Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

1999 Porsche 911 Engine problems

Owners have filed 4 complaints about the 1999 Porsche 911's engine & cooling with NHTSA - 50% of all its complaints, most recently on February 13, 2019. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
4
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Engine complaints

Engine & cooling

Engine has seized due to intermediate shaft bearing failue (ims bearing failure), the engine is a 3.4 Liter flat 6 cylinder engine with only 95,500 miles on it. There was no warning sign of an issue. Turned off car when I got home then when I turned it on the naext day it would not turn over to crank. I took it to a local mechanic shop to get it tested and was told I will have to replace entire engine which costs upwards of $13,000 because of an ims bearing failure.

Filed Incident EngineNHTSA 11179953
Engine & cooling

Was driving and massive amounts of antifreeze leaked out of the back onto the road and on my tires. Engine then started to smoke and overheat. Could have been very dangerous. Overflow reservoir cap was screwed on tightly so that was not the issue. I read that there were some issues with the 2001-07 porsche 911. My engine was replaced in 2003 so perhaps it was retrofitted with the problem parts. It will be at the ray catena porsche dealership in edison nj tomorrow for repairs. *Tr

Filed Incident Engine and engine coolingNHTSA 10522740
SteeringBrakesEngine & cooling

I was driving on a 16 lane major highway in toronto in the express lanes at 70 mph. Without warning the engine lost all power and stalled. The check engine light was flashing. It was difficult to stop safely since the power steering and power brakes were not functioning with the engine stopped. It would not restart and I was lucky to change lanes in heavy traffic and pull onto the hard shoulder of the road. I was stuck sitting in the express lanes by a guard rail until a tow truck came, which took an hour. After...

Read the full complaint

taking it to the porsche dealer it was diagnosed as a ims bearing failure that required a new engine. I was also told this bearing is a common problem with the 1997 to 2008 water cooled 911 and boxster porsches with a 10 percent failure rate to date, and that they will all fail eventually. The dealer also said there is a 3rd party retrofit kit that the porsche dealers are aware of but don't use because it would acknowledge there is a problem with the car, so porsche turned a blind eye and let the engines fail. Porsche has modified the bearing design several times before abandoning the design in the 2009 model year. All these models are unsafe when they will fail without notice and put drivers in harms way. *Tr

Filed Incident Steering · Service brakes · EngineNHTSA 10507046
Engine & cooling

Engine heat sensor failed causing coolant to leak from vehicle. Yh

Filed Incident Engine and engine coolingNHTSA 608690

Porsche 911 engine complaints by year

911 engine problems, every year

Had a engine problem with your 1999 911? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience