Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Vehicle safety record

2010 Peterbilt 386 Problems, complaints & recalls

Owners have filed 1 complaint about the 2010 Peterbilt 386 with NHTSA, most often about the visibility & wipers (1). It is covered by 5 recalls, the latest in April 2020 for the electronic stability control (ESC). For comparison, the 2009 has 1 and the 2011 has 1.

NHTSA data checked

CAbout as many problems as a typical 386 year, for its age

#373 most complained-about 2010 vehicle

Complaints
1
Recalls
5
Crashes
0
Fires
0
Injuries
0
Deaths
0

Most common 2010 Peterbilt 386 problems

Share of all 1 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.

2010 Peterbilt 386 recalls 5

Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do

Electronic stability control (ESC)

20V199000460,515 vehicles affected

The problem
PACCAR Incorporated (PACCAR) is recalling certain 2008-2019 Peterbilt 330, 335, 337, 340, 348, 365, 367, 384, 386, 387, 388, 389, 567, 579 and 587 vehicles and 2008-2020 Kenworth T170, T270, T370, T660, T680, T800, T880, and W900 vehicles equipped with NAMUX Software. In the event that the Anti-lock Brake System (ABS) loses battery and/or ignition power to the controller, the dash warning light for the ABS may not illuminate to warn the driver of the loss of ABS. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems," and 136, "Electronic Stability Control System on Heavy Vehicles."
The risk
If the driver unknowingly operates the vehicle without the ABS functioning, there would be an increased risk of a crash.
The fix
PACCAR will notify owners, and dealers will update the NAMUX software within the cab control module, free of charge. PACCAR issued owners an interim notification on June 4, 2020. The recall began May 26, 2020. Owners may contact Kenworth customer service at 1-425-828-5888 or Peterbilt customer service at 1-940-591-4220. PACCAR's number for this recall is 20pbc AND 20KWB.

Equipment: labels

13V593000561 vehicles affected

The problem
Paccar Incorporated (Paccar) is recalling certain 2004-2013 Peterbilt 379, 357, 378, 367, 388, 365, 389, 385 and 386 trucks manufactured from April 3, 2003, through October 25, 2013 and equipped with tri-drive rear axles and a tag or pusher axle. The affected vehicles may be missing required information from the certification label, specifically the tag or pusher axle the gross axle weight rating, suitable tire and rim information, and recommended tire pressure information. Without this information, the vehicles do not comply with the requirements of 49 C.F.R. Part 567, "Certification."
The risk
As a result, the axles may be overloaded or the wrong tires could be installed or the tires could be improperly inflated. All of these issues increase the risk of a crash.
The fix
Peterbilt will notify owners and dealers will inspect and replace the certification labels missing the necessary information. The recall is expected to begin in January 2014. Customers can contact Peterbilt at 1-940-591-4000. Peterbilt's number for this campaign is 1113-F.

Electrical system: software

11V380000211 vehicles affected

The problem
Paccar is recalling certain model year 2011-2012 kenworth t660, t700, and t800 vehicles manufactured from april 19, 2010, through may 13, 2011, and model year 2008, 2010, and 2011 peterbilt 365, 367, 384, 386, 387, 388 and 587 vehicles manufactured from april 20, 2010, through june 11, 2011, and equipped with paccar mx engines and eaton ultrashift dm or allison automatic transmissions (without auto-neutral). The fast idle control may be activated by the operator while the transmission is in gear.
The risk
If the fast idle control function is engaged with the transmission in gear, the vehicle could unexpectedly accelerate and override the parking brake and , creating a risk of a crash and damage to other vehicles or property and the potential for injury to nearby pedestrians.
The fix
Kenworth and peterbilt dealers will update the engine software for the affected chassis. This service will be performed free of charge. The safety recall began on august 22, 2011. Owners may contact kenworth at 1-425-828-5440 and peterbilt at 1-940-591-4196.

Fuel system: tank assembly

11V1270004,664 vehicles affected

The problem
Paccar is recalling certain model year 2008-2012 kenworth t2000, t660, t700, t800, and w900, as well as model year 2009-2012 peterbilt 365, 367, 384, 386, 387, 388, 389, and 587 trucks equipped with paccar mx engines. The oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil module onto exhaust components.
The risk
The discharge of engine oil onto exhaust components which are hot, such as when the engine is under significant load, may cause a fire.
The fix
Dealers will re-torque the oil module filter cap and install a secondary retention device on the secondary centrifugal spinner filter cap. This service will be performed free of charge. The safety recall is expected to begin during march 2011. Owners may contact kenworth at 1-425-828-5440 and peterbilt at 1-940-591-4196.

Steering: column

10V3080009,697 vehicles affected

The problem
Paccar is recalling certain model year 2008-2010 trucks equipped with trw steering shafts. The circumferential weld around the steering shaft tube that welds the splined tube to the non-splined tube may be mislocated. Mislocation of the circumferential weld may allow the splined tube and non-splined tube to rotate relative to one another during a low speed, high torque turn, possibly resulting in a separation of the two tubes.
The risk
A separation of the splined and non-splined tubes would cause a loss of steering control and increase the risk of a vehicle crash.
The fix
Dealers will inspect the steering shaft using a weld placement gauge provided by trw. Any steering shaft found to have been welded improperly will be replaced free of charge. The safety recall began on july 30, 2010. Owners may contact kenworth at 425-828-5440 and peterbilt at 940-591-4196.

What owners say

Be the first 386 owner to share.

Problems or none - your experience is exactly what the next buyer is looking for. Write it now

1 complaints about the 2010 Peterbilt 386

Newest first, as filed with NHTSA by owners.

Visibility & wipers

2010 Peterbilt 386, rain water beads on the side windows and does not get blown off. As this beading builds up on the windows and the mirror, it becomes very difficult to see anything in the mirrors. When this occurs at night it is impossible to see anything in the mirrors. Changing lanes in these conditions is extremely dangerous. *Tr

Filed Incident VisibilityNHTSA 10330613

Peterbilt 386: every year compared

YearComplaintsRecallsCrashesFiresTop problemGrade
20140500-C
20131600Engine & coolingC
20122700Wheels & tiresD
20111601Electrical systemD
20101500Visibility & wipersC
200911000-D
200841400Engine & coolingF
20071801BrakesD
20060200-A
All 386 years

2010 Peterbilt 386 vs rivals

VehicleComplaintsRecallsCrashesGrade
2010 Peterbilt 386150C
2010 Peterbilt 320140DCompare

More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.

Own a 2010 Peterbilt 386? Share your experience.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Questions about the 2010 Peterbilt 386

Does the 2010 Peterbilt 386 have any recalls?

Yes - NHTSA lists 5 recalls for the 2010 Peterbilt 386: electronic stability control (ESC) (April 2020); labels (November 2013); software (July 2011); tank assembly (February 2011) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.

What are the most common problems with the 2010 Peterbilt 386?

By the complaints owners filed with NHTSA, the most common problem areas are the visibility & wipers (1).

How many complaints has the 2010 Peterbilt 386 had?

1 complaints have been filed with NHTSA, the first on May 16, 2010 and the latest on May 16, 2010. Of these, 0 describe a crash and 0 a fire, and together they report 0 injuries and 0 deaths.

Is the 2010 Peterbilt 386 a reliable vehicle?

Its Safety Index is 48 out of 100 (grade C: about as many problems as a typical Peterbilt 386 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.

Which Peterbilt 386 years have the most complaints?
What should I do if my 2010 Peterbilt 386 has a problem?

If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience