Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Steering

2009 Peterbilt 387 Steering problems

Owners have filed 1 complaint about the 2009 Peterbilt 387's steering with NHTSA - 50% of all its complaints, most recently on September 13, 2008. Loss of power steering, stiff or loose steering, wandering, column and rack problems.

Complaints
1
Recalls
2
Crashes
0
Fires
0
Injuries
0
Deaths
0

Steering recalls for the 2009 Peterbilt 387

Steering: column

10V3080009,697 vehicles affected

The problem
Paccar is recalling certain model year 2008-2010 trucks equipped with trw steering shafts. The circumferential weld around the steering shaft tube that welds the splined tube to the non-splined tube may be mislocated. Mislocation of the circumferential weld may allow the splined tube and non-splined tube to rotate relative to one another during a low speed, high torque turn, possibly resulting in a separation of the two tubes.
The risk
A separation of the splined and non-splined tubes would cause a loss of steering control and increase the risk of a vehicle crash.
The fix
Dealers will inspect the steering shaft using a weld placement gauge provided by trw. Any steering shaft found to have been welded improperly will be replaced free of charge. The safety recall began on july 30, 2010. Owners may contact kenworth at 425-828-5440 and peterbilt at 940-591-4196.

Steering: column

09V2580002,096 vehicles affected

The problem
Paccar is recalling 2,096 my 2009 kenworth and peterbilt vehicles equipped with trw steering shafts. Mislocation of a circumferential weld may allow the splined tube and non-splined tube to rotate relative to one another during a low speed, high torque turn, possibly resulting in a separation of the two tubes.
The risk
A separation of the splined and non-splined tubes could cause a loss of steering control and increase the risk of a crash.
The fix
Dealers will inspect the steering shaft using a weld placement gauge and miswelded steering shaft will be replaced free of charge. The recall began july 31, 2009. Owners may contact kenworth at 1-425-828-5440 and peterbilt at 1-940-591-4196.

Steering complaints

Steering

Steering linkage is a critical failure in the peterbilt 387. I have a 2009 model, and only 4 months old, it now makes scary popping and creaking noise. From my understanding from other drivers of the same model vehicle, steering seizes to the right or left making it hard to break it loose. My opinion is that paccar needs to modify and improve the steering components. For me, the popping and creaking noise gets louder and louder every day. I'm thinking its the material used that's a complete fail. Peterbilt isn't...

Read the full complaint

willing to honor their mistake on my truck, telling me this is normal. Please do look into this component. Peoples lives are at risk when it comes to an 80,000lb road hazard. Thanks. *Tr

Filed Incident SteeringNHTSA 10242045

Peterbilt 387 steering complaints by year

387 steering problems, every year

Had a steering problem with your 2009 387? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience