- The problem
- Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.
- The risk
- If this occurs, the pinion shaft can be forced upward during left turns and back down as the steering wheel is moved back and to the right. If the pinion shaft moves further, the driver will need to exert more effort to turn the steering wheel, similar to a vehicle without power assisted steering. If the pinion shaft moves even further, the driver will require much higher effort to turn left and may not be able to turn the wheel as much as intended. With the maximum pinion shaft movement, which requires internal gear component damage, the driver can encounter high resistance to turning left, followed by unintended power assist to the right. In any of these conditions, a crash could occur.
- The fix
- Dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick at 1-866-608-8080; chevrolet at 1-800-630-2438; oldsmobile at 1-800-630-6537; or pontiac at 1-800-620-7668.
Steering
1997 Oldsmobile Cutlass Steering problems
Owners have filed 33 complaints about the 1997 Oldsmobile Cutlass's steering with NHTSA - 24% of all its complaints, most recently on January 8, 2014. They describe 4 crashes, 0 fires and 2 injuries. Loss of power steering, stiff or loose steering, wandering, column and rack problems.
- Complaints
- 33
- Recalls
- 1
- Crashes
- 4
- Fires
- 0
- Injuries
- 2
- Deaths
- 0
Steering recalls for the 1997 Oldsmobile Cutlass
Steering complaints
Vechile recently started making groaning noise when steering and from power steering pump. Power steering pump was replace back in 2011. Took to goodyear and tech indicated pump was fine, problem point to the rack and pinion. *Tr
We bought the car in 2010 from a used car dealer. Upon 6 months of driving we noticed a steering problem that was hard to the left and just didn't seem right. The engine also had overheating and gasket problems so we had the engine replaced. Upon test driving the vehicle the mechanic was driving and the power steer had a complete failure and ran him towards oncoming traffic and then back another direction. Upon return to the shop he concluded the entire rack was broken and needed replaced. At the time in 2011...
Read the full complaint
we were not aware that gm recalled the lower pinion bearing in the power steering rack in 2003 so we had paid for a new rack and pinion to be replaced. There evidently was leftover debris in the rack in pinion from the original part failure and now has ruined the 2nd rack and pinion. My complaint is that in 2004 our car is listed as a car that was affected and had been serviced in 2004 in georgia. The only thing replaced was a tiny snap ring, in which the detailed repair pdf states in multiple incidences that it is up to the mechanic to decide how much failure has taken place what to do and that any misteps will lead to other part failures!! We bought this car w/ very low mileage so at the point they say they fixed the car and when it broke was approx. 30,000 Miles. They either did not fix correctly or they did not touch the car at all because the very description to what happened to our car was exactly what is listed as the failure of the part. We would like the original part failure that is now shredded into hundreds of pieces causing future rack and pinion failures to be flushed clean and honestly should replaced the entire rack because they never fixed the part originally or they didn't fix it correctly and the original part failed exactly as stated on the recall to the point the mechanic almost wrecked our car. *Tr
I bought a 1997 cutlass supreme from gabriel jordan of henderson texas. There is a recall on a piece of equipment. In their words: "corrective summary: dealers will install a new lower pinion bearing unless inspect of the existing bearing indicates that replacement of the gear assembly is necessary. Owner notification began on february 5, 2004. Owners should contact buick at 1-866-608-8080; chevrolet at 1-800-630-2438; oldsmobile at 1-800-630-6537; or pontiac at 1-800-620-7668." They have absolutely refused to replace this equipment even though it is faulty. They claim their parts are not on the vehicle. They have given me a quote of $1,300 to replace it.*Jb
Groaning noise coming from steering column/gear when steering wheel is turned. *Jb
Dealership was unable to perform the steering gear bearing recall 03v527000 because they did not have the tools.*Ak
While driving steering jerked uncontrollably. Consumer was not able to maintain control of the vehicle, and it collided with another vehicle. No injuries reported. However, consumer drove the vehicle to the dealer. For inspection, but mechanic could not duplicate the problem. *Ak
After having recall 03v527000 performed on my vehicle, I am having clicking noises every time I turn the wheel of the vehicle. *Ak
While driving at 20 mph, the front wheels buckled and the vehicle fell to the ground. The steering locked up. The vehicle was taken to the dealer in march 2004 for a rack and pinion replacement. The consumer was wondering why this incident happened. *Ak the consumer was approaching a rail road track, then all of a sudden the steering wheel would not turn and the vehicle had taken off to the right. The consumer was not able to control the vehicle. The vehicle was not fixed or the dealer placed the wrong part on the vehicle. The lower pinion bearing was replaced. *Sc *jb
The dealership refused to honor the steering gear bearings recall 03v527000. After the dealership inspected the steering rack, they indicated that it was an after market productand it didn't look like the correct part for the vehicle. Also, the dealership stated that the vehicle was unsafe to drive. *Ak *sc *jb
