Tl* the contact owns a 2001 nissan maxima equipped with a webasto hollandia 700 aftermarket sunroof. The contact was driving approximately 65 mph when he heard a loud, abnormal banging from the roof of the vehicle. The contact looked into the rear view mirror and noticed that the sun roof had fractured from the vehicle. The vehicle was not taken to have the failure diagnosed or repaired. The manufacturer was notified and the contact was told that his equipment was not included in the recall associated with nhtsa campaign id number: 10v421000 (visibility:sun roof assembly). The failure and current mileage was 88,000.
Equipment & accessories
2001 Nissan Maxima Equipment problems
Owners have filed 10 complaints about the 2001 Nissan Maxima's equipment & accessories with NHTSA - 6% of all its complaints, most recently on January 3, 2011. Trailer hitches, mobility equipment, accessories and aftermarket parts.
- Complaints
- 10
- Recalls
- 0
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Equipment complaints
In feb. 2008, My maxima 2001, with 55000 miles, stalled out at a stop light--it would start up again but then stalled out when I tried to go. It was towed to the dealership, and the iac valve and the ecm were both replaced for about $1700. Then, on oct. 20, 2008, 8 Months later with the mileage just under 60,000 miles, the same thing happened but it was preceded by a smell of burning rubber. It was towed to the dealership and I was told that the engine harness needed to be replaced ($2000 parts and labor) and the...
Read the full complaint
iac valve and the ecm again needed to replaced (another $1700). At first, the dealer said that the iac valve and ecm were covered under the new parts warranty, but then I was told that if it was the engine harness that was responsible for the failure of the iac valve and the ecm, they were not under warranty and I'd have to pay the total bill of $3700! I started a case file with nissan consumer affairs and was told by a regional specialist that nissan could do nothing for me since the parts were not under warranty. From the internet (and not from the dealership), I learned that the ecm is covered under the epa specified major emission control components warranty for 8 years/80,000 miles but nissan has declined my claim, saying that the iac valve caused the failure of the ecm that first time in feb. 2008, So the ecm is not covered by that warranty. There is no language in the epa warranty that states that as an exclusion and there is no language in nissan's own new parts warranty that states that as an exclusion (i.E., A new part is not covered by the warranty if its failure is caused by another non-warranted part). I have read online many, many similar complaints about the failure of these parts. This seems to be a very dangerous design defect with the potential to cause serious harm. Both times I narrowly avoided accidents. Nissan hasn't been willing to honor the warranties. I have yet to authorize the repairs and I am not sure what to do next. *Tr
My 2001 nissan pathfinder was purchased 3 years ago. A bose 6-cd player came installed in the vehicle. The 6-cd player stopped working, and displays an error message, "err 2". My vehicle is no longer under warranty. This problem was addressed with the nissan dealer (service department) in buena park california on december 21, at 6:40pm. I was informed that I could purchase a new cd player, however this would be quite costly. The nissan dealer further stated, when a customer whose vehicle is under warranty...
Read the full complaint
has this same problem, they do not repair the problem. The cd player is replaced with another. No repair shop will look at my system. Apparently, this problem is common with nissans. Other than purchasing a new cd player, there has to be some type of consumer repair shop. Nissan seems unconcerned with this type of problem. *Tr
I was driving on the interstate at 70 mph I went to down shift to 3rd but got 1st. I know this is not supposed to happen so I thought I was in 3rd gear. I let off the clutch and the car went from 70 mph to about 35 mph in 3 sec. I would have went through the windshield if not for the seat belt which work fine. Well this ordeal left my car with 1 or 2 blown cylinder heads, bent,valves water out tail pipe and its not due to the fact I didn't know how to drive a stick I have been driving them since I got out of school in 96..Can you tell me why this happened ? And if a is defect found will they repair my car? *Jb
Flapping noise coming from engine. Warning lights came on and vehicle loss power. Belts came apart going approximated 65 mph. Towed into dealership. Found belts missing from pulleys. Dealership installed drive belts and performs several recall services related to 03v455000 & 03v4777000. Engine light stays on. Battery discharges overnight several times. Erratic idle/stalls over time. August 2004 car stalls on freeway driving 65 mph. Car towed to repair shop that reports loss of spark on cyl 2, but fails to find problem. Towed to dealership who finds ecm failure. Requires 800.00 To fix. *Jb
I believe the right front strut I purchased for my 2001 nissan maxima is being incorrectly manufactured by kyb america, llc (subsidiary of kayaba industry companies). Proper installation of the abs line and the main brake line can not be achieved due to reasons documented in the excerpt of correspondence between myself to kyb america below. This month I have begun to notice some dangerous wearing on my brake line caused by improper manufacturing/installation. Kyb has only responded to my initial form filled...
