In the involved vehicles, the air pressure which is used to actuate the engine shutdown solenoid may be blocked whenever transmission fluid temperature exceeds 250 degrees fahrenheit.
1975-1979 · 5 model years
White Truck RC2 Problems by year
Owners have filed 0 complaints about the White Truck RC2 across 5 model years, and it has 12 recalls.
- Complaints
- 0
- Recalls
- 12
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
RC2 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
White Truck RC2 recalls 12
The involved vehicles were built with certain tractor protection valves which may contain an extra valve. This may prevent the trailer brakes from fully releasing after a low pressure application, causing the trailer brakes to drag.
Some of the vehicles may have manganese bronze spring clip plates used as a substitute for malleable iron. The substitute clips, which are used to attach the suspension spring to the rear axle, may crack allowing the assembly to loosen. This can cause rear...
The windshield wiper may over-travel its designed sweep angle during its initial stroke with the possibility of temporary wiper immobilization.
The involved vehicles fail to conform to federal motor vehicle safety standard no. 210, "Seat belt assembly anchorages", because the seat tether anchor belt was not relocated two inches rearward as was the driver"s seat.
Loss of lights and engine shutdown may occur as a result of electrical system failure due to improper circuit crimping and potential heater motor circuit overloading. Also, the fuel solenoid may be improperly fused and the headlight harness improperly routed.
The involved vehicles do not conform to federal motor vehicle safety standard no. 121, "Air brake systems", in that some dual compartment air reservoirs were installed without a drain valve in both compartments. The omission of the drain valve could cause: 1)...
The vinyl covered interior passenger assist/grab handle located on the right hand hinge pillar can wear and fail in service.
The involved vehicles may have been built with power unit anti-skid logic modules on tag axle installations instead of the correct trailer type modules. Since the tag axle sensor output is less than that of the power unit sensor, it requires the more...
Due to location of the back of the cab reflector being above the 60-inch maximum height, reflectors were to be installed on the rear frame crossmember. Some of these trucks were delivered without the frame mounted reflectors. As a result, these vehicles do...
The involved vehicles may be in non-compliance with federal motor vehicle safety standard no. 207, "Seating systems", due to omission of the driver"s seat under-cab supports. As a result, the driver"s seat may eventually come loose.
The involved vehicles may fail to comply with the requirements of federal motor vehicle safety standard no. 121, "Air brake systems". The brakes may fail to release within the time specified by the standard.
Questions about the White Truck RC2
Which White Truck RC2 years have the fewest complaints?
How many recalls does the White Truck RC2 have?
NHTSA lists 12 recalls across all White Truck RC2 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data