- The problem
- On certain trailers equipped with bendix sr-2, sr-4, and sr-5 trailer spring brake valve assemblies, the molded rubber face of the inlet/exhaust valve (i/e valve) component of the affected valves can separate from the valve's metal insert. Air can be trapped by a separated i/e valve causing it to balloon and block the exhaust passage of the trailer spring brake circuit.
- The risk
- This condition can result in the affected vehicles being unable to apply the trailer parking/emergency spring brakes during parking in the event of a trailer supply line failure. Unintended rollaway could occur, possibly resulting in personal injury or death to the vehicle occupant or any bystanders.
- The fix
- Bendix will notify customers and provide a repair kit and installation instructions free of charge. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bendix at 440-329-9000 or strick at 704-436-2441.
Brakes
1997 Strick Trailer Brake problems
No owner has filed a complaint about the 1997 Strick Trailer's brakes with NHTSA. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
- Complaints
- 0
- Recalls
- 3
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Brake recalls for the 1997 Strick Trailer
- The problem
- Vehicle description: trailers equipped with maxibrake I actuators, type 20, type 24, type 30, and type 36. These brake actuators do not have an overstroke indicator. This does not comply with the requirements of fmvss no. 121, "Air brake systems."
- The risk
- This condition can lead to reduced brake output if the brakes or not properly adjusted or when it is used without an automatic brake adjusting mechanism.
- The fix
- Midland will provide owners with a modification kit which will make the brake system compliant.
- The problem
- Vehicle description: trailers equipped with antilock braking system (abs) electronic control units (ecu) for over-the-road trailer applications. The cover seal (o-ring) may have been improperly installed in certain easy-stop trailer abs electronic control units. An incorrectly installed seal could permit water to enter the ecu causing a fault to develop. This will cause the vehicle's trailer abs warning lamp to illuminate immediately when the water contacts the board, deactivating all or part of the abs.
- The risk
- If the warning lamp signal is ignored for a period of time, corrosion can develop eventually leaking to a complete loss of ecu function. The service brakes would continue to be fully functional.
- The fix
- Rockwell is conducting the notification and remedy for this recall. Dealers will replace the ecu on these trailers.
Brake complaints
No complaints about this area yet.
Strick Trailer brake complaints by year
Trailer brake problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data