- The problem
- Winnebago is recalling certain model year 2009-2013 model Era motorhomes, 2010-2013 Via and Itasca Reyo motorhomes, and 2011-2013 View and Itasca Navion motorhomes; manufactured November 13, 2007, through August 20, 2012. The proper fuses were not installed for the refrigerator circuits.
- The risk
- Without the proper fuse, heat can build which could lead to a vehicle fire.
- The fix
- Winnebago will notify owners, and dealers will replace the fuses. The recall began on December 21, 2012. Consumers may contact Winnebago Industries owner relations at 1-641-585-6939.
Electrical system
2012 Winnebago Via Electrical problems
Owners have filed 1 complaint about the 2012 Winnebago Via's electrical system with NHTSA - 50% of all its complaints, most recently on September 6, 2011. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.
- Complaints
- 1
- Recalls
- 1
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Electrical recalls for the 2012 Winnebago Via
Electrical complaints
While driving on interstate 94 approximately 23 august 2011, and surrounded by semi truck traffic I experienced a rapid deceleration of my vehicle without any warning. In addition, the traffic was so tight, and due to the rapid deceleration rate, I barely escaped being hit from the rear by an approaching fully loaded 53 foot semi trailer. I found out later that the problem was caused by a defective egr valve that failed due to water intrusion. The engine manufacturer, mercedes benz, stated that the winnebago...
Read the full complaint
company using their sprinter chasis and engine are responsible for a design deficiency that allows water to enter under the hood and damage the egr valve in such a manner as to cause the rapid deceleration. *Tr
Winnebago Via electrical complaints by year
Via electrical problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data