PACCAR Incorporated (PACCAR) is recalling certain 2026-2027 Peterbilt 579 and 2027 Kenworth T680 tractors. The trailer air connection quick release (QR) valve in the air brake system may have been incorrectly installed, which can cause the trailer to become...
Brakes
Peterbilt 579 Brake problems by year
7 complaints filed with NHTSA about the Peterbilt 579's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
Brake complaints by model year
Brake recalls
PACCAR Incorporated (PACCAR) is recalling certain 2021-2025 Peterbilt and Kenworth vehicles, equipped with Bendix EC80 Advanced Electronic Control Units (ECU). Please see the recall report for a complete list of models. Electrical noise and low signal to...
PACCAR Incorporated (PACCAR) is recalling certain 2023-2024 Peterbilt 579 trucks. The Intellipark Tractor Park Valve Module (PVM) may intermittently become stuck in the un-parked position and fail to move into the park position when the park switch is...
PACCAR Incorporated (PACCAR) is recalling certain 2019-2022 Kenworth T880, W990, Peterbilt 567, 579, 389, and 2022 Peterbilt 536, 537 wrecker and auto hauler vehicles. The work brake (winch brake) may unintentionally disengage the service brakes during...
PACCAR, Inc. (PACCAR) is recalling certain 2021-2022 Peterbilt 367, 389, 567, and 579 vehicles. The cross member mounted Hill Start Assist valve assembly may have insufficient clearance to the rear axle, causing damage to the rear brake hose and loss of the...
PACCAR Incorporated (PACCAR) is recalling certain 2021 Peterbilt 348 and 579 vehicles. The spring brake chamber may have been assembled with incorrect springs that were out of specification, which may cause the pressure plate to shift.
PACCAR Incorporated (PACCAR) is recalling certain model year 2015 Peterbilt 367, 389, 567, 579, and 587 trucks manufactured from May 23, 2014, to February 13, 2015, and 2015 Kenworth T270, T370, T440, T470, T660, T680, T800, T880, and W900 trucks manufactured...
Paccar is recalling certain model year 2013 kenworth t680, and peterbilt 579 vehicles, for failing to comply with the requirements of federal motor vehicle safety standard (fmvss) no. 121, "Air brake systems." These vehicles exceed the brake timing test...
Latest 579 brake complaints
The contact owns a 2022 Peterbilt 579. The vehicle was previously repaired under NHTSA Campaign Number: 24V915000 (SERVICE BRAKES, HYDRAULIC, ELECTRICAL SYSTEM); however, the vehicle experienced the failure listed in the recall after the recall repair. The contact stated that while driving 22 MPH, the brakes failed to activate. There was no warning light illuminated. The vehicle was taken to a dealer to be diagnosed, and the contact was informed that the failure with the brakes was caused by a loss of communication...
Read the full complaint
between the ECM and the ECU. The contact was informed that the ECU was not installed on the vehicle, and the lane mitigation system was found unplugged. The vehicle was not repaired. The manufacturer was notified of the failure; however, the manufacturer refused to help due to how the vehicle was manufactured. The contact stated that the vehicle was manufactured improperly with salvaged parts and stated that the serial number for the engine was not a match for the original engine. The failure mileage was 526,000.
The contact was the operator of a 2026 Peterbilt 579 for an employer. The contact stated that whether driving 30 MPH or 65 MPH, after another vehicle entered the lane in front of the vehicle, the Forward Collision Avoidance: AEB and Lane Keep Assist systems erroneously activated and brought the vehicle to an unsafe and abrupt stop. The contact stated that the RADAR system had experienced a False Positive alert of a possible crash, even though the vehicle was at a safe driving distance ahead. The contact stated that...
Read the full complaint
the failure caused other driver's behind the vehicle to run off the road or skid to a stop to avoid crashing into the rear of the vehicle. The contact stated that the failure also occurred with another vehicle approximately 100-feet ahead coming over into the lane, and the AEB activated, causing the wheels to lock up, bringing the vehicle to an abrupt stop. The contact stated that other drivers angrily honked at him. On one occasion, the contact was followed by an irate driver for ten minutes after the failure had occurred. The contact was concerned for his safety and the safety of the public because the system could not be overridden. The contact stated that on one occasion while his brother was driving the vehicle at a moderate speed, while the contact was asleep in the sleeping netting which the contact believes was not DOT approved, the AEB system activated and sent the contact's body forward, causing his rib cage to strike a cabinet inside the sleeper berth, causing an injury. The contact had not sought medical attention. The contact stated that the employer was notified of the failures with the vehicle, and the contact was informed to keep driving the vehicle as-is or seek other employment. The contact stated that the RADAR system also experienced False Positive alerts and inadvertent AEB activation while driving and approaching bridges or structures that cast shadows onto the roadway bringing the vehicle to an abrupt stop. The contact stated that prior to the abrupt stop, there was a picture of the hood on the instrument panel in RED, and instantly the vehicle came to a complete stop. The contact stated that the messages: "Auto-Electric Brakes - Disabled; Auto Lane - Defective; Lane Assist - Defective; and Lane Assist - Disabled" were displayed. The contact stated that after turning off and restarting the vehicle, all the messages were cleared from the system. The vehicle was not taken to be diagnosed or repaired. Neither the local dealer nor the manufacturer was notified of the failures. The approximate failure mileage was 200.
See attached document for complaint.
This vehicle about 6-8 weeks ago started throwing codes for all systems above (over 100 codes). This issue affected all systems of the vehicle including but not limited to the speed and braking of the vehicle, plus the fuel system and adaptive driving systems. We took it to the dealer Performance Peterbilt in Tifton, GA. They cleared the codes and said they resolved it by replacing a NOX sensor. We left the repair shop and within 50-100 miles the exact same issue started up again. We took it back to the same shop,...
Read the full complaint
they worked with Paccar and determined it needed a new ECM (Computer), this was changed out and still did not resolve issue. They then changed out the main wire harness. This resolved some issues but not all issues. Now the repair dealer is stating it needs a dash wire harness. This vehicle has relatively low miles 500K and has only been serviced by Peterbilt dealers through it's life. This issue causes the vehicle to accelerate and brake randomly plus many other issues by stopping power in hauling. We have another IDENTICAL vehicle which is now doing the same thing but have not brought it into the shop yet until manufacturer can get this 1st truck fixed properly to ensure safety.
Vehicle has a following distance sensor on front bumper. Sensor is sensing overpasses when traveling underneath them and that should not be detected. Vehicle is automatically applying hard braking. This is causing a possible rear end collision and or loss of vehicle controll in wet conditions.
Bendix wingman collision mitigation system, this system as am trying to brake the vehicle determined that the vehicle in front was closer than it really was and locked the brakes and steering, at such time the driver looses control of the vehicle completely, this was the fourth time it did this, the third time it locked the brakes I was trying to brake while a car was driving out of a driveway, second time I was trying to pass a car and it detected the car to close and locked the brakes, first time bumper to bumper...
Read the full complaint
it was raining, on a highway a vehicle cut in front of me tried to apply the brakes and the system locked up the brakes and steering, there was plenty of room for me to stop without this system having to lock the brakes up on me
Vehicle involved in wheel end fire that destroyed the attached trailer and load. Damage to tractor was contained to the rear chassis and backside of the cab. Vehicle was in motion on interstate highway when the driver saw smoke coming from the tractor drive wheels. Tire blew soon after and fire could not be extinguished by on board fire extinguisher. The fire prevented access to fifth wheel release. Driver was unable to separate trailer from tractor to prevent further damage and load loss. Total damages in...
Read the full complaint
excess of $250k formal fire investigation at storage lot and subsequent lab inspections concluded that a haldex 3030 goldseal chamber to be the root cause. The parking spring had failed and punctured parking side diaphragm. The subsequent leak caused parking brakes to partially apply while vehicle was moving. The private fire investigation firm hired by the fleet provided x-rays showing the spring failure prior to disassembly. This fleet has documented numerous haldex goldseal 3030 chamber failures on its other same year,make model tractors. Failures are occurring at abnormally high rates and within the first 2 years from date of in-service.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data