Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Suspension

2007 Mazda MAZDA3 Suspension problems

Owners have filed 14 complaints about the 2007 Mazda MAZDA3's suspension with NHTSA - 6% of all its complaints, most recently on March 3, 2021. They describe 1 crash, 0 fires and 0 injuries. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.

Complaints
14
Recalls
0
Crashes
1
Fires
0
Injuries
0
Deaths
0

Suspension complaints

SteeringSuspensionWheels & tires

I recently purchased this vehicle used with salvage title on february 6, 2021. I took it to be inspected and I needed both belts replaced, they had to tighten back down my struts in front, my power steering was acting funny and making noise and my intermediate speed shaft sensor is going bad because the check engine light keeps coming back on for the same code. There was damage to the vehicle but they didn't tell me that it was serious damage. When driving barely turning the wheel the car makes a whining noise, the...

Read the full complaint

vehicle still sways a little to the left and right but the alignment was just done yesterday. Before I was able to pay for the alignment etc new tires and mount and balance my car and steering wheel were both shaking really badly and jerking all over the place.

Filed Incident Steering · Suspension · WheelsNHTSA 11398986
SuspensionWheels & tires

I have purchased multiple sets of new tires for this car because I am having the same issue that all the complaints say about the tires wearing on the inside walls. I have had a few professionals look to find what is causing this and none of them can find anything. I now experience shaking of my car while driving over 40 mph. My tire pressure light comes on and off whenever. Just in the past year I have purchased 6 new tires. I am afraid I will die in an accident if driving on the freeway. Please help!! My tire pressure light comes on, the car shakes, the inside of the front tires and back driver side wear down to the threads on the inside.

Filed Incident Suspension · Wheels · Unknown or otherNHTSA 11104791
SuspensionAirbagsFuel system

Fuel propulsion system cracked at coupling under the rear passenger seat spewing massive amounts of fuel into the cab soaking the rear seat pad fire risk present with electric plug there struts are unstable and noisy vvt makes noise when started, grinding in front hubs. Vehicle has some of these problems driving and parked. Airbags system non active. Other issues unknown but possible 35.

Filed Incident Suspension · Air bags · Fuel / propulsion systemNHTSA 10937314
SuspensionBrakesBody, doors & structureEngine & cooling

Tl* the contact owns a 2007 mazda 3. The contact stated that the vehicle failed to start when the fuel tank was filled. The dealer performed a diagnostic, which located a failure code at the purge valve. The valve was replaced, but the vehicle experienced additional failures. The front end vibrated and the engine stalled while driving 65 mph. The dealer performed diagnostic testing, which indicated that the engine mount was worn, the struts leaked, and the evap system failed. However, the valves were replaced. The...

Read the full complaint

engine mount, struts, and evaporating system were not replaced. The rotor also wore prematurely and could not be resurfaced. The front bumper clips failed due to defective plastic. The clips were replaced several times; however, the failure was not corrected. The manufacturer stated that the vehicle was not included in nhtsa campaign number: 07v295000 (engine and engine cooling). The failure mileage was 50,000.

Filed Incident Suspension · Service brakes, hydraulic · Structure · EngineNHTSA 10663553
SteeringSuspension

Tl* the contact owns a 2007 mazda3. While driving at an unknown speed, a loud rattling noise emitted from the rear of the vehicle. The vehicle was taken to an independent mechanic. The technician diagnosed that the rear stabilizer control link and ball joint fractured. The rear stabilizer brushing ring and the control link were replaced. In addition, the contact stated that the steering wheel locked while attempting to turn left. The contact was able to complete the turn but the vehicle stalled in the middle of the...

Read the full complaint

intersection. The contact restarted the engine and the vehicle resumed normal operation. The manufacturer stated that the vehicle was not included in nhtsa campaign number: 10v374000 (steering). The steering failure was not repaired. The approximate failure mileage was 85,000.

Filed Incident Steering · SuspensionNHTSA 10649785
Suspension

Clunking noise in trunk when going over railroad tracks/bumps, etc.; Took to mazda dealer. Passenger side rear stabilizer/swaybar bolt loose and pin bent. Known issue for a lot of 2007 mazdas. New bushings and bolts put in/tightened. Clunking noise gone. *Js

Filed Incident SuspensionNHTSA 10585208
SuspensionEngine & coolingElectrical systemFuel system

The check engine light came on. Cause ,after running code check,p2004. Runner control vale stuck. Replace solenoid. Front struts gone. *Tr

Filed Incident Suspension · Engine and engine cooling · Electrical system · Fuel / propulsion systemNHTSA 10572685
Suspension

Tl* the contact owns a 2007 mazda 3. The contact stated that the axle was rubbing against a piece metal in the engine causing it to malfunction. The vehicle was taken to the dealer who diagnosed that the axle needed to be replaced. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure and current mileage was 98,000.

