Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

2014 Mazda MAZDA3 Engine problems

Owners have filed 14 complaints about the 2014 Mazda MAZDA3's engine & cooling with NHTSA - 10% of all its complaints, most recently on September 26, 2025. They describe 3 crashes, 0 fires and 1 injury. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
14
Recalls
0
Crashes
3
Fires
0
Injuries
1
Deaths
0

Engine complaints

Engine & coolingElectrical system

Odometer Fraud. The contact purchased a 2014 Mazda Mazda3. The contact stated that the vehicle was making an abnormal growling sound. The check engine warning light was illuminated. The contact discovered a mileage discrepancy after the purchase. The vehicle was a private sale. At the time of purchase, the vehicle mileage was 140,000. The vehicle was taken to the local dealer, where it was diagnosed and determined that the motor mounts needed to be replaced. It was later discovered that the Title mileage was 197,687.

Filed Incident Engine · Electrical systemNHTSA 11689873
Electrical systemEngine & cooling

The contact owns a 2014 Mazda Mazda3. The contact stated that while driving up an incline at an undisclosed speed, the vehicle temporarily lost motive power, and the contact became aware that the vehicle had failed to shift out of first gear. The contact stated that the vehicle returned to normal functionality; however, the failure recurred several times while driving. Additionally, the contact stated that the instrument panel was functioning erratically, and the instrument panel lights frequently remained...

Read the full complaint

illuminated after turning off the vehicle. The check engine warning light was illuminated. The vehicle was taken to the dealer, where the failure could not be duplicated. The vehicle was then taken to an independent mechanic, where it was diagnosed that the head gasket seal had failed, which resulted in an oil leak. The vehicle was repaired, but the failure reoccurred. The vehicle was taken back to an independent mechanic, where it was diagnosed with electrical system failure. The vehicle was not repaired. The contact related the failure to NHTSA Campaign Number: 14V173000(Electrical System); however, the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was 62,000.

Filed Incident Electrical system · Engine and engine coolingNHTSA 11622452
Acceleration & cruise controlEngine & cooling

While accelerating onto a highway, my engine overheating light flashed then stayed on and my acceleration suddenly throttled back and my car started slowing down. I was able to pull over on the shoulder, but there was a close call with a semi bearing down. I had my car towed to a repair shop, where they told me the water jacket had cracked and the overheating caused a blown head gasket. This was repaired and tested. A week later, I got the car up to highway speeds and the engine overheating light flashed again....

Read the full complaint

When I stopped and looked at the engine, there was foamy tan coolant all over the place. Towed it back again and was told the weld had failed. But in trying to find a used cylinder to replace mine, the shop told me that all of their sources said they had no used ones available because the same crack happened on those as well.

Filed Incident Vehicle speed control · EngineNHTSA 11583891
SteeringEngine & coolingFuel system

Safety recall-electrical system:alternator/generator/regulator while driving on the highway, with my wife and daughter in the backseat I notice my battery light come on. After that every warning light on dashboard came on and the car began to slow down even when pressing my foot on the gas. The car even tried stoping and the steering locked up. We were successfully able to get it towed but I believed this happen because the dealers didn't fix the recall and instaed they bypassed it.

Filed Incident Steering · Engine · Fuel / propulsion systemNHTSA 11197077
Engine & cooling

While merging onto the highway and accelerating to highway speeds, the car lost power, the check engine light flashed, the traction light came on, and the check tire pressure came on all at the same time. The car also would not allow me to accelerate past 35-40 mph. After taking it to the dealership, it was determined that one of the four engine coils needed to be replaced. A month and half later, the same thing happened and another engine coil is needing replacement.

Filed Incident EngineNHTSA 11182908
Electrical systemEngine & cooling

Occasionally the engine will hesitate when accelerating, and then the check engine light, tpm, and stability control light will illuminate on the dash. Less frequently, the engine will occasionally stall while driving or while sitting at a stop light. The lights on the dashboard will remain illuminated, so I do not think it's a total loss of power.

Filed Incident Electrical system · EngineNHTSA 11164555
Electrical systemEngine & coolingCrash

On numerous occasions when I attempt to accelerate, the vehicle does not move forward and feels like it might be jammed. The car will then propel into gear causing my vehicle to skid out. The problem is intermittent. It appears to be happening the worst when making right hand turns. This has resulted in one accident, and two near fatal accidents.

Filed Incident Electrical system · EngineNHTSA 11030186
AirbagsAcceleration & cruise controlEngine & coolingCrash

My 2014 mazda 3 suddenly and unexpectedly accelerated and crashed into a parked truck. There was an eye-witness. Here is what happened: I was driving on a quiet, dead-in street accompanied by my husband. I turned left into the turn around area at the end of the street. As I was coming to a stop, with my foot on the brake, the car suddenly accelerated'going very fast, very quickly. It leapt over the curb, narrowly missed a tree and a fire hydrant, passed back over the street I had been on moments earlier, and...

