PACCAR Incorporated (PACCAR) is recalling certain 2021-2024 Peterbilt 365, 367, 389, 535, 536, 537, 548, 567, 579, and 2021-2025 Kenworth T180, T280, T380, T480, T680, T880 and W990 trucks. The right-hand gear shifter stalk connectors may have been...
Transmission & drivetrain
Peterbilt 579 Transmission problems by year
6 complaints filed with NHTSA about the Peterbilt 579's transmission & drivetrain. Harsh or delayed shifting, slipping, CVT shudder, rollaway, axles, driveshafts and transfer cases.
Transmission complaints by model year
Transmission recalls
PACCAR Incorporated (PACCAR) is recalling certain 2018-2019 Peterbilt 337, 348, 365, 367, 389, 567, 579 and 587 trucks and 2018-2019 Kenworth C500, T270, T370, T440, T660, T680, T800, T880 and W900 trucks equipped with automated manual transmissions. An...
PACCAR Incorporated (PACCAR) is recalling certain 2018 Peterbilt 567, 579, Kenworth T680, and T880 trucks, equipped with certain Eaton Endurant and PACCAR AMT transmissions. The transmission control module (TCM) may allow the engine to crank briefly even if...
Paccar (Paccar Incorporated) is recalling certain 2016 Kenworth T680, T800, and T880 trucks manufactured January 5, 2015, to January 7, 2015 and 2016 Peterbilt 367, 384, 567, and 579 trucks manufactured January 2, 2015, to January 9, 2015 and equipped with...
PACCAR Incorporated (PACCAR) is recalling certain model year 2014 Peterbilt 567 and 579 model chassis manufactured January 29, 2013, through October 9, 2013, and equipped with Allison-brand transmissions. The affected vehicles may be missing the wiring that...
Latest 579 transmission complaints
After a decel to 20ish mph, the automated manual transmission attempted to shift into gear to begin acceleration. The transmission made load noises indicating a failure followed by a transmission warning with the fault code being 617 FMI 14. All acceleration and engine braking ability was disabled, increasing the risk of an accident due to the vehicle being disabled. A similar safety recall for the same vehicle would be NHTSA #24V-190 which causes the vehicle to become disabled and increase a crash risk. This is a...
Read the full complaint
known issue caused by compressed air contamination according to Eaton Transmissions service bulletin TAIB-1006, which was first published April 2023. In the over 3 years since the service bulletin was released, Eaton, Peterbilt, Paccar, and Cummins(engine manufacturers) have failed to develop adjusted maintenance intervals, added inspections, or additional filtration to prevent contamination of the transmissions air system. They've instead passed the financial burden of repair on the customers by denying warranties. The dealer determined based on TAIB-1006 that the MTM requires replacement and the air system cleaned of contamination. This was based on data and not a detailed inspection to determine the internal failure.
Peterbilt has a recall 24V190 for the right hand shifter stalk. This VIN is not on the recall list however it does have the defective shift stalk and has been replaced 3 times prior to the recall. The most recent replacement was 8/20/24 replaced with the same defective part #. How do I get this truck on the recall list?
The contact owns a 2022 Peterbilt Conventional 579. The contact stated while driving at an undisclosed speed, the transmission independently shifted to neutral. The vehicle was driven to the shoulder of the road. The vehicle was turned off and restarted, and the vehicle was independently reset. The vehicle was taken to the dealer; however, the contact was informed that a software update was ordered by the manufacturer. The software update was performed; however, the failure reoccurred. The contact was informed...
Read the full complaint
that there was no fix for the failure because the dealer was unable to determine the cause of the failure. The manufacturer was made aware of the failure and the dealer was instructed to perform the software update again. The failure mileage was approximately 540,000.
The contact owns a 2022 Peterbilt 579. The contact stated that while driving at an undisclosed speed, the vehicle downshifted with multiple warning lights illuminated. The vehicle was restarted; however, the failure recurred. The contact received notification of NHTSA Campaign Number: 24V190000 (Power Train); however, the part to do the recall repair was unavailable. The dealer was contacted. The vehicle was taken to the dealer where it was diagnosed and determined that the gear shifter assembly had failed and...
Read the full complaint
needed to be replaced. The vehicle was not repaired. The contact was informed by the dealer that the parts were not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The approximate failure mileage was 220,536. VIN tool confirms parts not available.
1. The components that malfunctioned were the "engine/transmission match" and "transmission communications failure idle torque limit". Yes, my unit is available for inspection at any time. 2. When I had to stop on the freeway due to heavy traffic, the gearshift would not budge, causing an even bigger traffic delay. I had to turn off/on my unit multiple times to be able to pull over, safely. If I were not able to change gears while on the road, it could create a big accident due to faulty parts. 3. Yes, my local...
Read the full complaint
Peterbilt is aware of this issue and ordered a "right hand turn stalk shift" (part# Q21-6155-211X) to fix the issue. I was told that this replacement part was out of stock and may need to wait up to 3 months for it. I called other Peterbilt's in CA but everyone was out of stock, with 20 to 30 trucks also waiting for the same part. I even called Canada to see if they had parts, but they are also out of this particular part, with a long waitlist of trucks at their dealerships. Peterbilt had to recall the gearshifts on their units back in 2018: https://www.truckinginfo.com/278812/kenworth-peterbilt-trucks-recalled-for-transmission-gear-display 4. There were no prior indications that the gearshift needed inspection. The vehicle only indicated "Transmission fault" when the gearshift became stuck. When I put my unit in "Drive" the dashboard showed an "!" and when I put my unit in "R" the dashboard showed the unit was in "Drive". These incorrect messages/gear changes can be very dangerous. My unit is a 2023 Peterbilt 579 with only 90K miles, there is no reason it would have a faulty gearshift and no reason why each dealership has a waitlist of 20-30 trucks waiting for this exact part. Paccar clearly did not learn from the 2018 recall 118-A. I believe Peterbilt is knowingly manufacturing faulty parts in an effort to make as many sales as possible. These faulty parts need immediate attention but are completely out of stock nationally.
Drive line installed incorrectly. Fell out while driver was on the highway.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data