- The problem
- Subaru of America, Inc. (Subaru) is recalling certain model year 2008-2011 Impreza, 2008-2014 WRX and STI, and 2009-2013 Forester vehicles, currently, or formerly, registered in Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, Wisconsin and the District of Columbia that were remedied under recall 14V-311 prior to December 23, 2014. The brake lines may experience brake line corrosion due to salt water splashing on the brake lines through a gap in the fuel tank protector.
- The risk
- Brake fluid may leak due to the brake line corrosion and may result in longer distances being required to slow or stop the vehicle, increasing the risk of a crash.
- The fix
- Subaru will notify owners, and dealers will apply an anti-corrosion wax to the four-way joint connector area of the brake line system, free of charge. The recall began on January 27, 2015. Owners may contact Subaru customer service at 1-800-782-2783. Subaru's number for this recall is WQQ-52. Notes: This recall is specific to affected Forester, Impreza, WRX, and STI customers who had their car remedied under NHTSA recall no. 14V-311 prior to December 23, 2014. Subaru has determined that this remedy was inadequate due to incomplete repair instructions provided to dealers. Affected Forester, Impreza, WRX, and STI vehicles that were not repaired under NHTSA recall no. 14V-311 prior to December 23, 2014 will continue to be processed under NHTSA recall no. 14V-311. Affected vehicles not currently, or formerly, registered in the salt belt states identified in this recall are eligible for repair, at no cost to the customer, upon request.
Brakes
2014 Subaru WRX Brake problems
Owners have filed 3 complaints about the 2014 Subaru WRX's brakes with NHTSA - 50% of all its complaints, most recently on September 26, 2015. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
- Complaints
- 3
- Recalls
- 2
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Brake recalls for the 2014 Subaru WRX
- The problem
- Subaru of America, Inc. (Subaru) is recalling certain model year 2005-2009 Outback and Legacy, 2008-2011 Impreza and 2008-2014 Impreza WRX/STI, and 2009-2013 Forester vehicles, currently, or formerly, registered in Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, Wisconsin and the District of Columbia. Salt water could splash on the brake lines through a gap in the fuel tank protector, resulting in excessive corrosion of the brake lines. Note that affected vehicles not currently, or formerly registered, in the salt belt states identified above are eligible for repair, at no cost to the customer, upon request.
- The risk
- Brake line corrosion may result in brake fluid leakage. Fluid leakage may result in longer distances being required to slow or stop the vehicle, increasing the risk of a crash.
- The fix
- Subaru will notify owners, and dealers will test the brake system by depressing the brake pedal and inspecting for brake fluid leaks. If no brake fluid seepage is observed, the affected areas will be rustproofed with anti-corrosion wax. If brake fluid seepage is observed, the brake lines will be replaced followed by rustproofing with anti-corrosion wax. These services will be performed free of charge. The recall began July 2014 and second notifications will run through November 2014. Owners may contact Subaru at 1-800-782-2783. Subaru's recall campaign number is WQK-47. Note: This recall supersedes recall 13V-110 which applied to certain 2005-2009 Legacy/Outback vehicles. Vehicles that were remedied under the previous campaign still need additional areas rust-proofed.
Brake complaints
While depressing the clutch or brake pedal in the vehicle I see excessive flex at the firewall and noticeable movement of break and clutch cylinders. My spot welds do not appear broken at this time however they are likely to fatigue and break. This appears to be a major defect which is a safety concern as it affects breaking and shifting. Subaru should be held accountable and correct the problem.
Tl* the contact owns a 2014 subaru wrx. The contact stated that while driving in stop and go traffic, the brakes failed to respond. The vehicle was taken to a independent mechanic, who repaired the vehicle. The contact was unaware of the exact repairs made to the vehicle. The manufacturer was contacted about the failure. The approximate failure mileage was unknown.
In *extremely* cold weather - below of - the vehicle will start successfully however the stability/traction control, anti-lock brakes, and "hill-assist" (part of the abs system) trouble indicator lights will light and stay lit. Based on the instruction manual if this occurs, I should cycle the ignition to see if the code clears. This is an unacceptable solution because the car's battery is already extremely stressed due to the cold temperature and may not restart the vehicle. However, on one occurrence I did...
Read the full complaint
cycle the ignition and the problem remained. While I recognize that a more vicious brake fluid is needed in a performance vehicle of this type, if the abs pump's orifices were larger this issue might not occur. The other possibility is the brake fluid used during assembly is already supersaturated with moisture and the cold temps allowed the suspended water to fall out of suspension and freeze in the hydraulic lines. Vehicle was safe to drive, the brake's mechanical action was unaffected by the fault. The brake and clutch pedals (which I believe to use the same fluid) it did feel like I was pushing through mud. I did confirm the abs was not functional. *Tr
Subaru WRX brake complaints by year
WRX brake problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data