Charging socket lock errors out. Disables charging and inhibits the vehicle's electric drivability. The vehicle displays the following error: Could not execute action. Locking error in charging system.
Electrical system
Audi Q5 E Electrical problems by year
6 complaints filed with NHTSA about the Audi Q5 E's electrical system. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.
Electrical complaints by model year
| Year | Electrical complaints | Crashes | Injuries | Recalls |
|---|---|---|---|---|
| 2021 | 6 | 0 | 0 | 0 |
Latest Q5 E electrical complaints
The contact owns a 2021 Audi Q5 E. The contact stated that when she purchased the vehicle the MMI (Multimedia Interface) system failed to load correctly. The contact stated that the dealer informed her that the system would upload later as the system was not communicating with Audi corporate and she would be able to finish the programming later. The contact stated that the vehicle was taken back to the dealer as messages that the navigation system was not loaded, the driver assistance was inoperable, the fuel gauge...
Read the full complaint
display was incorrect, and the Lane Assist feature had failed. The contact stated that she had experienced the failure for the past year. The contact stated she received notification of NHTSA Campaign Number: 22V742000 (Back Over Prevention) several months ago and the dealer informed the state DMV that they were unable to repair the recall at the time. The contact stated that she had been communicating with the director at her state DMV as she was unable to have the dealer repair the vehicle. The contact stated that a case was not opened with her state DMV. The contact stated that the manufacturer and dealer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the issue. The approximate failure mileage was 10.
The contact owns a 2021 Audi Q5 E. The contact stated that while driving at 45 MPH, the vehicle came to a sudden halt as the malfunction indicator light illuminated the instrument panel. The contact was able to restart the vehicle after approximately 15 minutes and drove the vehicle to a dealer(Audi of Quad Cities-1777 E 53rd St, Davenport, IA 52807) where they discovered a defective switch on the vehicle's battery pack which was linked to TSB-9321462062953/1. The contact had the switch repaired by the dealer. The...
Read the full complaint
contact stated that the failure recently occurred again while driving at 30 MPH; however, the time, the vehicle failed to restart. The contact had the vehicle towed to a dealer where it remained in their possession and where it had yet to be diagnosed. The manufacturer had been notified of the failure and he was sent a form for a possible vehicle buyback. The vehicle had yet to be repaired or diagnosed. The failure mileage was approximately 2,000.
My vehicle was completely shut down. After towing to dealer and had the problem checked out, dealer service department had identify that the problem was the damage of the control module caused by possible liquid reaching to the gateway. This is what the recall is. However, dealer cannot do any repair but rather than forcing me to pay for replacing module part. Dealer claims that they are not aware of any such recall of (Manufacturer Recall Number90S9 NHTSA Recall Number21V947). Manufacturer should be responsible for correcting and paying for any the damage of the flaw in their vehicle design.
While driving in the far left of the 405N in Long Beach, the vehicle experienced some catastrophic failure. The accelerator stopped working, gear shifting was not possible, the interior lights turned on and flashed, there was some text instruction on the screen about the vehicle having lost power, and the emergency On-Star system was not available. There were no warnings, messages or other symptoms prior to the malfunction of the vehicle. We managed to coast across 4 lanes of traffic moving at a high freeway speed,...
Read the full complaint
with our hazard lights flashing and honking to get other drivers' attention, and made it to the right shoulder before using the brakes to stop the car. Upon stopping, all four windows automatically rolled down slightly. It was not possible to restart the vehicle, change the gear, put the car in neutral or operate any of the electrical systems in the car, including On-Star. We were fortunate, but still very much in danger, to have stopped at a small triangular shoulder between the 405 freeway and an adjacent on-ramp. Cars were passing us at full speed and in close proximity on both sides of the car. We called AAA as well as 911 to assist us in getting out of that harrowing situation safely. The vehicle was towed directly to the Audi Service Center in Santa Monica, where we left it with an after-hours note describing the issue we experienced. We called Audi the following morning and the service tech, Angel, said they would review the problem. Upon review, Angel confirmed that the issue was a failure in the gateway control module - a problem that Audi is aware of and has occurred in many of the same types of vehicles. We found through online searches of this issue that it is generally caused by water spilled in the backseat of the vehicle. Angel confirmed that no moisture was found inside the vehicle and he did not believe the failure was caused by spilled liquid. Audi is now insisting that we continue to drive the car, without the issue being fixed.
The incident occurred on a busy road during evening rush hour. I was in the middle lane of three lanes, and the lane to the right of me was closed due to construction. The phrase "electrical malfunction" flashed across my dashboard, there were beeping sounds, and about 5-10 later the steering froze up and the car would no longer accelerate. There were no other prior warning indications. I was unable to steer over on a side road or shoulder. I blocked traffic in the middle lane. My 1-and-a-half-year-old was in the...
Read the full complaint
back seat with me, and I was 35 weeks pregnant at the time. The temperature was 104 outside and my car wouldn't start despite several trouble shooting attempts to turn it back on. The car kept beeping and flashing malfunction signals on the dashboard indicating that all the different safety functions were not functioning. The windows were inoperable as well and would randomly go up and down. The vehicle was towed to the dealership, and they determined the J533 Gateway Module needed to be replaced. This module is located underneath the back row in a tub-like recess, which had collected water, and the module had malfunctioned. It is unknown if the module is available for inspection upon request.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data