Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

2003 Mazda Protege Engine problems

Owners have filed 40 complaints about the 2003 Mazda Protege's engine & cooling with NHTSA - 33% of all its complaints, most recently on March 16, 2020. They describe 1 crash, 1 fire and 1 injury. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
40
Recalls
0
Crashes
1
Fires
1
Injuries
1
Deaths
0

Engine complaints

Engine & cooling

For over two and a half yrs, my car has had a rough idling noise and the engine often hesitates and wants to turn off. On several occasions the engine has hesitated and shut the car off. Very recently a loud noise was coming from my engine. (You could hear a rattling noise) it sounded like a piece of metal rattling around in the engine. A year ago I took my car into the dealership because of a recall (recall 3005c) to get it checked out (this is what the letter from mazda asked me to do) my car was there only two...

Read the full complaint

hours and only looked at maybe about thirty minutes. I received an oil change and then they were to inspect it due to the recall. When I retrieved my car they gave me a certificate of correction, but informed me that nothing had been fixed and that they were only authorized to inspect. That if the part broke that I would be responsible for it even though it was a recall. Here I am one year later and I had my car looked at and it appears that two of the screws must have come loose due to the recall. (They were found in my exhaust) I got no help from the dealer. I found the recall instructions online from mazda to the dealer which instructs the dealer to replace the parts if they have not been replaced on any previous occasion (which was procedure b). And if it has been previously worked on they are to proceed with procedure a which instructs them to do an air compression inspection for internal damage and give a certificate of correction. They did the wrong procedure on my car and never actually did what needed to be replaced for my car to be legal and ok to drive. They are now avoiding my calls and not returning numerous e-mails or voice mails. I have been trying the dealer and mazda themselves. On tues .I received nothing but rude mocking from each place telling me that it was my problem. I have been trying everyday since and I have received no response. *Nm updated 2/23/2007 - intake manifold shutter and variable tumble control valves.*Nm

Filed Incident Engine and engine coolingNHTSA 10182740
Engine & cooling

Dt*: the contact stated the check engine light illuminated and the vehicle began hesitating. The vehicle was taken to an independent repair shop, who determined the computer gave a code stating a misfire in the first cylinder. The spark plug was taken off and the gap was closed. The air intake manifold was then taken off and the screw had come off, this closed the gap on the spark plug. The intake manifold was being replaced.

Filed Incident Engine and engine coolingNHTSA 10169256
Engine & cooling

My engine failed causing a sudden loss of power. I was able to pull over safely. My car required about $1,000 worth of repairs, using used parts, and I have permanent engine damage that will ultimately shorten the life of my engine. The root cause of the engine failure was due to loose screws located in the air intake manifold, that allowed for a baffle or butterfly valve to break and enter my engine. This very same problem was recalled by mazda for vehicles made from march of 2003 to july of 2003, mine was...

Read the full complaint

manufactured in february of 2003, and therefore was not recalled. I know of at least three other people who also have experienced this very same issue who have not been included in the recall. I have had two separate mazda service managers confirm this was the same problem as the recall - loose screws in air intake manifold. I need this investigated to determine if more cars should be recalled. *Jb

Filed Incident Engine and engine coolingNHTSA 10156580
Engine & cooling

Dt*: the contact stated while driving 30mph, there was a rattling noise from the engine compartment followed by the engine stalling. The vehicle was towed to an independent repair shop for inspection. The mechanic determined the screws used for mounting the intake manifold shutter valve broke and fell into the catalytic converter as well as the oil pan and pistons. The vehicle is scheduled for replacement of those screws. There is an emission recall, #3005c, regarding the exhaust system. The vehicle has the same problems as indicated in the recall; however it is not included in the recall due to the vin.

Filed Incident Engine and engine coolingNHTSA 10152748
Engine & cooling

One of the butterfly valves on the intake manifold fell off completely. This happened when the last of the two screws holding it on came loose and fell-off and was sucked into the engine. When the part was dismantled, there were only five of the original eight screws remaining. Only one of the four valves was completely connected when the unit was opened. I was driving normally down road and luckily this happened as I was parking my car. The event happened on 7/22/05 and the mazda dealership stated that...

Read the full complaint

although they have seen this occur before, there is no tsb or recall. I will need to replace this part of the manifold at a cost of more that $1000 dollars. On a mazda enthusist website that I frequent, at least ten other members have had the same problem with results varying from complete engine replacement, to the same supposed fix as I need. That information can be found at "www.Protege5.Com" the information is available in numerous places if you search there for "engine noise." *Jb

Filed Incident Engine and engine coolingNHTSA 10130640
Engine & cooling

Car stalled at red light, there was a loud knocking sound coming from the engine. After stalling t more times the car ran for another 3 minutes to ge me home for the evening. I then to it to my local mazda service center.*Ak

Filed Incident Engine and engine coolingNHTSA 10106112
Engine & coolingAcceleration & cruise control

The vehicle stalled on a continuous basis. The dealer was not able to duplicate the problem. There was also a noise in the front of the vehicle when the accelerator was applied. *Jb *sc

Filed Incident Engine and engine cooling · Vehicle speed controlNHTSA 10101528
Engine & cooling

Intermittently while driving at any speed vehicle stalled. This problem occurred six times since december of 2003. Dealer examined the vehicle, and could not find what the problem was. *Ak

Filed Incident Engine and engine coolingNHTSA 10081405
Engine & cooling

Engine has a very bad hesitation during exceleration, both from a standing and roilling start. Hesitation is bad enough to cause vehicle control problems durring the winter when driving on snow or during rainy conditions. Engine has already had the pcm module reprogramed as per outstanding service bulletin this fixed the engine missing under same circumstance but does not correct the hesitation. Dealer has looked at the vehicle 2 times and cannot find or fix the problem.

Filed Incident Engine and engine coolingNHTSA 10079009
BrakesEngine & coolingTransmission & drivetrain

Vehicle went backwards even after consumer put the gear into park.*Mr when the consumer got back in the car after leaving it running she noticed the engine oil pressure light was on, but thought nothing of it. The consumer was unable to stop the vehicle until it came to rest on its own after rolling in a ditch. The dealer was unable to duplicate the problem. *Jb

Filed Incident Service brakes, hydraulic · Engine and engine cooling · Power trainNHTSA 10079939
Engine & coolingCrash1 injury

While approaching a stop sign, the engine stalled causing the brakes and power steering not to work. I was unable to stop at the stop sign and ran into the embankment on the other side. This car has had a history of engine stalling while running. *La

Filed Incident Engine and engine coolingNHTSA 10074465
Engine & cooling

2003 Mazda protege 5 stalled when trying to accelarate from a stop light. This has happened twice already. Both times I was able to restart the car without problems. The dealer can't duplicate problem, and can't figure out what is causing the the problem.*Ak

Filed Incident Engine and engine coolingNHTSA 10064365
Engine & cooling

There's a knocking sound coming from the engine when started in the morning. *Ak

Filed Incident Engine and engine coolingNHTSA 10051554
Engine & cooling

When the vehicle was started a knocking noise was heard. The vehicle was taken to the dealer and was unable to determine the problem. *Jb

Filed Engine and engine coolingNHTSA 10020190
Engine & cooling

Engine rattles when accelerating after starting in the morning, and periodically rattles when accelerating after stopping when warmed up.

Filed Incident Engine and engine coolingNHTSA 10003151

Mazda Protege engine complaints by year

Protege engine problems, every year

Had a engine problem with your 2003 Protege? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience