Triumph is recalling certain model year 2005 through 2009 sprint st 1050 motorcycles manufactured from november 4, 2004 through september 2009. The rear suspension drag link assembly in these motorcycles can fracture due to corrosion.
2005-2009 · 5 model years
Triumph Sprint ST 1050 Problems by year
Owners have filed 2 complaints about the Triumph Sprint ST 1050 across 5 model years, and it has 4 recalls. The 2008 has the most complaints once its age is allowed for (1). The most reported problem area is the acceleration & cruise control, followed by the wheels & tires.
- Complaints
- 2
- Recalls
- 4
- Crashes
- 2
- Fires
- 0
- Injuries
- 3
- Deaths
- 0
Sprint ST 1050 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common Sprint ST 1050 problems
Triumph Sprint ST 1050 recalls 4
Triumph is recalling 372 my 2008 sprint st motorcycles. There is a possibility that the single bolt that is used in the 3 positions on the rear suspension drag link assembly can become brittle and fracture. The bolts involved are the (1) drag link to drop...
On certain motorcycles equipped with an optional accessory luggage rack, undersized washers were used which prevents the sliding carriage from moving as intended.
On certain motorcycles, the rear drag link-through bolt may bend and, if not replaced or overloaded, may fracture causing the rear tire to contact the underside of the rear mudguard.
Latest Sprint ST 1050 complaints
While traveling at approximately 55 mph under normal road conditions, the rear tire experienced a sudden and catastrophic failure. I felt the tire fail first, followed by an immediate loss of stability. The tire split down the center of the tread without warning. There were no prior symptoms, warning signs, or handling issues before the failure. During the loss of control, I then felt the rear of the motorcycle drop further. After the crash, a rear suspension linkage component was found to be cracked at the...
Read the full complaint
mounting point. It is UNKNOWN whether the linkage failure occurred before or as a result of the crash sequence, but it was not felt prior to the tire failure. The tire, 180/55ZR17 73W, had been installed in August and had less than 1,500 miles of use. Tire pressure was set to manufacturer-recommended levels prior to operation. The failed tire is available for inspection, and the damaged rear linkage component remains on the motorcycle. The failure created an immediate safety hazard, resulting in a crash and injuries to a passenger. The motorcycle sustained severe damage and is considered a total loss. No prior warnings, messages, or indicators were present before the failure.
On march 27th, 2009 my motorcycle accelerated maximally and unintentionally during a turn one block from my house. During the event the asphalt was dry and clean and there were no other involved vehicles. The back tire began spinning and the front tire lifted off of the ground despite my rolling off the throttle and leaning on the front wheel. It all happened very quickly and I was left in the highway while my motorcycle drove onto the sidewalk without me. I suffered road rash and bruises on my left side (it was a...
Read the full complaint
left turn) and my best armani suit was shredded. Prior to this event the bike had always run rich, and the stepper motor had failed a few months prior. After getting the bike back I still noticed some surging but nothing as severe as what happened on march 27th. After the crash I did some studying of triumph throttle issues and asked the shop to replace my throttle control sensor. After the crash, and the primarily cosmetic repairs to the bike I got the bike back but noticed that the surging remained. I drove it very carefully (especially in turns) for several hundred more miles but the ignition quality continued to deteriorate to the point where my mpg dropped below 20, the bike was smoking and bucking, and had difficulty idling. While the stepper motor apparently died again, replacing it did not resolve the surging. Finally in november the shop agreed to go completely through the electrical system and they found that the 25 pin connector to the main computer (ecm) had become loose. I would hope that it would be impossible for this connector to work itself loose with normal vibration so I suspect the connector shipped from the factory not properly secured. My insurance company holds me at fault in the crash until I get a letter from triumph admitting fault, which so far they have declined to do. This is my first "at fault" accident in my 25 years of full time motorcycle riding. *Tr
Questions about the Triumph Sprint ST 1050
Which Triumph Sprint ST 1050 years have the most problems?
Which Triumph Sprint ST 1050 years have the fewest complaints?
What are the most common Triumph Sprint ST 1050 problems?
Across every model year, owners report problems with the acceleration & cruise control (1), wheels & tires (1) most often.
How many recalls does the Triumph Sprint ST 1050 have?
NHTSA lists 4 recalls across all Triumph Sprint ST 1050 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data