Recall 03v527000 concerning steering gear bearings failure. Consumer was authorized to take the vehicle to a chevrolet dealership to have recall repairs done. The dealer informed the consumer that a leaking rack and pinion needed to be replaced before recall work could be done. Replacement of the rack and pinion was part of the recalled problem. Dealer charged the consumer for replacing the rack and pinion. *Ak the consumer requested reimbursement. The transmission cable from the gear shift lever had to be replaced *jb
Dealership stated they would replace the steering rack if needed to fix the steering problem, they changed their minds. *Ph
Consumer was injured when her vehicle crashed into a telephone pole after she experienced lower pinion bearing separation. *Ph *mr
After dealership performed steering gear bearings recall 03v527000 repairs front end was out of alignment. The steering wheel was off center, and the right tire faced outwards. Dealership wanted to charge $80.00 To align the vehicle although the alignment was fine before the recall was done.*Ak
I had a recall on my steering rack pinion and the dealership and the manufactory would not honor it because they said the original gm part had been replaced with an non gm part. *Ak
While driving vehicle pulled to the right. Consumer pulled the steering wheel to the left and the vehicle rolled over and went into a ditch. Vehicle was totaled. *Ak
VEHICLE'S RACK AND PINION WAS LEAKING. *LA *MR
My vin[[redacted]] is not included in gm recall # 03v-527. My 1997 oldsmobile cutlass supreme is having the same problems as described. The repair estimate for repair from caldwell clover chevrolet, an authorized gm facility is $843.00. The recall needs to be expanded to include all effected automobiles with the problem. This problem has occurred approx. 8 - 12 Times over the past 3 months. Another safety issue with this same car is the horn. It does not blow. An authorized gm facility cannot find the...
Read the full complaint
problem under the hood and stated it is in the steering column under the air bag which is a timely and expensive repair. This problem is constant. The horn has not blown in over 1year except on the rare occasion (approx. Every two months) it will blow for less than 20 min. Then stop again.*Ak *js information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6)
Loss of power steering, grinding noise, leaking fluid. *La
While driving 50 mph, the vehicle started experiencing difficulty with the steering. The consumer struggled to steer the vehicle to the shoulder. The vehicle was towed to the dealer who replaced the rack and pinion steering system. The manufacturer had been informed of the problem. *Ak *scc *jb
While turning to the left at 10 mph the steering wheel locked up. The vehicle was towed to an independent shop. The dealer never was notified. *Ak they replaced the entire rack and pinion steering unit, it failed again one month later and the repair shop realigned the power steering fluid line. *Scc *jb
The steering locked up which made it difficult to control the vehicle as well as turn corners.*Ak the dealer replaced the rack and pinion assembly. *Nlm
When pulling to the left out of a parking place I noticed that the steering wheel was becoming increasingly difficult to turn. Eventually the wheel wouldn't turn even with force. While trying to turn the wheel a "squooshing" noise was heard. After a few moments the steering wheel did turn, but with extreme difficulty, and I immediately went straight home (approximately 14 miles). During that time I did not make any abrupt turns and was very cautious driving only 45 mph at the maximum. Upon reaching home I...
Read the full complaint
contacted the local gm dealership for service, since the car was unsafe to be driven any major distance. After the car was inspected I was told the rack and pinion was defective and needed to be replaced in order for the car to be operable. I don't feel that this item should have failed at 6 years since the car has been regularly and properly maintained. I also feel that this repair should be fully reimbursed by the manufacturer since this is a safety issue. *La
While driving and without warning steering wheel locked up. Dealer replaced rack and pinion and right axle.*Ak the vehicle was taken tot he dealer where they found the lower pinion bearing damaged, dust cap missing, power steering pump leaking, serpentine belt cracked and the right axle boot torn, which caused axle noise. The dealer replaced the rack and pinion, axle seal, replaced and resealed the power steering pump, replaced the serpentine belt and flushed the brake and power steering fluid. The lower intake manifold leaked at the left rear. The brake hose was twisted. The dealer replaced the hose. *Ts *nlm
While driving the vehicles the steering wheel makes noise. The vehicle was taken to the dealer on september 9, 2002 and replace steering column seals, on september 18, 2002 problem recurred. Happened again on january 8, 2003. The steering experienced many other failures and the dealer replaced the rack and pinion. *Nlm *nlm
Consumer stated while driving steering failed when wheel was turned to the left. Dealer diagnosed that rack and pinion had failed and consumer had replaced. Ts *tt
Oldsmobile Cutlass steering complaints by year
Cutlass steering problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data