Certain wagons fail to comply with the requirements of federal motor vehicle safety standard no. 210, "Seat belt assembly anchorages." The seat belt anchor may separate from the floor of the vehicle before holding the required test load for the required time.
Seats & seat belts
Saturn LS Seat Belt problems by year
11 complaints filed with NHTSA about the Saturn LS's seats & seat belts. Seat belts that won't latch or retract, seat frames, seat heaters, recliners and child seat anchors.
Seat Belt complaints by model year
Seat Belt recalls
Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load...
Latest LS seat belt complaints
The whole subframe on my 2000 saturn ls is rotted so bad that I can't even drive the vehicle. It started with my car not starting and putting it up on a lift to see what the problem was. That not starting problem is a bad resonator, but in the process the subframe was found to be seriously rotted away. *Tr
Driver's side power seat motor overheated and began to melt upholstery. I had to pull the fuse out of the right side fuse panel to cutoff electrical supply and avoid likely fire. *Tr
Dt*: the contact stated while stopped in traffic, the vehicle was hit from behind by another vehicle. Upon impact the driver's seatbelt did not hold causing the occupant to hit the steering wheel. The dash board came forward onto the occupant and the airbag did not deploy. The occupant sustained head, back, neck and right hip injuries and a police report was filed. The vehicle was taken to an independent repair shop, which repaired the vehicle body damages. Although the vehicle was not taken to the dealership for inspection, no other repairs were made.
The drivers seat heater shorted out and caught fire burning a substantial hole in the seat, causing considerable discomfort to my wife by burning her leg. When the manufacturer was informed there was no alarm or concern what-so-ever. I believe this incident is but one of many and should cause considerable concern as the fire hazzard should not be overlooked.
The drivers seat and head rest design in my car blocks my rear view visibility. My model car has adjustable seats. Despite, the various adjustments available to me, I am unable to position the seat such that I can see over the top of the seat. My view out the rear windows of my car is severely impaired by the seat. I am not a short person! If I remove the headrest from the seat I am able to see behind me, but I then create another unsafe siftuation, so I don't do it. The instruction manual that comes with...
Read the full complaint
my car actually contains a photo showing how to adjust the head rest of the car to be at a "proper" height. I am unable to adjust the seat and headrest to achieve the manufacturer's recommended adjustment height. This problem could be resolved by either redesigning the seat or "possibly" coming up with an alternate head rest design.*Ak
The owners handbook provides instruction for placing a rear facing infant seat in the center position of the rear seat. In this position the infant can be struck by the arm rest during a crash. The arm rest is unrestrained and may fold down into the infant seat during a crash. The manufacturer should place a warning in the owners handbook about this condition.
Have had the slave cylinder go out twice. Seat belt no bucles twice. *Ak
There is a gap between the seat and the molding on the passenger side seat about an inch or so where your fingers get stuck in when you go to adjust your seat or drop something on the side. My daughter got her fingers stuck in it several times as well as myself. You have to pull the molding back towards the seat to fix it but once the seat is sat in, the molding separates from the seat again. According to the dealer, there is no fix for this hazard.*Ak
When driver sits on power adjusting seat, the reclining button will depress unintentionally, and seat will recline backwards . Dealer and manufacturer claim there is no solution. *Ak
Due to design and location of power seat button, when exiting vehicle the button is accidently depressed, causing the seat to move backwards into the reclining position, crashing into a child safety seat. Consumer has contacted dealer. *Ak.Et.
The placement of the controls for the drivers side automatic seat are positioned in a way that when the driver get out of the vehicle the back of the seat goes back into the rear seat, the seat also slowly creeps backwards while driving down the road. Nlm
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data