Read the full complaint
out online with a generic auto responder email listing their contact information. The picture I referencebelow is available at the web address: http://www.Astuteinnovations.Com/strut.Htm the following is from an email I sent on april 15, 2004: "the reasons I think it may be manufactured wrong are shown on the picture, here is the main points. "I can't get the retainer clip for the brake line onto the kyb strut because of a bent lip. The bent lip in the picture is referring to the overall shape of the metal not the rounded top edge. "The rear abs sensor mount is the same as the nissan strut but the front sensor mount has a mount that opens facing down. This forces the abs sensor to take a sharp turn down in order to get to the opening of the kyb mount. I think I mentioned that my abs light came on but it is now off. This is a safety concern for me even though I'm fairly sure the abs system is fine. I also had to zip tie the brake line to the kyb mount because of the retainer clip issue & this also scares me because if the zip ties fail then my break line would end up dangling loosely and might get damaged as a result (i check the zip ties every time before I drive the vehicle)." Thank you chuck christiansen. *Ak
I am one of many who have had the oil dipstick break off in their 2001 nissan sentra. I was able to remove mine using super glue and a dowel rod saving me hundreds of dollars. However, anyone is not aware of this will have to do what nissan suggests and that is to require people to use their services for a defective part of nisssan's design. I have been exposed to other plastic failures where under high temperature and pressure (an o-ring on the groove in the plastic) causes plastic to become brittle.*Ak
Numerous problems with vehicle's front rotors. *Mr this was the consumer's third set of front rotors and the latest set warped. The vehicle vibrated and pulled to the side when the consumer applied the brakes. The vehicle had been in the shop for brake work six times. The consumer owned many nissan's and stated that this was the first major problem ever experienced. There was still a slight vibration coming from the rear brakes, moaning/groaning sounds from the front right, creaking/popping when turning,...
Read the full complaint
when setting the cruise at 70 mph(cruise control cable was not properly adjusted), it felt as if the gas was applied, and bumps could be felt in the road through the steering wheel. *Scc. It took a long time for the air condition to cool the vehicle. *Jb
Front rotors have failed three times within 60,000 and nissan says that this is due to driving habits, i.E., Rotors get hot and then fail. Reference # 4029350 perjudy ext. 3773. Dealer has replaced rotors each time and I find no fault with dealer with the exception that they do not know what is causing this; other than the driving habits as expressed by the nissan rep. Judy. This condition is dangerous and causes the car to be bounce with loss of control a very real possiblity. For the second replacement, a...
Read the full complaint
statement in the followup to nissan was made that this problem was serious. This vehicle is not driven in the city or under city conditions where brake pressure occurs often; the miles are highway miles as we live in the country; we have a paved road to the house so road conditions are not a factor. The response by nissan is a "run-around" with the same verbage and reflects the nissan rep's atttempt to defuse any complaint. In looking at the office of defects investigations, there are several references to rotor failure: nissan said that they were unaware of any problems. In fact, the nissan dealer (ancira-san antonio, tx) indicated that I should contact nissan concerning this situation. I did and am not satisfied the least with their runaround as I believe this to be a serious and dangerous condition of at least the vehicle which we have.
Every 3,000-6,000 miles brake rotors become warped, causing a shaking in the steering while while braking. Nissan, acknowledging a problem with their part, would repair rotors or replace them, but it was only a temporary repair, as they would become warped again after a few thousand miles. Nissan has now refused to repair/replace new rotors that warped only after few thousand miles.
Nissan Maxima equipment complaints by year
Maxima equipment problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data