Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Equipment & accessories

Mitsubishi Lancer Evolution Equipment problems by year

6 complaints filed with NHTSA about the Mitsubishi Lancer Evolution's equipment & accessories. Trailer hitches, mobility equipment, accessories and aftermarket parts.

Equipment complaints by model year

YearEquipment complaintsCrashesInjuriesRecalls
20112000
20082000
20061000
20041000
20030001

Equipment recalls

Latest Lancer Evolution equipment complaints

2011 Mitsubishi Lancer EvolutionEquipment & accessoriesVisibility & wipers

Tl* the contact owns a 2011 mitsubishi lancer. The contact stated that there was a crack on the windshield. The contact also stated that when the air conditioner was turned on, it blew warm air after approximately five minutes. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was 62,000.

Filed Incident Equipment · Visibility / wiperNHTSA 10733982
2008 Mitsubishi Lancer EvolutionTransmission & drivetrainEquipment & accessoriesDriver assistance

When starting my 2008 mitsubishi lancer evolution gsr, I received a warning message on the cluster display showing a yellow-orange symbol that shows 4 wheels connected by axles and the middle-shaft, where the front two wheels are facing at an angle to the side. The error code read as c161e: dtc c161e: electric pump relay circuit system (stuck). This has become a very common issue with the 2008 mitsubishi lancer evolution. So common that when you search for the code c161e, you can find countless forum discussions on...

Read the full complaint

multiple websites commenting on the frequency of this issue. Including myself, a single discussion identifies at least 48 unique cars, 42 of which are the 2008 model year, where the acd pump failed, all of which having driven fewer than 75,000 miles and nearly 60% with less than 50,000 miles (http://www.Evoxforums.Com/forums/showthread.Php?T=58221&highlight=c161e&page=1). Several of these vehicles required multiple replacements of the same part. This problem affects the safety and effectiveness of the vehicle's all-wheel-drive system, likely including the vehicle's traction control and needs to be recalled immediately. *Tr

Filed Incident Power train · Equipment adaptive / mobility · Electronic stability control (ESC)NHTSA 10640971
2008 Mitsubishi Lancer EvolutionTransmission & drivetrainEquipment & accessoriesDriver assistance

Active yaw control (ayc) and active center differential (acd) pump failed. Not covered under power train warranty pump was corroded and could no longer produce enough pressure. Pump in located directly behind passenger rear wheel exposed to water, salt, and other road debris. *Tr

Filed Incident Power train · Equipment adaptive / mobility · Electronic stability control (ESC)NHTSA 10595963
2004 Mitsubishi Lancer EvolutionVisibility & wipersEquipment & accessories

I bought a 2004 lancer oz rally brand new, still drive it daily and I've always had this problem too. It was hard to turn to the heat and the knob broke off. I can't use the heat anymore because I can't get it to turn at all. I even tried using needle nose pliers (mine still has some of the white plastic part attached), which worked a few times but now I can't get it to turn at all. In 2006, when the knob broke off, I contacted the dealer where I bought the car from about the problem. They said it would cost...

Read the full complaint

at least $800 to repair. I asked why, it's just a knob? They told me they had to take my whole dash apart to fix it and it was mostly labor costs. I can't afford to pay this for a faulty mechanism. I also couldn't use my defroster this morning and really needed it. I had to pull over to wipe my windows... Not safe mitsubishi!!!! Please recall this now!!! *Tr

Filed Incident Visibility · EquipmentNHTSA 10371130
2006 Mitsubishi Lancer EvolutionTransmission & drivetrainEquipment & accessories

I first noticed that my 2006 mitsubishi lancer evolution mr started to make a grinding/scrapping noise that seemed to be generating from the timing belt area. The car had approximately 30,000 miles on the odometer. It seemed to be a noise that was present at idle and upon cold start ups. I started to research this on various forums and internet, only to find that it was a common problem with a clear solution. There have been a few dealerships who have seemed to have resolved this issue but each fix seemed to vary...

Read the full complaint

within the timing belt area. The timing belt, sensor blade, tensioner, tensioner pulleys, etc. Have been known to cause this issue. The dealership that "fixed" my timing belt area grinding noise suggested that I replace the timing belt only, which I did. Only to have the problem resurface about 2500 miles later. I am unwilling to keep putting timing belts in my car to temporarily fix the problem. It scares me that the dealer keeps trying to go down this same road with the same conclusion. This car is my daily driver and about 90% of the times my kids are in this car with me. It would be terrible if my engine brakes down on me while driving around with my kids in the car. This can be a dangerous problem. I urge mitsubishi to strongly consider a recall for this. With such an amazing car I would hope mitsubishi would standby it and do the right thing! *Tr

Filed Incident Power train · EquipmentNHTSA 10368619

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience