- The problem
- Mazda North American Operations (Mazda) is recalling certain 2014-2018 Mazda3 and 2016-2021 CX-3 vehicles. The rearview camera image may not display properly by showing a flickering or distorted image.
- The risk
- A rearview camera that does not display properly can reduce the driver's rear view, increasing the risk of a crash or injury.
- The fix
- Dealers will inspect and replace the rearview camera, as necessary. In addition, dealers will install a wiring harness fastening seal. All repairs will be performed free of charge. Interim notification letters, notifying owners of the safety risk, were mailed September 13, 2023. Final owner letters for affected models and model years in the states of CT, MA, MD, NJ, NY, PA and VA were mailed August 14, 2024. The remaining owner notification letters will be mailed at a future date, anticipated on or before May 1, 2025. Owners may contact Mazda customer service at 1-800-222-5500, Option 6. Mazda's number for this recall is 6023G.
Driver assistance
2015 Mazda MAZDA3 Driver Assist problems
Owners have filed 13 complaints about the 2015 Mazda MAZDA3's driver assistance with NHTSA - 10% of all its complaints, most recently on April 15, 2026. Phantom braking, automatic emergency braking, lane keeping, blind spot and collision warnings.
- Complaints
- 13
- Recalls
- 1
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Driver Assist recalls for the 2015 Mazda MAZDA3
Driver Assist complaints
The contact owns a 2015 Mazda Mazda3. The contact stated that while driving at various speeds, or while attempting to reverse, the rear camera flashed on and off for approximately five minutes and then started working as intended. No warning light was illuminated. The vehicle was repaired under the NHTSA Campaign Number: 23V487000 (BACK OVER PREVENTION) by the owner of the vehicle; however, the fix failed to repair the vehicle. The contact stated that the failure had occurred after the recall repair was performed. The manufacturer was not notified of the failure. The failure mileage was 180,000.
The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (BACK OVER PREVENTION). However, the dealer refused to complete the recall repairs due to the vehicle having a Salvage Title. The contact stated that the rearview camera displayed a black screen while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, which prevented the driver from safely operating the vehicle. The manufacturer was made aware of the issue and referred the contact back to the dealer. The vehicle remained unrepaired. The failure mileage was approximately 86,000.
The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated that the back-up camera screen image was flickering and became distorted while reversing. The cause of the failure was not determined. The failure mileage was 60,000. VIN tool confirms parts not available.
The contact owns a 2015 Mazda Mazda3. The contact stated that occasionally while the vehicle was shifted into reverse, the review camera image would not display on the digital screen. In addition, the contact stated that the image looked distorted. The contact received a notification of 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was contacted, but the vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 85,000.
The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated while reversing, the rearview camera image failed to display. The local dealer was notified of the failure, but the vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure, but no assistance was provided. The failure mileage was approximately 82,000. VIN tool confirms parts not available.
The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while reversing, the rearview camera image was distorted, blank or failed to activate as needed. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 63,000. VIN tool confirms parts not available.
The contact owns a 2015 Mazda Mazda3. The contact stated that while reversing, the rear-view camera image was distorted, black, and failed to appear on the center display. The vehicle was taken to the local dealer, where an unknown software was reprogrammed; however, the failure persisted. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the...
Read the full complaint
manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 53,953. VIN tool confirms parts not available.
The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.
See attached document for complaint
The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2015 Mazda Mazda3. The contact received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The local dealer was notified of the issue and confirmed that the parts were not yet available. The manufacturer was not notified of the issue. The contact had not experienced a failure. VIN tool confirms part not available.
This in regards to NHTSA Recall #: 23V-487. It has been 173 days since this recall was announced and I have not received any correspondence from the manufacturer. The recall has been sitting with no remedy available for 6 months. I want to know when Mazda is expected to have a fix to this vehicle?
The contact owns a 2015 Mazda Mazda3. The contact stated that on numerous occasions after he opened and closed the trunk of the vehicle or while shifted into reverse, the rear-view camera image intermittently became distorted or blank. The contact then received notification of NHTSA Campaign Number: 23V487000 (Back Over Prevention) however, the part to do the recall repair was not yet available. An undisclosed dealer was contacted and stated to the contact that there was no such recall for the failure. The vehicle...
Read the full complaint
was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 67,000. VIN tool confirms parts not available.
Mazda MAZDA3 driver assist complaints by year
MAZDA3 driver assist problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data