Read the full complaint

crashed into a parked pick-up truck. The air-bags did not deploy. All of this happened in 2 to 3 seconds. We were not hurt. The eye witness was in his yard, which adjoins the turn-around area. After the accident, he came over and asked if I was ok. He asked me if I could turn my car off. The eye witness later told me he had seen the whole thing and that I never had control over the car. He said he told the police that he was watching me turn my car into the turnaround area and saw the car suddenly accelerate. He wanted me to know that there was a mechanical problem with my car. He told me that when he approached the car, it was revving and still trying to accelerate into the truck, even though my feet were nowhere near the pedals. That was why he asked if I could turn the car off. I remembered before turning the car off, that I could hear the whine of the engine as it sounds when it is at high rpms. The unexpected acceleration and the fact that the air-bags did not deploy are both serious safety concerns. The car was towed to the mazda dealership and the service department contacted mazda corporation who sent an engineer to check it out. They said they could not find a problem, but they put an event data recorder on the car to monitor it. They drove the car for a few days and nothing showed up. The dealer bought the car back.

Filed Incident Air bags · Vehicle speed control · EngineNHTSA 10888959
Engine & cooling

On february 23, 2015, I purchased a new 2014 mazda 3 s grand touring sedan with technical package, vin # [[redacted]]. The vehicle current mileage is 5,470. Since purchase, this car has had a stalling problem that is intermittent, unpredictable, and not reproducible on demand. Stalling means it does not respond to normal pressure on the accelerator, and literally coasts for a period of time. This time may vary from 2 to 10 seconds in a given instance. During this time the motor is running, there is no check...

Read the full complaint

engine light, and no codes are thrown. I have learned that quickly repeated pressing of the accelerator may help terminate the stalling. Common factors when stalling occurs seem to be when the engine is warm. The car has been driven for a while, and then the car has been parked for a short time, restarted, and moved back to traffic followed by a 90 degree right or left turn or car is driving normal route then stops for a stop light/stop sign or traffic, followed by a 90 degree right or left turn. In both these scenarios, there is a sharp turn. The car will just finish the turn and then stall when the accelerator pedal is pressed. It should go without saying that if this problem occurs at the wrong time, it could be a major safety hazard to life and property. Information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6). *Tr

Filed Incident EngineNHTSA 10761787
Engine & coolingCrash1 injury

In parking garage, turning into parking spot. Car engine revved up, and car accelerated into the guard rail, smashing the frontend of the vehicle and damaging the radiator. Driver did not put foot on the gas; car lunged forward on it's own. The airbag deployed, and driver had dark bruises on abdomen, left anterior thigh, and left side of neck d/t seat belt, and also had minor whiplash. Fortunately, no other cars or people were around when car accelerated. Also, had the car had more than just a few feet to run into something, the driver would have been injured worse. Prior to incident, car engine revved up for several seconds on its own twice while driving down the highway.

Filed Incident EngineNHTSA 10716911
Engine & cooling

My vehicle is equipped with standard "push-button" start which is used in conjunction with a radio controlled "key fob." While standing within a close proximity to the vehicle, the doors will unlock with the touch of a button on the door handle and the vehicle will start with the touch of the interior start button and the brake pedal pushed down. The same interior start button is pushed again to turn off the engine. On april 15, 2015, after parking the vehicle, I put the car in park, engaged the hand brake, and...

Read the full complaint

exitted the car, forgetting to push the interior start button to turn off the engine. I left the vicinity of the vehicle (about 100 yards away) and the car engine continued to run until I returned, 2 hours and 40 minutes later to turn the car off. My local mazda dealer said this was normal and there was no built-in safety mechanism to prevent the car engine from running while the "key fob" was no where near the car. Imagine the safety concerns associated with this? If the car were parked in a residential garage, the results would have been disasterous. Why doesn't the engine automatically cut off when the key fob is a certain distance from the vehicle? Why isn't the alert (a short series of beeps identical to other beeps the car makes when locked) distinctive and alarming? This is a serious, life-threatening situation associated with the use of keyless start engines that needs to be addressed. *Tr

Filed Incident EngineNHTSA 10706287
Transmission & drivetrainEngine & coolingFuel system

Harsh vibration in cabin similar to an engine misfire occurs randomly near idle or immediately after ignition. The dealership and manufacturer have been made aware of this concern and were unsuccessful in reproducing or isolating source of the vibration. Video documentation of the failure during its occurrence has been provided to both parties and has been forwarded to the senior regional engineer for analysis. Current owner has an open vehicle repurchase claim under lemon law with the manufacturer pending investigation of fault. *Tr

Filed Incident Power train · Engine · Fuel / propulsion systemNHTSA 10678354
Electrical systemEngine & coolingFuel system

My car is equipped with a push to start/stop (keyless) "feature". I pulled my car into the garage last night (with the radio off), pressed the start/stop button to stop the engine, and went inside. When I woke up this morning, the car was still running, all night inside my attached enclosed garage. Co meter measure non-zero ppm levels a few hours after shutting the car off. Other then the radio, there are no obvious non-audible indications that the engine is running / not running. Additional expectation would be the car should be smart enough to automatically shut itself off after idling for extended period of time. Mine was running in the garage for about 6.5 Hours. *Tr

Filed Incident Electrical system · Engine · Fuel / propulsion systemNHTSA 10658837
Electrical systemEngine & cooling

Tl* the contact owns a 2014 mazda mazda3. The contact stated that while coming to a stop, the vehicle lunged forward. The vehicle was taken to the dealer. The technician stated that the power module needed to be updated. The manufacturer was made aware of the failure. The failure mileage was 7,600 and the current mileage was 9,200. Updated 07/16/14 ma

Filed Incident Electrical system · EngineNHTSA 10586595

Mazda MAZDA3 engine complaints by year

MAZDA3 engine problems, every year

Had a engine problem with your 2014 MAZDA3? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience