Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

Yamaha FJR1300 Engine problems by year

24 complaints filed with NHTSA about the Yamaha FJR1300's engine & cooling. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Engine complaints by model year

YearEngine complaintsCrashesInjuriesRecalls
20210001
20200001
20190001
20182001
20170001
20161001
20093000
20081010
200710000
20052000
20042010
20033000

Engine recalls

Engine and engine cooling: software

21V8650002,462 vehicles affected

Do not drive

Yamaha Motor Corporation, USA (Yamaha) is recalling certain 2016-2021 FJR13 motorcycles. The Engine Control Unit (ECU) programming installed under Recall 20V-813 (990141), that was designed to prevent gear damage, may prevent the engine from accelerating as...

Latest FJR1300 engine complaints

2018 Yamaha FJR1300Engine & coolingTransmission & drivetrainLights

The contact owns a 2018 Yamaha FJR 1300. The contact received notifications of NHTSA Campaign Numbers: 20V814000 (Exterior Lighting), 20V813000 (Power Train), and 21V865000 (Engine and Engine Cooling). The vehicle was taken to the local dealer, but the vehicle was not repaired due to the parts being on back order. The manufacturer was contacted and confirmed that parts were on back order. The contact had not experienced failure.

Filed Incident Engine and engine cooling · Power train · Exterior lightingNHTSA 11751773
2018 Yamaha FJR1300Engine & coolingFuel system

The Yamaha FJR 1300 between 2016 and 2020 was subjected to a recall due possible to transmission. This was documented in the NHTSA as well as Yamaha - the recalls has been completed for many motorcycles including mine. Resolution - As part of that recall they replaced the transmission with a reinforced 2nd gear and main shaft (as we riders understand it), and they performed an ECU re-flash to prevent RPMs over 4k while in 1st, 2nd and 3rd with clutch open. Issue - The ECU - Rev limiting kicks in between 1 to 2nd...

Read the full complaint

and 2nd to 3rd at <35 mph with clutch open (pulled) - 4k RPM max. While these are not typical speeds for those gears - needing more power happens in cases of emergency maneuvering. If at any time you need a bit more power and you hit the throttle at that lower speed, you open clutch, hit the throttle and expect power. But no, you can't get above 4k rpm. Essentially leaving you in a potential perilous predicament. Now think about this RPM limiting is about emergency maneuvering. If one finds themselves having to move out of a dangerous situation (either stopped or moving slowly) where you need that 'bit more 'umph' to get going get going an out of the situation quickly, its not happening! And that is exactly how I found out about this. I needed to maneuver out of a dangerous (rear end) situation and hit the throttle only to find pout that it stopped at 4k RPMs. As any experienced rider can attest, when you need power to move into safety, you expect the motorcycle to respond. Yamaha has taken this ability away. This I find it to be a serious safety issue and Yamaha has placed many (~4k) riders in this predicament with this restriction. Interesting related fact - the exact FJR1300 2021 models with the same transmission as the one used in the recall for previous affected ones does not have that ECU restriction. I am asking the NHTSA to look into this potentially life threatening situation and request that Yamaha re-address this new problem.

Filed Incident Engine · Fuel / propulsion systemNHTSA 11426976
2016 Yamaha FJR1300BrakesEngine & cooling

Yamaha has issued 2 safety recalls for my motorcycle 1/21/2021. Vin [[redacted]]. It is a 2016 yamaha fjr 1300. One is for front brake switch may fail, the 2nd is for the transmission's second gear not being strong enough and the gear could break possibly causing the transmission, rear wheel to lock and not rotate. I made an appointment and dropped the bike at a dealer. It has been 50 days, and no progress has been made. Both dealer and yamaha motor corp say parts are not available. Yamaha stated yesterday...

Read the full complaint

that the needed parts are in japan. Parts are expected in june 16, 2021. Yamaha also stated they have already delayed parts by one month, and will most likely do it again, a little before the june 16, 2021 date. Help me. The recall states "you should not operate your affected motorcycle... Until the modifications are performed". So, I am stuck with no motorcycle, and there is no completion date for yamaha completing the required recall repairs. What is my compensation for lose of use of my motorcycle for 50 days ( and most likely up to 41 to 70 more days of waiting!)? Sincerely, [[redacted]] parts of this document have been redacted to protect personally identifiable information pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6).

Filed Incident Service brakes · EngineNHTSA 11415239
2005 Yamaha FJR1300Electrical systemEngine & coolingFuel system

Ignition switch is intermittent. Sometimes after turning switch to off position then back to the on position, motorcycle will not start and gage have no power. Sometime I may have to turn key on and off fifty or more times and sometimes that doesn't work. Motorcycle has less than 17,000 miles on it and has been garage kept. I've read many other owners having same the same problems.

Filed Incident Electrical system · Engine · Fuel / propulsion systemNHTSA 11208378
2009 Yamaha FJR1300Electrical systemEngine & cooling

I was riding at about 30mph on a highway and the engine suddenly died. I had to coast over to the shoulder to stop. The gauges stayed on, the kill switch was in the run position, but the engine would not start (starter would not engage) until I turned the ignition key off then back on. Then it started back up as usual, and I rode on to work. These are the same symptoms described in the recalls # 09v-002 and 11v-338 which were performed on my bike in 2011 (modification numbers from yamaha 990051 and 990061)...

Read the full complaint

but apparently the bike is not fixed and appears to be dangerous to ride since it lost engine power without warning at speed. Per the recall instructions, the wire sublead was replaced but the wire harness assembly was not replaced. Perhaps the main wire harness is defective and needs to be replaced?

Filed Incident Electrical system · EngineNHTSA 10853165
2007 Yamaha FJR1300Electrical systemLightsEngine & cooling

High beam indicator came on, turn signals failed to operate, bike would not restart after stopping. This was all caused by ground spider 6 burning and failing.

Filed Incident Electrical system · Exterior lighting · EngineNHTSA 10725381
2009 Yamaha FJR1300Engine & coolingAcceleration & cruise control

The problem I am about to describe has been occurring since the motorcycle was new. However, due to research, I am only now able to report the problem. On hot days, when the motorcycle is parked outside, after starting, it stumbles and cuts out during acceleration. The last incident (which I am now reporting on) almost caused me to get hit in a parking lot when the motorcycle died accelerating from a stop sign. A vehicle at the adjacent stop sign almost hit me when I stalled out. The research I've done points to...

Read the full complaint

the emission control charcoal canister as being the problem. Once it becomes saturated, it effects the intake, and then causes stumbling and cutting out. If the motorcycle can be ridden at highway speed, the canister clears and the motorcycle operates in a normal manner. However, a dangerous situation exists prior to its clearing. *Tr

Filed Incident Engine and engine cooling · Vehicle speed controlNHTSA 10629166
2009 Yamaha FJR1300Engine & coolingElectrical system

Engine intermittently cuts-out. Cut-out lasts for a second or less and may repeat itself several times before operating properly again. May cut-out several times in 10 mile daily commute. When engine is cutting-out, it is a complete loss of engine power. Very unsafe situation when traveling on freeway in traffic. Ignition switch and wiring harness recall work has been completed and problem has not been resolved. *Tr

Filed Incident Engine and engine cooling · Electrical systemNHTSA 10440925
2007 Yamaha FJR1300Engine & coolingFuel system

Engine surges above 3000 feet altitude causing uncontrolled lifting of front wheel in first and second gear. *Tr

Filed Incident Engine and engine cooling · Fuel system, gasolineNHTSA 10424672
2008 Yamaha FJR1300Engine & cooling1 injury

We purchased a new 2008 yamaha yzf-r6 and started riding it. We immediately noticed that there is a rather large amount of heat generated by the engine and the ducting from the radiator directs this superheated airflow right onto the lower legs of the rider. This is not much of an issue when the ambient temperatures are below 80 degrees f. Anything higher and it will cause burns with blisters even through blue jean pants. My wife has ridden this bike about 10 times and every time it has been hot enough to burn...

Read the full complaint

her causing discomfort and red welps, this indicates a first degree burn where the outer layer of skin is damaged but still able to function. 2 Of those times it caused actual blistering from the extreme heat directed onto the legs. This is indicative of second degrees burns where the outer layer of skin is damaged as well as the second layer( the dermis) this causes them to separate. The skin in this area can no longer function to protect the body or regulate temperature. This condition caused by the motorcycle results in a dangerous proposition for the rider as it causes bodily harm every time it is ridden in 80 degree temps or above. The burns can become infected and result in loss of limb or life if not taken care of properly. We have talked to the selling dealer and were informed that there was no revised parts or any thing we can do about the problem other than to trade it in on another model. This motorcycle should have the fairings redesigned to direct the airflow around the legs and away from any other body parts. The treatment we have received regarding this issue is also unacceptable. No remedy was ever offered to us other than trading the brand new motorcycle in on another model (and taking the loss from the trade in value). *Tr

Filed Incident Engine and engine coolingNHTSA 10261486
2007 Yamaha FJR1300Engine & cooling

Brand new 2008 yamaha fjr1300a. Engine frequently stalls upon application of throttle from a dead stop. Happens hot or cold. This is a very dangerous defect; if I were attempting to get out of the way of a car I'd be hit and injured. There is an open investigation that appears to be similar to what I'm experiencing: pe 08048. *Tr

Filed Incident Engine and engine coolingNHTSA 10240939
2007 Yamaha FJR1300Engine & cooling

I purchases a brand new 2007 yamaha fjr1300 from otd motorsports in marina del ray california. The motorcycle had 1 mile on the odometer. After riding the bike for a couple of weeks a bad engine surge began to appear. Not a normal slow methodical boost of energy but a sudden almost overwhelming boost of power. It would consistently happen during the transition between deceleration and acceleration. Several times while having a passenger on the back of the bike, she almost fell off due to this power surge. I took it...

Read the full complaint

to house of motorcycle in el cajon california to have them look at it. Several technicians took the bike for a ride and found the same dangerous issue. After talking with yamaha corporation in cypress california it was concluded that this was a "quirk" of this model and year of bike and there was nothing they could do. The fix was simple, I purchased a dynojet power commander and a g2 throttle tube. The surge is non existent with these two items together. If I bypass the power commander and use the stock ecu the surge is still very pronounced. Before I fixed the issue, on several occasions the surge, a almost threw my messenger from the bike and b almost put me into another lane while acceleration and turning through intersections. This is a very dangerous "quirk" and needs to be addressed with the yamaha corporation before someone gets seriously hurt. *Tr

Filed Incident Engine and engine coolingNHTSA 10238479
2004 Yamaha FJR1300Engine & cooling1 injury

Own a 2004 yamaha fjr1300 motorcycle. The engine generates a great deal of heat and the 2004 design did not account for the drivers safety in figuring how to direct the heat away from the driver. (I understand yamaha improved this problem starting in 2006). As a result I suffered burns on the inside of both legs and the bike is virtually unrideable in hot weather. The weather was about 90 degrees f and it only took about 45 minutes to receive these burns. It appears that the heat is building up on the underside of...

Read the full complaint

the gas tank and then is transferred to the drivers leg/groin area while riding. The internet is loaded with similar complaints from other riders but yamaha is ignoring them. They admit to a problem by the mere fact that they redesigned the problem area in 2006. I want yamaha to step up to the plate and fix the problem for owners of these motorcycles dated 2003-2005. *Tr

Filed Incident Engine and engine coolingNHTSA 10236901
2007 Yamaha FJR1300Engine & cooling

This is related to the new yamaha 2007 fjr1300a. The ecu doesn't appear to take realtime barometric readings. This is very apparent when you change altitude on mountain roads, which causes a very unsafe condition where the motorcycle hesitates when throttle input is applied. The hesitation gets longer the higher you go. It is a consistent, repeatable issue, and happens every time I ride in the mountains. I have reported it to yamaha, but they deny the issue exists. *Tr

Filed Incident Engine and engine coolingNHTSA 10203620
2007 Yamaha FJR1300Engine & cooling

2007 Yamaha fjr1300a. After traveling 25 miles aprox. And climbing ~1500 ft in altitude the engine malfunctions. Engine seems to lack fuel for a few seconds, then abruptly surges forward. Often this would oscillate between starving for fuel and surging forward. Road conditions were dry, if not there would be great danger of loss of control resulting in injury or death. Additional information on the problem was located on public internet forums (http://www.Fjrforum.Com/forum//index.Php?Showtopic=23179). Confirming that other owners of this motorcycle have experienced similar problems. *Tr

Filed Incident Engine and engine coolingNHTSA 10198785

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience