mazda corporate and they had me take it to my dealer. They inspected the lights and said mazda was willing to offer a $500 goodwill to replace the tail light assembly. That will not cover the cost of $1226.77 Without labor to have the dealer replace the tail lights. They gave me a case ref# 1-174187018. There should be a recall for this issue and the consumer should not have to pay to get the lights replaced. This is a problem when the light bulbs burn through the plastic tail light assembly. This is a design flaw.

Filed Incident Exterior lightingNHTSA 10811706
LightsBody, doors & structure

Mazda cx7 2009 rear lens, light bulb melts internal red plastic, issue all 2007 to 2009 cx7. A safety issue rear stop light and driving light will not reflect the red color. *Tr

Filed Incident Exterior lighting · StructureNHTSA 10482143
Lights

Normal low light beam is cut off by the design of the surrounding hood area of the vehicle. This design factor cuts off the projected beam and limits the distance of clear visibility. The problem was described during dealer service and was told, that is how it was designed. No adjustment of light is possible in order to improve the night low beam visibility. The high beam is not affected & seems unobstructed. For daylight running lights it would be acceptable but for limiting night light projection by design is...

Read the full complaint

questionable. Is there a requirement for low beam minimum projection? If so, the issue needs studied & corrected. This presents a safety concern since distance visible on low beam is decreased & obstructed. Any explanation or help in this matter is appreciated. *Tr

Filed Incident Exterior lightingNHTSA 10433684
Lights

Excessive condensation in front headlights. At 3:00pm afternoon condensation is still present in headlight (85 degrees f). This humidity has to go somewhere and there are electric components in the back and near the headlights with warnings. Mazda refuses to correct or change headlights (mazda bulletin 09-016/09). *Tr

Filed Incident Exterior lightingNHTSA 10303650

Mazda CX-7 lighting complaints by year

CX-7 lighting problems, every year

Had a lighting problem with your 2009 CX-7? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience