Center High Mounted Stop Lamp, (CHMSL), lense breaks/detaches repeatedly.
Lights
BMW 128I/135I Lighting problems by year
30 complaints filed with NHTSA about the BMW 128I/135I's lights. Headlights, tail lights, brake lights, turn signals and interior lighting failures.
Lighting complaints by model year
Latest 128I/135I lighting complaints
The contact owns a 2010 BMW 128I. The contact stated while driving at undisclosed speeds, the headlights and taillights became inoperable. The engine warning light was illuminated. The contact stated that the failure was related to NHTSA Campaign Number: 19V579000 (Electrical System). The vehicle was taken to an independent mechanic who replaced the bulbs. The vehicle was taken to the local dealer, where it was diagnosed that the failure was electrical. The vehicle was not repaired. The vehicle was taken to an independent mechanic who was unable to assist. The manufacturer was not contacted. The failure mileage was approximately 125,000.
Left driver side rear taillights failed constantly I have no rear working lights . I brought in for repair and there is no fix for the lights ! I was rear ended
Tail lights burn out and require entire housing to be replaced instead of just bulbs. Led's burn out very quickly, contrary to typical led's and are costly to replace
First we had the adaptive headlight error code, we also had frequent blown bulbs. After pulling the complete unit out from the car noticed that all the wiring insulation is crumbling and falling off the wiring loom. Multiple wire were bonded together causing heat and short circuits.
Daytime running light kept burning out. So I decided to investigate further. On closer inspection, the insulation for the wires inside of the headlight had completely deteriorated in some areas leaving the bare metal wires exposed. In other areas the insulation was cracking or falling off. How is that possible in a sealed environment such as the headlight housing? This could easily cause the headlights to cease functioning leading to a crash, or a short which would cause a fire.
The wiring of my 2009 bmw headlights, both sides, has its insulation disintegrate, exposing bare copper wire (as it is made of biodegradable material) to the point where my daytime running lights have shorted out and the adaptive headlight control on the passenger headlight is stuck at an angle that is too high. As these are adaptive headlights, a short here can render the car's headlight in a blinding state. Local shops want to charge $900+ per light housing to completely replace the light assembly.
TAIL LIGHTS DOESN'T WORK
The plastic insulation on the headlight wiring has flaked off leaving the wires completely bare in some places. This has resulted in the loss of a drl, headlight ballast, and adaptive headlight motor. This is a well documented issue online, from bmw owners of multiple years/series. In fact, there is already an nhtsa complaint on the exact same year and model as I have. This issue is dangerous in multiple ways. The loss of lighting at night could result in an accident, harming both the occupants and people...
Read the full complaint
nearby. The highly charged bare wiring could short, spark, and cause a fire. The continued destruction of headlight bulbs, motors, etc is harmful to the consumers and economy as those parts can be very expensive.
Wiring inside headlight assembly has insufficiently insulated wiring. The wire insulation is flaking off due to heat exposure from normal operating conditions. This is a safety problem. Fire potential. Lights could stop working while driving at night.
Driver side led tail lights have gone out. The runing lights have three bars that have gone out and have got no help from local dealership in fixing them. There are news areticles of the recall affecting all model year but none show up for my car even though it's the exact same problem.
"3Rd brakelight" lens continues to break. I purchased the car in july of 2008 and will soon be on its 3rd lens. This is a bmw defect and is a very expensive part. I'm concerned about re-replacing this defective part over and over again and if I choose not to, others being able to see me when I apply the brakes! This has happened to numerous owners who I'm sure like me, have had no fault(like an accident) in the breakage. No specific date on when it breaks as it is probably cause by normal road vibrations. Light has broken due to normal driving a few occasions already.
Third brake light lens cracks and allows rain water into unit. After having the dealer replace the lens twice I decided to do it myself. The supplier "ecs tuning" features the lens assembly with the words -- "replace your cracked lens." This made me think the problem is more than a couple of assemblies. *Tr
Right rear roadside parking and tail lamp led failed. These lamps should not fail within this time frame. I was not aware of this issue until I was waming up car and cleaning off snow when I saw the difference.
I have a 2009 528i . While going down the road my headlights when on lowbeams go out . The brights work but not the lowbeams the car control says lowbeam malfunction . First it was the left light and then the rightfront. I have not had this car long and its a wonderful car. But this is not safe and need to know if there has been any recalls for this or what can be done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data