Filed Incident SuspensionNHTSA 10474144
Suspension

Hard knocking noise occurs when attempting to turn the vehicle. Dealership has made multiple failed repair attempts to fix the vehicle (a motor mount, rear sway bar bushings, front strut bar bushings, front sway bar, stabilizer plate, control rod, upper strut bearing and mount) as drivability and handling issues have become worse. The dealership recently determined that the vehicle has a bent lower a-arm which is of no fault to external influence. As the vehicle is now out of warranty the manufacturer is...

Read the full complaint

refusing to fix the vehicle. The defect in the lower a-arm is as a result of a failure in material. The front end geometry is now severely out phase by 30 degrees (per the dealership) which can cause undue stress to the lower ball joint causing premature breakage. The result of the lower a-arm separating from the spindle can cause an accident. The vehicle needs a new a-arm and possibly other related components. Tw*

Filed Incident SuspensionNHTSA 10303064
Suspension

2007 Mazda 3 excessive premature tire wear. At 30,000 miles I see that the front tires are worn to the point of steel band visible and sticking out. Inspection at 25,000 miles dealer said there was wear but not critical. The tread is separating and I am replacing tires immediately. I have learned that front suspension has excessive negative camber causing this. *Tr

Filed Incident SuspensionNHTSA 10286263
Suspension

I bought a mazda 3 2007 on april 2007. The car began to make a noise on july of that year. I reported this to the after-service dealer, where we buy the car, but they couldn't found what makes the noise. The had told me that they changed the damper (shock-absorber) at least 3 times, but each time, the noise continue there, it sounds like a 'clap' each time I pass through a brim, or just driving. They said it was the suspension, the dampers, but the noise is still there. The car stayed several days and several...

Read the full complaint

times at the after-service of the car dealer, and they wouldn't be able to repair it, so we decided to prove a new car-dealer after-service, and we took the car there several time too. This last time, tired of their inefficiency, lack of compromise and non service customer, we decided to write o mazda mexico, and they have the car on the last car-dealer where we took the car the last time, it's going to be the third time during march, that my car is there, they couldn't fix it, and today they said that they are still reviewing it, and they don't have a clue about that could be happening. We don't know what to do, so we are trying to express this issue in all the forums that we have available. I hope you can help on this, because I read that you send the failures to several countries, when you find something. *Tr

Filed Incident SuspensionNHTSA 10263672
Suspension

I have had the dealer replace front end parts 2 times. First the front hub bearings. Then they had to replace the intermediate shaft also part of the front end. The car is 2007 with 37,000 miles. I have other cars with over 100,000 miles and never had to replace any of these parts. *Tr

Filed Incident SuspensionNHTSA 10260602
Suspension

Found tire wear on inside of both rear tires. Took to dealer to align rear end. Service dept stated that there is no way to align rear wheels. However I could buy a kit from the internet that when installed would allow the rear wheels to be aligned. Cost to me would be $500.00. Called mazda to complain and they say it is ok. However I believe that running your car on the inside tread of your tires is a safety hazard. Tires are designed to run on the flat bottom and not on the inside edge. Mazda said the rear end...

Read the full complaint

was designed that way for stability. I know of no other car made today that does not have the ability to align the rear end so that the tires will run flat on the road. Having talked to mazda I am sure they will not correct the manufacture defect unless the government gets involved. And I hope you do before there is an accident from a blown tire. *Tr

Filed Incident SuspensionNHTSA 10249901
SteeringSuspensionWheels & tiresCrash

2007 Mazda323 lost control and hit a barrier wall. *Kb the police report stated the vehicle had a flat left front tire and steering mechanism damage that caused the consumer to lose control of the vehicle

Filed Incident Steering · Suspension · TiresNHTSA 10229538

Mazda MAZDA3 suspension complaints by year

MAZDA3 suspension problems, every year

Had a suspension problem with your 2007 MAZDA3? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience