On certain sport utility vehicles, the two bolts that attach the steering gear assembly to the frame may have been over-tightened. This condition could result in one or both of the bolts fracturing, causing the steering gear to become loose.
Updated daily from NHTSA
Latest vehicle recalls
38 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain trucks equipped with davco fuel pro 382 heated fuel filters, when the key is in the 'on' position, the pre-heater, located in the fuel filter base, is energized.
On certain trucks, one or both rear axle housings may contain thinner material than what is necessary for normal vehicle operation. Over time, this thinner material may result in a fatigue failure of the rear axle housing, possibly in the location of the...
On certain motorcycles, the horizontal and vertical cylinders mobile timing belt tensioner is dimensionally incorrect.
On certain motorcycles, the horizontal cylinder head fitting to the thermostat produced a coolant leakage.
Certain my 2006 sturdibus and universe school buses equipped with ricon 2000 and 5000 series wheel chair lifts. The defect involves the interlock switch system in the lift not detecting the presence of a passenger (either wheelchair or standee) on the ricon...
Certain truck equipped with behr cables, the cables were installed incorrectly and are too long.
On certain fifth wheel trailers, the taillight sockets may not maintain contact with the bulb. The taillights may not function reliably.
On certain vehicles, the heat generated by the engine causes repeated bending deformation of the polypropylene cooling fan including its retaining ring, which stresses the polypropylene thereby initiating cracking of the blades. The centrifugal forces...
On certain motor homes, the tv is not secured sufficiently and could fall out when the motorhome is moving.
Certain trucks were recalled for the installation of sleeves on the fuel injection line as required by safety recall sc0317 (nhtsa recall no. 06V392). There is a possibility that the new sleeves may chafe the fuel injection line.
Certain u.S. Bus sturdibus, sturdivan, and universe school buses manufactured between may 1, 2000, and may 2, 2006. In a crash, the wall and floor mounting bolts can pull through the supporting steel which fails to conform to federal motor vehicle safety...
On certain trucks built with front axles assembled by arvinmeritor, the front spindle nut may be over-tightened causing preload on the front wheel bearings which could lead to premature bearing wear.
On certain mini van conversions, the brake lines may have been routed incorrectly. The brake lines can make contact and chafe on the stabilizer bar.
On certain motor homes, the exterior slideout storage drawer can inadvertently slide out during normal highway operation.
On certain sport utility vehicles equipped with antilock brakes (abs), the abs module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.
On certain sport utility vehicles equipped with antilock brakes (abs), the abs module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.
On certain trucks, the rear drive axle housing was manufactured with steel below the specified thickness and, as a result, it could develop a crack.
On certain trucks, if the ignition switch is turned on prior to initial start up in the manufacturing plant or during the filter replacement in the field, a small flame will ignite when the fuel is added to prime the system.
On certain vehicles originally sold in or currently registered in the states of arizona and nevada, due to the combination of fuel quality and climate conditions, the fuel pump may, in certain cases, experience a reduced functionality. The most common...