Paccar is recalling certain model year 2007-2008 kenworth and peterbilt vehicles manufactured from february 2, 2006 through april 30, 2007. The bearing surfaces of the extended lube universal joint that attaches the inter-axle driveline to the drive axle may...
Transmission & drivetrain
Peterbilt 379 Transmission problems by year
8 complaints filed with NHTSA about the Peterbilt 379's transmission & drivetrain. Harsh or delayed shifting, slipping, CVT shudder, rollaway, axles, driveshafts and transfer cases.
Transmission complaints by model year
Transmission recalls
On certain trucks, the axle housings may have been manufactured with steel that was out of specification which could result in a fatigue failure over time.
On certain trucks equipped with chalmers rear suspensions, the adjustable torque rod end castings may be brittle. A brittle rod end casting may fracture without warning, causing the vehicles' rear axles to become misaligned.
On certain heavy duty trucks, the locking tab that locks the outer spindle nut onto the spindle was not engaged or properly bent over.
Latest 379 transmission complaints
2005 Peterbilt 379 conventional, drive shaft broke from truck onto the roadway and another vehicle struck it. *Bf ohio traffic crash report # 10-0279-90 updated 05/03/10 *bf
The drive shaft on a 2007 peterbilt malfunctioned and dropped out of the tractor, causing damage to the tractor and to 5 vehicles following who hit the shaft in the roadway. The peterbilt has 267,009 miles on it and the shaft was under warranty. This was a dana corporation driveshaft and they fixed the tractor under warranty and are handling the claims of the 5 vehicles who encountered the defective shaft. *Tr
2005 Peterbilt 379 caught fire. Consumer heard a hissing noise and pulled over and notice the tires were on fire. *Nj the driver noticed smoke coming from the drive axles. Ohio traffic report # 10-0196-89 updated 04/15/10 *bf
The crankshaft broke when slowing for a scale house, leaving the truck disabled. The truck was towed to a shop. The cluch and transmission input shaft had to be replaced. *Jb
The weld between the shaft housing and air chamber arm was breaking. *Ph *la
Vehicle is leaning too much to the left. Vehicle has been to the dealer and several independent repair shops, and no one can correct the problem, asking nhtsa to assist on this issue.*Ak. Several mechanic discovered that the steer tires were worn, the steer axle wheel bearing was broken and the right steer axle kinpin had excessive play, the vehicle was aligned, the clutch was adjusted, the steering was tight, and the steering gear box was replaced.*Jb
While driving on the highway a truck pulled out in front of consumer's vehicle. Consumer slammed on brakes and transmission downshifted into gear. Contacted dealer. This has happened 5 times. *Ak
Wheel seals & bearings went out. Had bearings & seals replaced & they went out again. Also wheel hub and spindle might be defective. *Ak
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data